查询词典 cubic

In the first part of the paper, we construct a family of 1 parameter cubic algebraic curves interpolating four given points and two tangent lines at the endpoints, and one can manipulate the shape of cubic algebraic curves by controlling the points or the tangent line directly.

该文提出的代数曲线的结构有两种，一种是插值平面上四点及两端点切线的三次代数曲线；另一种是插值两端点、两切线及两曲率的三次代数曲线。

Because we mainly involve visual fields of medical science , have placed more contents on the development in the field of medical image of visual technology and argumentation used. Second part It is the visual technology knowledge, the generalization in such respects as the basic principle , basic functions, function store and three-dimensional animation technology to OpenGL ,etc. The realization of the system using OpenGL functions finish that three-dimension demonstration. The third part It is number value that calculate knowledge, three-dimension rebuild technology is it is it is it punish to fit to go on to need, the research of interpolator technology that cant leave, So this part has quoted the Hermite function principle , define cubic Hermite function to begin, calculate the differential coefficient among them draws cubic spline again.

由于我们主要是涉及医学可视化领域，所以将更多的内容放在了可视化技术在医学影像领域的发展与应用的论述；第二部分是可视化技术方面的知识，主要对 OpenGL 的基本原理、基本功能、函数库及三维动画技术等方面的概括，在系统实现时就是通过调用 OpenGL 函数库实现三维显示的；第三部分是数值计算方面的知识，三维重建技术需要进行拟合处理，离不开插值技术的研究，所以这一部分从埃尔米特函数原理开始讨论，引入三次埃尔米特函数，进一步计算时又引用三次样条函数。

Analysis data indicates that most of Ti belong to hexad cubic system of α-Ti changes to cubic system of β-TiD2, and the existance of new elements in electrolytic products is determined.

对电解产物的X射线衍射分析肯定了电解前属六方晶系的α-Ti大部分转变成立方晶系的份β-TiD2，并检测到了新的元素成份。

In this dissertation, we optimized the thinkness of each layer of TFEL devices using the layered optimization method to obtain ZnS: Ce〓 TFEL devices. Accoding to the energy level structure of Ce〓, two criteria for distinguishing the EL of Ce〓 were found out, from which it was conduded that the TFEL of ZnS: Ce〓 comes from 5d→4f transition of Ce〓. The measurement of brightness waveform showed that the TFEL of ZnS: Ce〓 was the luminescence from independent centers. and there were the field induced-delocalization in this process anf it〓s the cause of low TFEL efficiency of ZnS: Ce〓. In this dissertation, different influence factors on TFEL of ZnS: Ce〓 were sdudied. The influence of different host lattice is different: The blue/green ratio of ZnS: Ce〓 in hexagonal system of ZnS is larger than that in cubic system of ZnS, and the TFEL peaks in hexagonal system of ZnS moves toward longer wavelength compared with that in cubic system of ZnS. The adding buffer layer was used in this stage. The solubility of Ce〓 in ZnS was small and it was another limit to TFEL brightness of ZnS: Ce〓 device. The solubility of Ce〓 increased ten times when using Li ions as flux, so that the TFEL brightness of ZnS: Ce〓 was enhanced. It was found that the appearing of ZnO in active layer improves the TFEL of ZnS: Ce〓: the brightness and the wave range of ZnS: Ce〓TFEL were enhanced.

