查询词典 crystal particle

During the process,a series of artifactitious techniques are respec-tively adopted according to the types of products,such as low-temperature carbonization,crystal type control,particle surface processing,gas smash,etc.

在生产过程中，根据产品型号分别采取了低温碳化、晶型碳化、晶型控制、粒子表面处理、气体粉碎等一系列加工工艺。

By means of FTIR,SEM,DSC,TGA and XRD,we studied the microstructure,particle shape,meltage temperature,decomposition temperature and crystal degree,and gained better understanding about influences of different degrees of substitution on microstructure and thermal property of starch acetates.

用傅立叶红外、扫描电镜、差示扫描量热、热失重和X射线衍射测试技术对淀粉醋酸酯的结构、形貌、熔融温度、分解温度和结晶度进行表征，分析了不同取代度对醋酸酯淀粉的热性能及其结晶结构的影响。

H2SO4. By means of FTIR, SEM, DSC, TGA and XRD, we studied the microstructure, particle shape, meltage temperature, decomposition temperature and crystal degree, and gained better understanding about influences of different degrees of substitution on microstructure and thermal property of starch acetates.

用傅立叶红外、扫描电镜、差示扫描量热、热失重和X射线衍射测试技术对淀粉醋酸酯的结构、形貌、熔融温度、分解温度和结晶度进行表征，分析了不同取代度对醋酸酯淀粉的热性能及其结晶结构的影响。

Morphological structures of TiO2 such as crystal structure, particle size, surface area and surface state properties which influence photoactivity of the catalyst have been discussed.

本文介绍了TiO2多相光催化剂的作用机理及其结构特性对光催化活性的影响，并对TiO2的晶相组成、晶粒尺寸、比表面积、表面形态与光催化活性的关系作了综述。

The effect of inoculating crystal and additive on particle size and bulk density of CeO2 was studied.

用碳酸氢铵作沉淀剂制备大颗粒CeO2，研究了晶种和添加剂对CeO2产品的粒度和松装密度的影响，适量加入晶种和添加剂可以促进CeO2颗粒的长大。

The liquating of crystal is useful to its shape and size and a thin layer of glass will bring about which is helpful to glaze gloss. Through cross experiment design, the reasonable range of oil-drop glaze chemical composition is studied and the limitation that single special clay is added to glaze batch is broken. It is proved that using ordinary ceramic raw materials to produce oil-drop glaze is feasible if the chemical composition of glaze is reasonable and the technology control is suitable. In addition, through the experiment it is found out that proper firing rule is the critical factor that affects the oil-drop glaze decorating effect. At the same time, other technological factors, for example, the thickness of glaze layer, glazing method, the size of glaze particle, which can affect the quality of glaze surface, must be considered.

晶体的适当熔解促使油滴形状圆整、尺寸大小适中，并在晶体表面形成一层玻璃相，有利于釉面光泽度的提高；通过正交试验方法探讨了油滴釉合理的化学组成范围，并突破了传统油滴釉制品及目前大多数仿制品采用单一特定天然釉土配料的局限，试验证明，只要化学组成合理，工艺控制适当，使用普通制瓷原料生产油滴釉制品是完全可行的；此外，本研究还发现，合理的烧成工艺控制是影响油滴釉装饰效果的关键性因素，同时还应注意釉层厚度、施釉方法、釉料研磨细度等其他工艺条件对釉面质量的影响。

In the process for producing ammonium molybdate on particle size, bulk density, crystal shape and structureal components of ammonium molybdate.

研究了钼酸铵生产中的原始溶液密度、搅拌转数、反应温度、终点 p H值等因素对钼酸铵产品的粒径、松装密度、晶体形貌和结构成分的影响，选择了最佳工艺条件，介绍了实践情况。

For different materials,the macrostructure of damage sites are dissimilar.The microstructure of damage sites were indicated as follows:the damages of granite and marble after being particle impacted were made up of damage of cleavage surfaces and crystal faces and spread of cracks along phase interface and pore space,which is harmful to mechanical property;while the damages of concrete and mortar were made up of cracks of transition zone and aggregates and plastic flow of C-S-H,which may cause more hidden danger to perma nence than to mechanical properties.

