查询词典 current converter

The instruments used ATmega16L onboard A / D converter channels to achieve the cold wind pressure, the hot blast pressure, the furnace top pressure and cold wind current capacity four way analog acquisition;used PWM waveform produced by ATmega16L internal timing / Counter to achieve the entire differential pressure ,the cold wind flow and the permeability index three-way analog output for recording instruments; realized the cold wind pressure, the hot blast pressure, the furnace top pressure, the cold wind current capacity and the entire differential pressure five group parameter tour demonstration and the fixed-point demonstration by key-elect key's coordination during demonstration blast furnace permeable index; produced acousto-optics alarm when the permeable index across the upper and lower limits;used RS-485 realizing the communication with the superior computer.

仪表利用ATmega16L自带的A/D转换通道实现对冷风压力、热风压力、炉顶压力及冷风流量四路模拟信号的采集；通过ATmega16L内部的定时/计数器产生的PWM波形来实现对全压差、冷风流量及透气性指数三路模拟量输出供记录仪表使用；通过键选键的配合在显示高炉透气性指数的同时实现冷风压力、热风压力、炉顶压力、冷风流量及全压差五路参数的巡回显示与定点显示；当高炉透气性指数越上、下限时，仪表产生声光报警信号；仪表采用RS-485与上位机实现通信。

Based on a low swing, low crossing point current switch driver and central symmetry Q2 random walk pMOS current source layout routing methods, a 1.8V 10 bit 120MS/s CMOS current-steering digital-to-analog converter IP core is implemented in a TSMC 0.18μm CMOS process.

采用低摆幅低交叉点的高速CMOS电流开关驱动器结构和中心对称Q^2随机游动对策拓扑方式的pMOS电流源阵列版图布局方式，基于TSMC0.18μm CMOS工艺实现了一种1.8V10位120MS/s分段温度计译码电流舵CMOS电流舵D/A转换器IP核。

In order to resolve such question,an optic-fiber current measurement system with simple structure and suitable for high voltage frequency converter was developed based on Faraday effect and principle of optic -fiber current sensors,where a high circular bi-refractive optic-fiber coil was used as a current s...

鉴于光纤传感可以解决上述问题，基于偏振态调制的光纤电流传感器原理，研究一种适用于高压变频器的小巧的，基于法拉第磁光效应的高圆双折射光纤电流检测系统，用Jones矩阵对光纤系统进行分析。

This high voltage electrostatic precipitation controller has 7 channels of analog input,2 channels of analog output, 12 digital inputs and 16 digital outputs. The analog input includes primary current, secondary current, primary voltage, secondary voltage, etc. Controller uses MAX 187 as the A/D converter, which ensure the sampling speed and the conversion precision in the same time. The processor unit is RCM2250 module. Rabit 2000 processor, a 128K SRAM and a 256K Flash Rom are integrated in RCM2250, which improves the performance of pricipitation controller. MAX504 is used to produce the 4~20mA current output.

模拟量输入采集的信号有升压变压器一次电流、一次电压、二次电流、二次电压等，采用12位逐次比较式A/D转换器MAX187，兼顾采样速率和转换精度；中央处理单元采用以8位嵌入式处理器Rabbit2000为基础的RCM2250模块，外扩128KSRAM和256K Flash ROM，内部资源丰富，提高了控制器的整体性能；模拟量输出采用内带基准源的10位电压输出数模转换器MAX504，实现了标准4～20mA电流信号输出；控制器通过控制算法在相应开关量点上输出可控硅的触发脉冲。

Next, the following points are emphasized:(1) The design of photoelectric conversion preamplifier circuit. In order to improve the measurement accuracy of luminometer and ensure linear relationship of the photoelectric, operational amplifiers is designed as current-voltage converter form, on the one hand, it is available to zero-load effect; on the other hand, short-circuit current can be transformed into a voltage volume through the feedback resistor, it is equivalent to voltage drop flowed through a load resistor on the actual effect.

其次，本文重点做了以下工作：(1)光电转换前置放大电路的设计：为了提高照度计的测量准确度，确保光电间的线性关系，本设计把运算放大器接成电流电压变换器的形式，一方面可得到零负载效应；另一方面，短路电流通过反馈电阻变成电压量，实际效果相当于流过一个负载电阻形成的压降。

This paper proposes a novel zero-voltage and zero-current-switching pwm three-level converter, which introduces a block capacitor in series with the primary winding of the transformer to make the primary current to reduce to zero during zero state.

提出一种新颖的零电压零电流开关PWM三电平直流变换器，它是在基本的三电平直流变换器的变压器一次侧串入一个阻断电容，使一次电流在零状态时减小到零。

Brushless DC motor ; four-switch converter ; current sensor ; phase current sensing ; operating mode ; operating submode ; phase current regulation

无刷直流电机；四开关逆变器；电流传感器；相电流检测；工作模式；子工作模式；相电流调节

Through the analysis of the work principle of three phases voltage resource PWM converter, set up the low and high mathematic models, deduce the restriction equations about grid voltage, grid current, modulation voltage and the DC output voltage and the calculation equations of the AC-side inductance and the DC-side capacitance. There are two control strategies are adopted: Predicted current control strategy and voltage-current two closed-loop control strategy, and give a comparison by theory and practice.

通过分析三相电压源型PWM变换器的工作原理，分别分析了低频和高频数学模型，并推导出了交流侧电压电流、调制电压、直流侧电压之间的数学约束关系以及交流侧电感和直流支撑电容参数的选取依据公式；分析对比了两种控制策略：预测电流控制和电压电流双闭环控制并加以实验验证；同时采用了负载电流前馈补偿和本文提出的一种基于专家系统的神经元新型智能PI控制器两种方法大大提高了整个系统的动态响应性能，并在仿真和实验中加以验证，这也是本文研究的重点内容之一。

In the case of short - circuit,the output current amplitude and phase of PWM converter are controlled to adjust the equivalent impedance of current - limiter for fault current suppression.

故障发生后，通过变流器控制变压器二次侧注入电流的相位和幅值，进而调节限流器的等效阻抗，从而实现抑制短路电流的目的。

By using synchronous rectifier, a higher efficiency low-voltage output DC/DC converter module can be achieved. This paper presents a kind of synchronous rectification DC/DC converter, which includes active clamp circuit, insulating transformer, and current double synchronous rectifier.

为提高低输出电压的DC/DC变换器的效率，提出了一种倍流同步整流有源箝位DC/DC变换器，电路拓扑主要包括有源箝位电路、隔离变压器和倍流同步整流电路。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。