查询词典 current pulse

In order to drive a high impedance load such as HPM sources, it is necessary to commutate FCG's long pulse width, high-current and low voltage pulse to a short pulse with high voltage.

为用FCG驱动象HPM源这样较高阻抗的负载，必须使用脉冲功率调制电路把FCG产生的低电压、大电流、上升时间长的电压脉冲转化为高电压、上升时间短的脉冲。

The four conditions are as follows: the molten alloy only with the addition of deoxidant during melting; only applying high-density pulse electric current on castings during solidification; compound addition of grain refiner and sodium modifier, and addition of borax r modifier liquid along with applying pulse electric current during melting.

这4种工艺条件分别为：在合金液熔炼过程中，除了加脱氧剂外不做任何处理；凝固过程中单独施加高密度电脉冲；添加晶粒细化剂和钠盐变质剂混合剂，或者添加硼砂变质细化剂，并施加高密度电脉冲。

The single a machine that should design to adopt serieses MCS-51s primarily conduct and actions main a measurement for, passing spreading feeling machine to the current of air measuring, its change is homologous pulse signal, this pulse signal through A/ D conversion with D/ A conversion after produce the certain electric voltage signal, will show the inceptive pulse signal a discharge for representing to come out at the same time.

该设计主要采用了MCS-51系列的单片机作为主要的芯片，通过传感器对燃气流量的测定，将其转变为相应的脉冲信号，这个脉冲信号经过A/D转换和D/A转化之后产生一定的电压信号，同时会将起初的脉冲信号所代表的流量显示出来。

A series of researches have been developed on cathode design, process control and machining gap control etc. Several results that are valuable to applications and instructively significant have been gained.PECM is a new technology that the pulse power, especially the high frequency and short pulse current power, is applied and the traditional direct current power is replaced instead.

脉冲电化学加工是用脉冲电源代替传统的直流电源，尤其是高频、窄脉冲电流的引入，使脉冲电化学加工中间隙过程的电化学特性、流场特性和阳极溶解特性等都得到了很大的改善，其加工精度、表面质量和加工效率都有了很大的提高。

In this paper the pulse measurement used to measure the pulse ionization electron current for electron impact ion source of time of flight mass spectrometer was discussed, the shortcoming of average current measurement was analyzed, and the practical measuring circuit of the pulse was given.

本文讨论了脉冲测量技术在飞行时间质谱计电子轰击离子源中测量脉冲离化电子流的应用，分析了平均电流测量方法测量脉冲离化电子流的局限性，给出了实际的脉冲测量电

In this dissertation, some research on the contact reliability of relay has been made on the basis of a new measuring method for contact resistance that is the pulse current method. The thermal propagation has been analyzed so as to analyze the thermal effect of pulse current flowing over contact.

本文在提出一种新的测量接触电阻方法——脉冲电流法（脉冲宽度为300μS）的基础上，针对继电器接触可靠性进行了研究，并对触点热过程进行了分析，以便分析脉冲电流对触点产生的热效应。

The effects of pulse parameters such as pulse width Ton, pulse interval Toff, pulse frequency f, pulse current density J on the morphology ,grain size , hardness, internal stress and orientation of coating , and coherence of coating to sucbstrate have been examined .

研究了脉冲电镀参数：脉冲宽度Ton ，脉冲间隔Toff，脉冲频率f，脉冲电流密度 J对镀层微观形貌、颗粒大小、硬度、与基体结合力的影响，分析了镀层内应力、择优取向与脉冲参数的关系。

The influences of plating process parameters, such as sulphamate concentration, electrolyte pH value and temperature, and pulse parameters, such as cathodal current density, pulse current frequency and duty cycle, on the micro-hardness of the nickel deposit has been studied by orthogonal experiments.

利用正交试验法分析研究了主盐氨基磺酸镍浓度、电镀过程工艺参数及脉冲参数（阴极电流密度、脉冲频率和占空比）对镀层显微硬度的影响；并对相关参数进行了优化。

It is concluded that the main influence factors on the micro-hardness of the nickel deposit are sulphamate concentration and electrolyte temperature. The most hard nickel deposit layer was obtained with sulphamate concentration 700g/L, cathodal current density 5A/dm2, pulse current frequency 800Hz, pulse current duty cycle 0.6, electrolyte pH value 4.0, electrolyte temperature 70℃.

试验结果表明：主盐浓度和镀液温度是影响镀层硬度的显著因素；当主盐氨基磺酸镍的浓度为700g/L，阴极电流密度为5A/dm2，脉冲频率为800Hz，占空比为0.6，镀液pH值取4.0，镀液温度为70℃时，可以制得显微硬度最高的镍镀层。

Of electric current, voltage and resistor what can make up programmed control to make electric current, voltage and power is accurate read time use within transient state simulative generator of buy pulse form is successive as laden as pulse job has the synchronism outside complete protective function to spark input higher power can shunt-wound job can make, electronic load is all Agilent Dc that the solution of stand-alone of ideal equipment Agilent of power cell and batteries capacity test offers your place to need all sorts of dynamic and laden application undertook optimizing.

电流、电压及电阻的可编程节制电流、电压及功率的切确读回用于瞬态模拟的内置脉冲形发生器陆续与脉冲负载工作存在完整的保护性能外同步触发输入较高功率可并联工作可使到高达240V的负载可利用单输入或多输入主机箱 3年保修期 Agilent直流电子负载是测试与评估直流电源，功率元件和电池容量测试的理想行动措施 Agilent单机解决方案供给您所需的一切 Agilent dc电子负载为各类动静负载应用进行了优化。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。