对四种材料损伤形貌的微观分析表明：花岗岩、大理石受颗粒冲击后产生的损伤主要为拉应力导致的解理面、晶面的破坏以及裂纹沿相界面和孔隙的扩展，对其力学性能有较大的危害；混凝土和砂浆的损伤由过渡区开裂、骨料破裂和C-S-H的塑性滑移共同构成，对耐久性造成的隐患远大于对力学性能的影响。

In this project, the selection criteria of matrix and reinforcement for obtaining composites with high strength and toughness are determined. The as-cast and aged microstructures of composites reinforced with particles of different strength are observed, and their metallurgical conditions and stabilization mechanisms are analyzed. The aging precipitation behaviors and mechanisms are studied. Some characteristics of nano-materials (micro-distortion areas) are found in 150nm- Al2O3p/Al composites and their formation mechanisms are expatiated. The "flexible" restriction to the deformation of the matrix by low strength AlN particle is observed by in-situ TEM and SEM techniques, and the mechanisms of its resist on cracks propagation and its contribution to composite strength are revealed. The high temperature deformation behaviors of Al2O3p/Al composites are studied. A rare-earth coating is established on sub-micron Al2O3 particles, leading to an improvement in wettability between coated Al2O3 and liquid aluminum and a decrease in infiltration pressure. The strength and ductility of coated particles reinforced composite are also increased. The interfacial characteristics, bonding structures and their formation mechanisms are studied, and the crystal orientation relationships between reinforcement particles and aluminum matrix are investigated. Finally a lighter composite with better balance of strength and damping properties is reinforced with hollow ceramic microballoons of ultra-lower strength.

本项目发现了获得高强度和高韧性复合材料的基体、增强体选择依据；观察了各种强度质点增强复合材料的铸态和时效态微观组织，分析其微观结构形成的金属学条件及稳定性机理，研究了其时效析出规律和时效机制，发现了150nmAl2O3颗粒增强铝基复合材料基体中的纳米材料特征，并解释了其形成机理；利用TEM和SEM动态拉伸技术发现了低强度质点AlN颗粒对变形协调的&柔性强化&机制，揭示了其对裂纹扩展的阻碍作用和对复合材料高强度的贡献；研究了中强度质点的Al2O3颗粒增强铝基复合材料的高温变形行为，并对其进行了稀土界面层设计与制备，改善了颗粒与铝合金之间的界面润湿性，降低了复合材料铸造渗透压力，提高了复合材料的强、韧性；研究了多种复合材料界面结构及形成机理，确定了增强体与基体之间的界面结合机制，分析了复合材料界面处的晶体学位向关系；最后制备了含微孔的中空型陶瓷颗粒增强的特种复合材料，得到了强度和阻尼综合性能较好的轻质复合材料。

The calcium carbonate crystal is needle short fiber-typed, its length is 2-8 micron and width is 0.3-1.5 micron, the ratio of length and diameter is 5-10, its content of vaterite calcium carbonate is larger than 90% with small particle on the surface of.

该碳酸钙晶体为针状短纤维形，其尺寸长为2-8微米，宽为0.3-1.5微米，长径比在5-10，球霰石型碳酸钙含量大于90％。该针状短纤维碳酸钙晶体表面附载有小颗粒。

Fancy gold-plated dangling earrings with facetted White Opal crystals.

花式镀金悬垂耳环与facetted白欧泊水晶。

This essay chooses the study aim from biology teachers in middle school in Shi Jiazhuang which tells us that most of the middle school biology teachers in Shi Jiazhuang have the"burnout", lower successfulness, individualize.

本文选取石家庄市初中生物教师作为研究对象，运用问卷调查的方法对石家庄市初中生物教师职业倦怠的现状进行调查，调查结果发现，石家庄市初中生物教师这一群体普遍存在职业倦怠，情感枯竭程度偏高，成就感偏低，去个性化程度最为严重。