查询词典 current converter

Based on a low swing, low crossing point current switch driver and central symmetry Q2 random walk pMOS current source layout routing methods, a 1.8V 10 bit 120MS/s CMOS current-steering digital-to-analog converter IP core is implemented in a TSMC 0.18μm CMOS process.

采用低摆幅低交叉点的高速CMOS电流开关驱动器结构和中心对称Q^2随机游动对策拓扑方式的pMOS电流源阵列版图布局方式，基于TSMC0.18μm CMOS工艺实现了一种1.8V10位120MS/s分段温度计译码电流舵CMOS电流舵D/A转换器IP核。

In order to resolve such question,an optic-fiber current measurement system with simple structure and suitable for high voltage frequency converter was developed based on Faraday effect and principle of optic -fiber current sensors,where a high circular bi-refractive optic-fiber coil was used as a current s...

鉴于光纤传感可以解决上述问题，基于偏振态调制的光纤电流传感器原理，研究一种适用于高压变频器的小巧的，基于法拉第磁光效应的高圆双折射光纤电流检测系统，用Jones矩阵对光纤系统进行分析。

This high voltage electrostatic precipitation controller has 7 channels of analog input,2 channels of analog output, 12 digital inputs and 16 digital outputs. The analog input includes primary current, secondary current, primary voltage, secondary voltage, etc. Controller uses MAX 187 as the A/D converter, which ensure the sampling speed and the conversion precision in the same time. The processor unit is RCM2250 module. Rabit 2000 processor, a 128K SRAM and a 256K Flash Rom are integrated in RCM2250, which improves the performance of pricipitation controller. MAX504 is used to produce the 4~20mA current output.

模拟量输入采集的信号有升压变压器一次电流、一次电压、二次电流、二次电压等，采用12位逐次比较式A/D转换器MAX187，兼顾采样速率和转换精度；中央处理单元采用以8位嵌入式处理器Rabbit2000为基础的RCM2250模块，外扩128KSRAM和256K Flash ROM，内部资源丰富，提高了控制器的整体性能；模拟量输出采用内带基准源的10位电压输出数模转换器MAX504，实现了标准4～20mA电流信号输出；控制器通过控制算法在相应开关量点上输出可控硅的触发脉冲。

The chip consists of a power mos, mode select circuit, driving circuit, and two series of controller circuit. The controller consists to the active current sensing circuit, sample and hold circuit, hysteresis current comparator, voltage to current converter, error amplifier and non-overlap circuit.

晶片包含一组功率电晶体、模式选择电路、驱动电路及二组控制电路，控制电路主要架构有主动式电流感测电路、取样保持电路、磁滞电流比较电路、电压对电流转换电路、误差放大器及非重叠电路。

Brushless DC motor ; four-switch converter ; current sensor ; phase current sensing ; operating mode ; operating submode ; phase current regulation

无刷直流电机；四开关逆变器；电流传感器；相电流检测；工作模式；子工作模式；相电流调节

Through the analysis of the work principle of three phases voltage resource PWM converter, set up the low and high mathematic models, deduce the restriction equations about grid voltage, grid current, modulation voltage and the DC output voltage and the calculation equations of the AC-side inductance and the DC-side capacitance. There are two control strategies are adopted: Predicted current control strategy and voltage-current two closed-loop control strategy, and give a comparison by theory and practice.

通过分析三相电压源型PWM变换器的工作原理，分别分析了低频和高频数学模型，并推导出了交流侧电压电流、调制电压、直流侧电压之间的数学约束关系以及交流侧电感和直流支撑电容参数的选取依据公式；分析对比了两种控制策略：预测电流控制和电压电流双闭环控制并加以实验验证；同时采用了负载电流前馈补偿和本文提出的一种基于专家系统的神经元新型智能PI控制器两种方法大大提高了整个系统的动态响应性能，并在仿真和实验中加以验证，这也是本文研究的重点内容之一。

In the case of short - circuit,the output current amplitude and phase of PWM converter are controlled to adjust the equivalent impedance of current - limiter for fault current suppression.

故障发生后，通过变流器控制变压器二次侧注入电流的相位和幅值，进而调节限流器的等效阻抗，从而实现抑制短路电流的目的。

The most common ratio using current asset and current-liability data is the current ratio, which is current assets divided by current liabilities.

利用流动资产和流动负债数据计算的最常见的比率是流动比率，即流动资产除以流动负债。

Backset current area, the important factor of burner performance was discussed on the basis of carrying on numerical simulation to the cement kiln with three-channel burner by the model of. RNG k-ε. The model that backset current area was divided into center backset current area, interior backset current area, and other backset current area was compared in three-dimensional condition.

在采用重整化群κ-ε模型对水泥窑用多通道燃烧器进行数值模拟的基础上，针对影响燃烧器性能的重要指标－回流区进行讨论，将三维条件下燃烧器的流场分布与传统燃烧器流场进行劝比，提出了三维条件下燃烧器回流区分为中心回流区、内回流区、外回流区3个回流区的分布模型，并分析了影响回流区的直流风和旋流风2个重要因素。

The instantaneous current capacity may demonstrate through the nixietube, provides the craft data reference for the operator.8031If the system the setting value carries on again the current capacity actual value the comparison, calculates the control quantity after the PID adjustment operation vi, again transforms into the electric current output signal, after but controls the silicon-controlled rectifier after the enlargement the breakover angle, the realization adjusts the slippery difference electrical machinery magnetic clutch exciting current the function, thus the adjustment implementing agency slippery difference electrical machinery rotational speed, causes to transport on the leather belt the material current capacity to stabilize as far as possible nearby the setting value, and has the good static target and the dynamic performance.

瞬间流量可通过数码管显示出来，为操作人员提供工艺数据参考。8031系统再将流量实际值与其设定值进行比较，经PID调节运算后计算出控制量vi，再转换为电流输出信号，而后经放大去控制可控硅的导通角，实现调节滑差电机电磁离合器励磁电流的功能，从而调节执行机构滑差电机的转速，使输送皮带上的物料流量尽可能稳定在设定值附近，并具有良好的静态指标和动态性能。问题补充：希望大家不要给机器翻译的答案，我想要人工翻译的，谢谢大家了

Metrorrhagia is also gynaecological problems of common diseases.

崩漏是妇科常见病也是疑难症。

WordFTP gives you the convenience and timesaving you need.

wordftp让您的方便和省时您所需要的。