查询词典 current-account holder

Trans-Blot Cells and Systems 170-3825 Trans-Blot Cell With Wire Electrodes and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3850 Trans-Blot System With Plate Electrodes and PowerPac HC Power Supply, 100120/220240 V 170-3853 Trans-Blot System With Plate Electrodes, Super Cooling Coil, and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3910 Trans-Blot Cell With Wire Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3939 Trans-Blot Cell With Plate Electrodes and Super Cooling Coil, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3946 Trans-Blot Cell With Plate Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) Trans-Blot Cell Accessories 170-3912 Super Cooling Coil, required for all high-intensity transfers 170-3913 Gel Holder Cassette, includes 2 fiber pads 170-3914 Fiber Pads, 15.5 x 20.5 cm, 6 170-3920 Trans-Blot Standard Wire Electrode Card, cathode 170-3921 Trans-Blot Standard Wire Electrode Card, anode 170-3922 Trans-Blot Cell Buffer Tank 170-3923 Trans-Blot Cell Lid With Power Cables 170-3943 Trans-Blot Platinum Anode Plate Electrode 170-3944 Trans-Blot Stainless-Steel Cathode Plate Electrode 170-3945 Trans-Blot Plate Electrode Pair, platinum anode and stainless-steel cathode 16 规格:说明: Trans-Blot Plus

电泳转印槽组件 1。缓冲液槽及带有电缆的盖 2。凝胶支架转印夹 3。纤维衬垫 4。电极丝 5。电极板 6。特级冷却芯 Trans-Blot 转印槽是功能灵活的转印设备，可理想地用于多种转印应用。Trans-Blot 转印槽特点包括：*能进行多胶转印，可容纳3 块PROTEAN I xi 凝胶、6块Criterion 凝胶、12块Mini-PROTEAN 3 或Ready Gel 预制胶*多组参数灵活可设，可调节的电压设置（从30 V 的过夜转印到200 V 的1 小时快速实验）*电极间距设置为8 cm 用于标准印迹杂交，或设置为4cm 用于高强度印迹杂交*可选择板式电极：涂有铂金的钛作为正极，不锈钢为负极，能提供高强度电场和比其它电极更高的电流密度。或选择较经济的铂金电极丝*通过特级冷却芯和水循环仪来调节温度―是天然酶（4°C）或高强度转印的理想选择，随着转印时间增加（多达24 小时），不会引起缓冲液耗竭（在高强度转印中必须使用冷却芯，也推荐用于所有板式电极的应用）*带铰链的凝胶支架转印夹能避免滑动，确保凝胶与印迹膜间的紧密接触；每个转印夹都有颜色标记以保证在转印槽中的正确定位 Trans-Blot 转印槽的锁闭凝胶支架转印夹系统。转印夹（1）支撑凝胶（2）印迹膜（3）两侧有纤维衬垫和滤纸（4）确保凝胶三明治内的完全接触。凝胶夹垂直插入缓冲液槽中（5）。

In this thesis the process of constructing the non-perturbative Hamiltonian theory is de-scribed and is applied to estimate the vacuum condensate. It contains the following contents:At the very beginning, by using the path integral method and eliminating the gluon freedom, aGCM action 〓 of current quarks including lower order current-current coupling was derivedfrom the QCD Lagrangian and the effective Hamiltonian operator that could hardly be doneby the normal methods was derived. After doing this, the broken vacuum is introduced whichincludes quark-antiquark condensate through the generalized Bogoliubov-Valatin transformation,the effective Hamiltonian of constituent quark was derived. The detailed formulas containingthe spatial current-current coupling term for the effective Hamiltonian and gap equations wasworked out by parameterizing the correlation kernel as a quadratic potential. And then, the gapequation was solved and the quark-antiquark condensate of vacuum was studied both in the casesof instantaneous interaction and retarded interaction. In the end, the effective Hamiltionian withtwo-body quark-quark interaction was derived with one-body approximation, and with the helpof the functional integral method the coupling non-linear dynamic equations for systems withnuclear matter was derived. Finally, these equations were solved by selfconsistent method andthe effect of nuclear matter on vacuum condensate was studied. The spatial current-current coupling term is too difficult to handle, hence the correlationkernel is assumed to be not important and usually omitted in the pure vacuum condensate, andthe instantaneous interaction generally is adopted. Retaining the spatial current-current termand partial retardation effect, the quark pairs condensate in pure vacuum was studied, and theeffect of quark mass was also studied. At present, little study is focused in the case with nuclearmatter and spatial current-current term also omitted. Under the approximation with partialspatial current-current term, the effect of nuclear matter on vacuum condensate was studied.