本文采用TFEL的分层优化方案，优化组合了各膜层厚度，选择最佳制备条件，得到了ZnS：Ce〓的TFEL；根据Ce〓的能级结构，找到了判别Ce〓的EL的两个简单依据，并据此断定ZnS：Ce〓的TFEL的两个发射峰分别属于Ce〓的〓和〓跃迁；亮度波形测量表明ZnS：Ce〓的TFEL属于分立中心发光，分析认为在此过程中存在着较严重的场致离化，这也是ZnS：Ce〓的TFEL效率较低的一个原因；本文考查了影响ZnS：Ce〓的TFEL的各种因素，发现：基质的晶体结构对ZnS：Ce〓的TFEL有所影响，在六角相ZnS中Ce〓的TFEL优于立方相ZnS中Ce〓的TFEL：发射峰的蓝-绿比相对较大，且光谱向短波方向移动，在此项研究中本文采用了在发光层前增镀过渡层的办法，过渡层为六角晶相的ZnO；限制ZnS：Ce〓的TFEL器件亮度的一个原因是Ce〓在ZnS中的溶解度低，本文用Li离子作助溶剂增大了Ce〓的溶解度，增大幅度为一个量级，并且ZnS：Ce〓的TFEL亮度明显提高；从ZnS：Ce〓的TFEL光谱来看ZnS：Ce〓的TFEL波长覆盖范围较小，亮度也不高，达不到做为白色TFEL材料的要求，需要寻找新的白色TFEL材料；在研究ZnS：Ce〓的TFEL中还发现：发光层中ZnO的出现有利于ZnS：Ce〓的TFEL：发射峰变宽、亮度增大。

Take CdS for account, hexagonal spherical CdS with average particle size of 50nm was formed in pyridine, cubic rod-like in 1,6 hexyl diamine, mixtures of cubic and hexagonal spherical particles in biethylamine .

以CdS为例，在吡啶中形成六方相球形CdS纳米晶，平均粒径约为50nm；在1-6已二胺中得到的是棒状立方纤锌矿的CdS；在二乙胺中，得到的是立方和六方的混合相，产物形貌为球形粒子。

In this paper,we give the representation of integral closure of a cubic extension about general Neotherian unique factorization domain (2,3 are not units). Then we give a series of integral number about a cubic extension.

本文在前人研究的基础上，去掉2，3可逆的这一条件，给出了诺特唯一分解环上的三次扩张的整闭包的描述，并由此刻画了一批该扩张下的整元。

Three-dimensional reconstruction is realized by three-dimensional morphological characteristic of cucumber leaf ,cubic Bezier curve of leafstalk,pentagon leafstalk section,jointing quadrangle leafstalk surface,leafstalk shags built by random and joint sequential C0 cubic NURBS surface in cucumber.

根据黄瓜叶的三维形态特征，利用3次Bezier曲线描述黄瓜叶柄曲线，采用五边形作为叶柄截面，用四边形面片进行叶柄表面拼接，并用随机方法生成叶柄的粗毛；利用C0连续的3次NURBS曲面拼接生成了黄瓜叶片曲面，实现了黄瓜叶的三维重建。

Because of cubic B spline curve have several advantages such as local controllable, continuity etc, an active contour model based on cubic B spline curve is proposed in this dissertation.

针对以上问题，结合三次B样条曲线连续性及局部可控性的特点，本文提出了一种基于三次B样条曲线的主动轮廓模型。

Using of optical microscopy, X-ray diffraction, transmission electron microscopy, hardness and tensile testing, the effect of thermal exposure at high temperatures on the microstructures and of high-temperature tensile properties of rapidly solidified AlCrYZr have been studied. The results show that there are two main phases,Al20Cr2Y(cubic, a=1.437 nm) and DO23Al3Zr(terganal, a=0.4 013 nm , c= 1.732 nm), in the as-solidified alloy. The Al20Cr2Y phase can maintain its cubic structure at 500℃, but the particles coarsen remarkably and even become lumpish. In coarse lumpish Al20Cr2Y phase the plane faults and twin structures exist.

摘 要：采用金相、 X射线衍射、透射电镜、硬度测定和拉伸试验研究了高温热暴露对快速凝固AlCrYZr合金显微组织影响和高温下力学性能的热稳定性，结果表明，快速凝固AlCrYZr合金主要第二相为Al20Cr2Y(立方，a=1.437nm)和DO23Al3Zr(正方，a=0.401 3nm， c=1.732nm)，Al20Cr2Y在500℃热暴露尚能保持其立方结构，但质点明显粗化，甚至块状化，在粗大的Al20Cr2Y相中存在有层错和孪晶结构。

Annual plywood consumption in Russia is 560 000 cubic meters. As expected, the share of OSB will account for 15% of the plywood market (i.e. 150 000 cubic meters a year).

正如预计，定向刨花板占据了15%的人造板市场也就是每年15万立方米。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。