查询词典 current drive

The principle of constant power drive is: PD converts the change of output light power of laser diode into the change of diode current, and the change of current is feed back to voltage-current converser which adjusts output current of driver to compensate the laser diode.

这样，当激光器的输出光功率衰减时，驱动器相应的增大输出电流；当激光器的输出光功率增强时，驱动器就相应减小输出电流。对许多激光器应用来说，最希望脉冲输出，因为脉冲输出只有极小的结发热。

ABSTRACT: A Rockwell PowerFlex7000 Variable Frequency Drive is used in JiuZHou Electric medium voltage drive test bay as the converter. Because of it belong to the current source drive, it has the function of the four quadrant, it can achieve the energy feedbackmake the motor brake,also has the advanced vector control technology, so it can achieve all kinds of load test, there are no other drives can replace it in simulate motor load. PowerFlex7000 drive has ability to achieve the full load test before the drive leave factory.

摘 要：罗克韦尔PowerFlex7000变频器在九洲中压变频实验站测试系统中作为变流逆变器使用，由于本身属于电流源型变频器，具有四象限运行功能，能够实现能量的回馈和对电机的制动，先进的矢量控制技术，可以实现各种复杂多变的负载特性，在模拟电机负载方面起到了其他变频器无可替代的作用，实现了变频器出厂之前的满负荷测试。

ABSTRACT The researches of this thesis are carried out around the development of high performance machine tool spindle permanent magnet synchronous motor and its drive system. Five parts are included: First of all, concerning the operating characteristics of the machine tool spindle drive system, the optimum current control strategies of spindle PMSM are determined; The design rules of spindle PMSM's key parameters are summarized, based on the study on the influences of the design parameters on the performances of the PMSM operating at different current control strategies; The practical methods to improve the flux-weakening ability of the PMSM are presented; Based on the analysis and comparison of the operating performances of PMSM with different rotor structures, a novel PMSM rotor structure, which is of excellent mechanical performance, suitable for fluxweakening operation and can improve the torque output capacity in the same time, is presented.

本文围绕高性能机床主轴永磁同步电动机及其传动系统的设计研究展开，所做工作主要包括五部分：首先，确定了主轴永磁同步电动机定子电流的最优控制策略；通过对不同控制策略下主要设计参数对主轴永磁同步电动机性能影响的计算研究，总结了参数设计规律；提出了永磁同步电动机弱磁扩速的实用措施；在分析比较不同转子磁路结构电机的性能，尤其是弱磁扩速能力的基础上，提出了一种机械性能优越，易于弱磁扩速，同时能保证电机恒转矩运行时的转矩输出能力的新型转子磁路结构。

We theoretically investigated the effects of incorporating Ih, T-type Ca2+ current, sustained inward current, and/or low-voltage-activated L-type Ca2+ channel current on 1 creation of BP cells, 2 robustness of BP activity to electrotonic loads of nonpacemaking cells, and 3 BP cell ability to drive NP cells.

我们从理论上研究了合并Ih， T-型 Ca2+流，持续内向电流，和/或低电压激活的L-型Ca2+通道电流对1产生 BP细胞， 2 BP 活性对非起搏细胞电紧张负荷的稳定性，和 3 BP 细胞驱动 NP细胞的能力的作用。

This system consists of a power unit, a four-electrode probe, a constant current drive unit, pre-amplifier and filter units, a signal generator unit, and data acquisition and control units, where the signal generator unit, and the data acquisition and control units are carried out utilizing DAQ card (PCI-6024E) which is mounded inside a PC.

本系统硬体方面主要包括下列几个部份：电源电路单元、四端电极单元、定电流驱动单元、前置放大与滤波单元、信号产生单元、和资料撷取与控制单元等。

SMD-MC34119 Pinout: C Three External Clock Inputs, Two Multi-purpose I/O Pins per Channel C Double PWM Generation, Capture/Waveform Mode, Up/Down Capability One Four-channel 16-bit PWM Controller One Two-wire Interface C Master Mode Support Only, All Two-wire Atmel EEPROMs Supported One 8-channel 10-bit Analog-to-Digital Converter, Four Channels Multiplexed with Digital I/Os IEEE 1149.1 JTAG Boundary Scan on All Digital Pins 5V-tolerant I/Os, including Four High-current Drive I/O lines, Up to 16 mA Each Power Supplies C Embedded 1.8V Regulator, Drawing up to 100 mA for the Core and External Components C 3.3V VDDIO I/O Lines Power Supply, Independent 3.3V VDDFLASH Flash Power Supply C 1.8V VDDCORE Core Power Supply with Brownout Detector Fully Static Operation: Up to 55 MHz at 1.65V and 85C Worst Case Conditions Available in a 64-lead LQFP Package

SMD-MC34119引脚说明： C款三输入外部时钟，两个多用途I / O引脚每通道双PWM生成，捕获/波形模式，上/下能力的一个四通道16位PWM控制器一两线接口C中间模式支持，只有在所有两线Atmel公司的EEPROM支持的一个8通道10位模拟数字转换器，四通道复用数字I / O的IEEE 1149.1 JTAG边界扫描所有数字引脚5V容限I / O口，其中包括4大电流驱动I / O线，最多一六毫安C镶嵌每个电源1.8V的稳压器，绘图高达100的核心和外部元件 3.3 VDDIO毫安I / O的电源线，独立电源3.3V的VDDFLASH闪光 1.8 VDDCORE核心电源掉电检测与全静态工作：高达55兆赫和85℃时为1.65V最恶劣条件下以64引脚LQFP封装

Among them, the arm sport the adoption treads into the electrical engineering to drive, the wrist and bedrocks exercise to adopt the direct current electrical engineering to drive, the hand claw action adoption the air pressure drive.

其中，手臂运动采用步进电机驱动，手腕和底盘运动采用直流电机驱动，手爪动作采用气压驱动。

The paper designs and develops the direct current drive circuit of SOA to realize the cross phase modulation for dual-loop optical buffer in the lab.

本文设计并研制出了SOA的直流驱动电路，用于实现本实验室中双环全光缓存器中信号光与控制光的交叉相位调制。

In order to study diesel locomotive AC-DC electric-drive system, this thesis makes a analysis of the primary capability parameters of AC-DC electric-drive system, under the train"s running state, such as traction dynamotor"s voltage/ current, pulling power and train velocity, then makes a research in the ideal running characteristic and the adjust characteristic of dynamotor and the speed adjust characteristic of electromotor with the theory of AC-DC electric-drive.

本文针对内燃机车交-直电力传动系统，对机车运行过程中，传动系统的主要性能指标参数(如牵引发电机电压/电流、牵引力、机车速度等)及其关系进行分析；并运用交-直电力传动原理，对机车电力传动过程中牵引发电机的理想外特性、调整特性及牵引电动机的速度调节特性进行研究；通过参考东风7型内燃机车的性能、结构参数，运用Visual Basic对内燃机车交-直电力传动系统进行数学建模。

Edge characteristics are analyzed in discharges with supersonic molecular beam injection and lower hybrid current drive respectively.

以及雷诺协强的径向梯度与极向流和径向电场梯度与湍流损失的相互关系。

This brought fixed cost, but it also is meant at the same time use a source to won't make you singlehanded assume a problem.

这带来了一定的成本，但它同时也意味着使用开源不会让你独力承担问题。

He gained a small fortune in real estate.

他在房地产上发了一笔小财。