本论文描述了量子色动力学整体色对称模型哈密顿量方法的构建过程，得到了反映正反夸克对凝聚真空结构的关于组分夸克的有效哈密顿量算符，它隐含了胶子作用，并且准确至流-流耦合项；接着，通过参数化哈密顿量中的夸克作用关联核，导出平方禁闭势参数化选择的哈密顿量的具体公式和能隙方程；随后，应用公式，编程求解，考察了瞬时作用下和部分延迟作用下真空的正反夸克对凝聚，在计算中保留了空间流-流耦合作用；之后，导出瞬时势和延迟势下包含二体作用项的哈密顿量公式，并采用单体化近似，通过泛函变分方法得到核物质存在时耦合的非线性动力学方程；在保留部分空间双流耦合作用的近似下，求解核物质的动力学方程，考察核物质密度对真空凝聚的影响，以往考察真空凝聚，对关联核的选用，由于空间流-流耦合项不易处理，也认为作用不大，常忽略该项，并且常采用瞬时作用；本文保留空间双流项和部分延迟作用，考察了真空情形的夸克对凝聚，还考察了夸克质量对纯真空凝聚的影响，以往对核物质存在情形的真空凝聚考察很少，也都忽略空间流-流项，本文在考虑部分空间流-流项近似下，考察了核物质存在对真空凝聚的影响。

If the blank is wrinkling on the blank holder surface, the cause is most likely one of four factors: insufficient blank holder force; a poor fit between the die face and blank holder surface; an equalizer block that is holding the die face apart from the blank holder surface; or severe blank holder deflection.

如果板料在压边面上起皱，绝大多数起因是后面四个因素之一：不充分的压边力；凹模和压边圈表面不良的匹配；凹模和压边圈间的平衡块；或者是压边圈的严重变形。

If the blank is wrinkling on the blank holder surface, the cause is most likely one of four factors: insufficient blank holder force; a poor fit between the die face and blank holder surface; an equalizer block that is holding the die face apart from the blank holder surface; or severe blank holder deflection.

如果展开平板在压边圈面上起皱，绝大多数起因是后面四个因素之一：不充分的压边力；凹模和压边圈表面不良的匹配；凹模和压边圈表面间的平衡块；压边圈的变形。

If the blank is wrinkling on the blank holder surface, the cause is most likely one of four factors: insufficient blank holder force; a poor fit between the die face and blank holder surface; an equalizer block that is holding the die face apart from the blank holder surface; or severe blank holder deflection.

褶皱起因于不充分的拉伸或失去控制的压缩变形。如果板料在压边面上起皱，绝大多数起因是后面四个因素之一：不充分的压边力；凹模和压边圈表面不良的匹配；凹模和压边圈间的平衡块；或者是压边圈的严重变形。

Discretionary Account is an arrangement by which the holder of an account gives written power of attorney to someone else,often a broker,to buy and sell without prior approval of the holder;often referred to as a "managed account"or"controlled account".

全权委托一种委托形式，账户的所有人将交易权委托给其他人，受托人在交易时不需要事先征得账户所有人的同意。

Our factory main products are: plastic lamp holder E14, E27 Series, ceramic lamp holder series (such as lawn lamp holder, quartz lamp holder, halogen, Block, etc.), bakelite lampholder E12, E14, E17 series, energy-saving lamp lampholders Series , all kinds of accessories switch, line caps, line clasp, clamp and other products.

我厂的主要产品有：塑胶灯头E14、E27 系列、陶瓷灯座系列（如草地灯座、石英灯座、金卤灯座等）、胶木灯座E12、E14、E17系列、节能灯灯座系列，各种配件开关，线帽，线扣，线夹等产品。

The bread maker also includes tray holder members to be combined with opposite ends of a pair of tray members; a pair of guides mounted on inner sidewalls of the oven compartment facing each other to slidably guide the tray holder members by being slidingly combined with the tray holder members; and a shock absorber between the tray holder member and the guide.

面包机还包括与一对盘件的相对端部结合的盘保持件；安装在烤箱室内侧壁上的一对引导件，所述引导件彼此面对以通过与盘保持件的滑动结合而可滑动地引导盘保持件；以及介于盘保持件与引导件之间的震动吸收器。

The present invention relates to a holder for a roll of unwindable material, in particular a holder for paper rolls, preferably for standing a paper roll vertically on a horizontal surface, with a cylindrical holding rod(1), a base(5)and an essentially known pivotal retaining arrangement for the free end of the paper roll, the object is to provide a holder in which the roll is retained on the holder in a stable manner also when different widths of paper are used, and where the cost of manufacture can be reduced through a simple embodiment and few components.

一用于可展开的材料的卷装的支架，特别是纸卷的支架，优选是使纸卷垂直立在水平表面上，其带有圆柱形支承杆(1)、底座(5)和一已知的用于纸卷的自由端的固定装置，利用这种支架，当使用不同宽度的纸卷时，纸卷能以稳定的方式被保持在支架上，通过简单的实施方式和很少的部件，制造成本能减少。

Ost of the brush holder is brushes vertical grip, but also oblique brush holder, which is based on working conditions and formulated in the existing technology used in the brush holder many early introduction of steel wire spring brush holder.

大多数的刷握是直向刷握，也有斜形刷握，它们是根据工况而配制的，在现有技术中使用的刷握还有很多早期引进的钢丝弹簧刷握。

Although translator has turned from being a crystal ball by which the original culture can unrestrainedly penetrate to another crystal ball by which the target culture can freely traverse, the translator's personal embodiment, in the process of cognitive act, are still absent in translation studies. Translators are still subjects without body or simply disembodied subjects.

译者虽然由原语文化可以自由穿透的玻璃球变成了译语文化可以自由穿越的玻璃球，但译者认知过程中的个体体验在翻译研究中依然缺席，译者依然仅仅是一个没有躯体体验的主体。

Chillingly, he claimed our technology is 'not nearly as sophisticated' as theirs and "had they been hostile", he warned 'we would be been gone by now'.

令人毛骨悚然的，他声称我们的技术是'并不那么复杂，像他们一样，和"如果他们敌意"，他警告说，'我们将现在已经过去了。