查询词典 curves

The problem of scalar multiplication on the Jacobians of hyperelliptic curves is studied. A fast algorithm for scalar multiplication on the Jacobians of a kind of hyperelliptic curves based subfield is proposed with its computational cost analyzed.

讨论了超椭圆曲线密码体制的标量乘问题，对基于子域的一类超椭圆曲线Jacobian的标量乘提出了一个快速算法，并分析了算法的计算量。

The DH protocol, ElGamal encryption and ElGamal signature scheme, DSA are extended to Hypereliptic curves, and a new message recovery signature scheme based on Hyperelliptic curves is presented. And it is proved that this new message recovery signature scheme is not strong equivalent to HC-ElGamal signature scheme.

将DH协议、ElGamal加密体制、ElGamal签名和DSA推广到了HC上，提出了一个基于超椭圆曲线的消息恢复签名方案，并证明了这个消息恢复签名方案与HC-ElGamal签名方案不是强等价的。

The problem of scalar multiplication on the Jacobians of hyperelliptic curves isstudied. A fast algorithm for scalar multiplication on the Jacobians of a kind ofhyperelliptic curves based subfield is proposed with its computational costanalyzed.

讨论了超椭圆曲线密码体制的标量乘问题，对基于子域的一类超椭圆曲线Jacobian的标量乘提出了一个快速算法，并分析了算法的计算量。

The concentration-response curves for ATP with and without preapplication of hypotonicity showed that preapplication of hypotonicity shifted the curve downward; maximal amplitude of IATP with hypotonicity decreased by 25.26±2.41%, while the threshold value remained unchanged; the EC50 value of the two curves were very close(1.19×10-4M vs 1.33×10-4M).

3在低渗透压(260mOsm)环境下，ATP-激活电流的浓度反应曲线明显下移；阈值和最大反应浓度不变，EC50为1.19×10-4M，与单独加ATP时的1.33×10-4M基本一致；而最大反应浓度时的ATP电流幅值减小了25.26±2.41%(n=6)。

Then through dynamical analysis, every instantaneous acceleration distributing of slope under dynamical earthquake can be got too. According to this result, adding earthquake force to structure by way of inertial force, this paper analyses the slope stabilization by using FEM strength reduction method and gains every instantaneous safety factor and its corresponding slide. Curves of safety factors versus duration can be made by curvefitting. By safety factors versus duration curves and slides, we can value structure's quakeproof stabilization and point its slide out. By these principles, programs of FEM stabilization analysis for each moment are organized.

首先通过三维非线性有限元静力分析得到动力分析的初始应力，再进行动力分析得出边坡在动力作用下每一瞬时的加速度分布，根据每一瞬时的加速度分布的结果，将地震作用力作为惯性力加在结构上，用有限元强度折减法进行边坡稳定分析，得出在地震动力作用下每一瞬时的安全系数及对应滑裂面，拟合可得到一条安全系数随时间变化的曲线，根据这条安全系数时程曲线及滑裂面，综合得出结构的抗震稳定安全系数及对应的滑裂面。

Pump operating point from the actual pump curves and pump device characteristic curves to determine the point of intersection.

泵的实际工作点由泵的曲线与泵的装置特性曲线的交点来确定。

The initial adsorption pH was determined to be 5.0 by investigating breakthrough curves and adsorption isotherm curves.

通过分析ALA在001×7上的穿透曲线和吸附等温线，确定发酵液的吸附pH为5.0。

The purpose of this dissertation is to develop a general nonisothermal viscoelastic stress constitutive theory based on the experimental curves of materials, and to present the finite element method formulation and the method of obtaining the nonisothermal relaxation curves from the isothermal relaxation surface.

本文的目的则是基于材料的实验曲线，建立一个一般的变温粘弹性应力本构方程，并给出相应的有限元计算公式及如何由等温松弛曲面确定变温松弛曲线的方法。

The results indicate that lgG'-,lgG-lgw relation-ship curves look as straight lines on the double logarithmic scale at lower mas fraction of fumed silica.In the higher angular frequency region,therer is a slight downward discrepancy for the curves from the straight line.With the increase of the fumed silica mass fraction the lines are upward translation,but the slopes decrease.

发现当气相二氧化硅质量分数最小时， lgG'-lgG"-lgw 相互关系基本上呈直线，在高频部位 lgG'， lgG"开始微微向下偏离直线形态；随着气相二氧化硅质量分数的增加，直线整体向上平移的同时谢率降低。

But in order to draw the curves on the surface you need to make it "live" to be able to magnetize your curves.

但是为了画曲线表面上你需要让它"活"能够吸引你的曲线。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