查询词典 curves

In order to make available for alternative Aiming bidding curves,improve the speed,precision and convergence, an effective method for generation scheduling is proposed based on an improved dynamic programming- local redefined dynamic programming .

为有效解决各种类型报价曲线的负荷经济分配，并考虑到计算速度、精度及收敛性等问题，采用了一种改进的动态规划法——局部加密动态规划法，并采取了限制机组组合状态的措施。

Point C on a minimum speed at the pump performance curves efficient area of extreme left point.

C点就成为最小转速时水泵性能曲线高效区的左端点。

The method of eigenfunction expansion was used to calculate the disperse curves of guid.

利用特征函数展开法计算出周向导波的频散曲线及0。

The current-voltage curves at different pressure are calculated using the elastic scattering Green function theory.

利用弹性散射格林函数方法计算了不同压力下分子结的伏安曲线。

Although from characteristic curves of the EDI it was indicated that the process condition is similar to that of the traditional electrodialysis,the separation efficiency of the process is greatly enhanced.

EDI水软化过程的特征曲线表明，该过程工况与传统电渗析过程相似，但分离效率显著提高。

By using calculated activation energy of the V colorcenter and measured current-time curves, mechanism explanation of the colorcenter formation for the electrolytically colored crystals is presented.

借助算得的V色心激活能和测得的电流~时间关系图，对经此种电注入着色晶体中色心形成提出机理解释。

On the basis of the circuit theory,electromechanics and practical state of the electrified railways,we have made up equivalent circuit of threephase traction substations and traction power supply systems and have got external performance curves.

根据电路原理和电机学的基本理论，结合电气化铁路的实际状态，构成三相牵引变电所和牵引供电系统的等值电路，得出外特性曲线。

The stress-strain curves of the alloy deformed in circulatory stress have been plotted by means of electrometry.

结果表明：无论在Af以上或Af以下，一定温度和一定应变下的应力循环次数的增加。

Commercial metals were used for preparing Cu-Zn-Al shape memoryalloys in this experiment. Stress-strain curves of the alloy at differenttemperatures were plotted with the aid of the electrometry.

本实验采用工业纯金属制备Cu—Zn—Al 记忆合金，用电测法测绘了该合金在马氏体相变点上下某些特性温度区间的σ—ε曲线，所得主要结果是：1。

The stress-strain curves of Cu-Zn-Al alloys at different temperatures have been plotted on the tensile machine with the aid of electrometry. The main results were as follows: 1. When specimens were deformed within the range of M_s and M_d, the critical stress for inducing martensitic transformation increased with the temperature, and there existed a linear relationship between them. 2. When specimens were deformed above Af, complete pseudoelasticity might be obtained theoretically, which might be damaged, h...

在拉力试验机上用电测法测绘了Cu-Zn-Al合金在马氏体相变点上下各温度的σ-ε曲线，所得主要结果如下：(1)试样在M_s与M_d之间加载，随着温度升高，诱发马氏体相变所需临界应力增大，且加载温度与临界应力之间存在着线性关系；(2)在A_f点以上加载，理论上可获得完全的伪弹性，但加载温度过高或应变量过大，均会损害伪弹性；(3)试样在M_s点上下温度区域变形，得到的伪弹性回复和形状记忆回复之和在80%以上，但在M_s点附近总回复量出现一极小值，且伪弹性回复在M_f点以下又有所回升。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。