查询词典 cross-section paper

The bump at the approach abutment, which is the intuitionistic showing form, is the difficult problem of worrying the highway construction. By using of on the large-scale test flat and giving the control of ground subsidence curves in this paper, the results of large-scale tests of two different abutments (gravity type and cross brace type), which were treated with Geogrid, Geocell wedged-shaped flexible slab and lime soil replacement, were analyzed. The adaptability to ground subsidence and active property of Geocell Wedged-shaped Flexible Slab were achieved.

本文利用大比尺模型试验平台，结合给出的地基沉降控制曲线，对黄土填料下土工格室楔形柔性搭板、土工格栅加筋与灰土换填处治两种不同桥台类型之路桥过渡段的大比尺模型试验结果进行了对比研究，对两种桥台类型中各种处治方法的作用性状及对地基沉降的适应性进行了分析。

This paper, with the two-room laboratory rig, tested the cross and counter flow plate type air to air energy recovery heat exchanger at winter standard condition and non-standard condition.

本文在双房间环境的试验平台上，对逆流－叉流板式全热交换器在冬季标准工况和非标准工况下进行了实验测试，结果表明，在冬季标准工况下，其全热效率可达70%。

The innovation in the paper: First, it combines the higher education research and the population economic structure research together, searches the best meet-point of higher education research among different subjects, broadens the field and vision of cross research between higher education and closed subject from the horizontal dimension. Second, it discusses the basic relationship between higher education development and the components of population economic structure theoretically at the micro-level; moreover, it analyzes the correlation modes, existing problems between them in Henan Province, and provides the corresponding countermeasures. Third, it takes in the methods of quantitative analysis and qualitative analysis as a body..

论文的创新之处在于：一、把高等教育研究和人口经济结构研究相结合，在不同学科间寻找高等教育研究的最佳切合点，从横向层面拓宽了高等教育与相邻学科间进行交叉研究的领域和视野；二、从人口经济结构的微观层面，在理论上探讨了高等教育发展与人口经济结构诸组成部分间的基本关系，并以河南省为研究对象，细化分析了二者间的关联模式和存在的问题，提出了相应对策；三、融定量分析与定性分析于一体。

The paper designs and develops the direct current drive circuit of SOA to realize the cross phase modulation for dual-loop optical buffer in the lab.

本文设计并研制出了SOA的直流驱动电路，用于实现本实验室中双环全光缓存器中信号光与控制光的交叉相位调制。

In this paper, based on radar signal designing and cross correlation receiving technology,a method for gradually acquiring one-dimensional range profile using target echo is studied.

它可以处理一些环境信息十分复杂、背景知识不清楚的问题，能很好地应用到非合作目标识别中。

The paper discusses the principle of zero-phase wavelet extracted from Ground Penetrating Radar record at the base of coefficient of reflection being white noise and used to remove the random noise in the GPR signal with cross correlation filter.

该文简述了在反射系数为白噪声条件下探地雷达记录道中零相位子波的提取，并用提取的子波对探地雷达信号进行互相关滤波的方法原理及编写的相应的程序。

The work of the pre-buried tube: this is a very important task, in General, offsctdruckereien, one finds the control box in the paper of the surface, ground advance steel pipe, steel and wire cross sections, on the basis of the number of dislocations.

预埋惯的处事：这是一项很次给的处事，凡是来讲，胶印的把持电箱多数安插在输纸器的传不静背，在怠工不地基时预不后埋惯，采取钢惯答不梢据线径截背、不梢数来不决。

Through the construction of abutment replacement in Shangzhi Highway and Railway Cross-bridge, a comprehensive introduction of basic principle about abutment replacement technology by the bridge deck steel method was given and the construction technology and social benefits were analyzed in the paper.

通过尚志公铁立交桥支座更换施工，全面介绍桥面钢梁法更换支座的基本原理，并对该种技术的施工工艺、社会经济效益进行分析。

This paper has done some studies on arithmetic for this system: presents a method of detecting and tracing moving objects in real time, and analyses their height using the restriction of vanishing lines, vanishing points and cross-ratio in perspective geometry.

文中为实现这种智能视觉监控系统做了一些算法上的研究工作：实现了对运动物体进行实时检测和追踪，并利用透视几何中的消影点、消影线以及交比的约束方法对运动物体高度进行了分析。

In this paper two models of cross-shaped reinforced concrete masonry walls were established by using ANSYS to simulate related experimental research. The values analyzed from ANSYS are similar to the values of experiments.

用ANSYS有限元分析软件建立了2个十字形截面配筋砌体墙片的模型，模拟了相关的抗剪试验研究，计算结果与试验值有较好的吻合。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