查询词典 curves

Firstly, we normalized the basic voxel by constructing its minimum oriented bounding box. Secondly, we constructed its D2 shape distribution curve, and computed the values of EMD(earth mover's distance) compared with the corresponding curves of the normal cone and cylinder respectively, and the corresponding top diameters. Finally, we compared the top diameters and obtained the parameters by the bounding box.

首先建立基本体素的MOBB，对体素进行标准化；然后生成其D2形状分布曲线，计算此曲线分别与标准圆锥体形状分布曲线、标准圆柱体形状分布曲线的EMD(earth mover's distance)值以及相应的上底直径；最后通过比较两个上底直径的大小来判断此体素是否为圆台体，并由包围盒的边长给出圆台体的参数。

The curves of abnormal dispersion in the absorption range and normal dispersion in the gain range are acquired.

二、采用激光经典理论中吸收系数与折射率的关系，结合钛宝石晶体光谱资料，研究了钛宝石的色散特性，获得了吸收区反常色散与增益区正常色散的色散曲线。

The rise stress-strain curves of recycled aggregate concrete are similar to those of the normal concrete, cubic polynomial are proposed for the rise stress-strain curve of concrete, and the peak strain are higher than normal concrete.

应力应变曲线的上升段与普通混凝土相似，都是用3次多项式拟合，其峰值应变比普通混凝土高。

They are presented in need of special curves and surfaces in engineering applications. In order to prove that the uniform C-B-spline basis is normalized totally positive, we compute the matrix which transforms the C-Bézier basis into the uniform C-B-spline and decompose this matrix into a product of. bidiagonal and stochastic factors.

本文用递推的方法，计算出代数三角空间中的n次C-Bézier基与n次均匀C-B-spline基之间的转换矩阵，并把该矩阵分解为一系列二对角阵的乘积，从而证明出n次均匀C-B-spline基是一个标准全正基，进一步用插入节点的方法，把它扩充为一组标准B基，从而我们可以利用B基的很多优良性质，在工程应用中对这两组基进行开发利用。

They are presented in need of special curves and surfaces in engineering applications. In order to prove that the uniform C-B-spline basis is normalized totally positive, we compute the matrix which transforms the C-Bézier basis into the uniform C-B-spline and decompose this matrix into a product of. bidiagonal and stochastic factors. Furthermore, we give a normalized B-basis by inserting knots.

本文用递推的方法，计算出代数三角空间中的n次C-Bézier基与n次均匀C-B-spline基之间的转换矩阵，并把该矩阵分解为一系列二对角阵的乘积，从而证明出n次均匀C-B-spline基是一个标准全正基，进一步用插入节点的方法，把它扩充为一组标准B基，从而我们可以利用B基的很多优良性质，在工程应用中对这两组基进行开发利用。

Numerical examples are given for fitting the numerically obtained stress-strain curves to a set of experimental results.

给出的数值计算例子计算了单轴压缩试验结果的参数辨识问题。

More than 1300 growth curves were recorded in the presence of various nutrient concentrations.

在不同的营养物的浓度下我们设计绘制了1300多条生长曲线。

OCCAM algorithm has been successfully used to invert transient Rayleigh wave dispersion curves for lower velocity layers.

OCCAM算法在大地电磁测深资料反演中已获得了成功应用。

1 Oven order 5.1.1 first hearth cloth Wind board laying 200mm thickness of the bed material; About Revert cloth laying Wind board thickness 200mm bed material, to prevent Ogive burn plug secondary air pipe; 5.1.2 prior to Add a small amount of flammable wood furnace and left and right back Feeder, ignition Wind Road in oven two days before ignition; 5.1.3 ignition started Ovens need to use a small amount of diesel added to the accumulation of wood, wood ignition when combustible, wood drying to around 200 ° C, according to adjust primer wind baffle and then curves of thermal insulation and heating.

5.1烘炉顺序 5.1.1先将炉床布风板上铺设厚度为200mm的床料；左右返料器布风板上铺设厚度200mm床料，防止把风帽烧坏，堵塞二次风管； 5.1.2事先将少量易燃木柴放入炉膛和左、右返料器，点火风道应在烘炉前2天进行点火； 5.1.3开始烘炉点火时需要用少量的柴油加在堆积的木柴上，点火时木柴易燃烧，木柴烘至200℃左右后，根据情况调节引风挡板，再按升温曲线保温、升温。

In the actual oil-field production, it is generally to choose the homologous plates and formula to correct the well-logging curves.

在油田的实际生产中，一般根据所用仪器的类型及具体条件来选择相应的解释图版及校正公式对测井曲线进行校正。

Finally it offers the analysis of the fault-tolerance system as well as its test verification.

这样，运行于空间环境中的系统的设计目标就是在保证系统实时性

However, it is still difficult to find out the real reason of the increase of the keratinized gingiva during the orthodontic extrusion whether it is due to the proliferation of the gingival tissue or to its elastic nature, that is because the proliferation of the fibroblasts as well as the connective tissue changes in volume and the intra-fibers spaces were all immeasurable in most of the studies.

然而，仍然难以找到真正的原因增加的角化牙龈在正畸挤压它是否是由于扩散的牙龈组织或其弹性性质，这是因为增殖的成纤维细胞以及作为结缔组织的变化量和内部纤维空格都是不可估量的，大多数的研究。