查询词典 cross-eyed

Results:1 CT demonstrated clear boundary and homogenous density in symptomless, near oval and symmetry. Normal cross section areas of scalene anterior muscle is 1.3793±0.0948cm2, normal CT value is 54.594±2.0106; 2 Cross section form of patient anterior scalene muscle is irregulation, adherence to tissue around, boundary not pure. Statistics display this area and CT value has obvious significant difference in symptomless group and patient group(P.01); 3 After one course, it shows 87.5%/100% of success rate and valid rate respectively in the short-term, as well as 71.8%/93.75% in the long-term.

结果：1 无症状者前斜角肌横断面形态双侧对称，成近椭圆形，轮廓清晰，与周围组织界限清楚，两侧横断面面积及CT值相近，C6上缘-C7上缘水平正常前斜角肌横断面面积为：1.3793±0.0948cm2 ，CT值为：54.594±2.0106；2 前斜角肌综合征患者患侧前斜角肌横断面形态不规则，与周围组织粘连，界限不清，统计显示患侧横断面面积较正常值增大，P＜0.01，差异非常显著，CT值较正常值增大，P＜0.01，差异非常显著；3 手法治疗1疗程后，随访显示近期优良率87.5%，有效率100%，远期优良率71.8%，有效率93.75%。

Results:1 CT demonstrated clear boundary and homogenous density in symptomless, near oval and symmetry. Normal cross section areas of scalene anterior muscle is 1.3793 0.0948cm2, normal CT value is 54.594 2.0106; 2 Cross section form of patient anterior scalene muscle is irregulation, adherence to tissue around, boundary not pure. Statistics display this area and CT value has obvioussignificant difference in symptomless group and patient group(P.01); 3 After one course, it shows 87.5%/100% of success rate and valid rate respectively in the short-term, as well as 71.8%/93.75% in the long-term.

结果：1无症状者前斜角肌横断面形态双侧对称，成近椭圆形，轮廓清晰，与周围组织界限清楚，两侧横断面面积及CT值相近，C_6上缘-C_7上缘水平正常前斜角肌横断面面积为：1.3793±0.0948cm~2，CT值为：54.594±2.0106；2前斜角肌综合征患者患侧前斜角肌横断面形态不规则，与周围组织粘连，界限不清，统计显示患侧横断面面积较正常值增大，P＜0.01，差异非常显著，CT值较正常值增大，P＜0.01，差异非常显著；3手法治疗1疗程后，随访显示近期优良率87.5％，有效率100％，远期优良率71.8％，有效率93.75％。

Simulation experiment and cases shows that change in seal space(both cross sectionally and areally) causes spatial variety of vertical seal in a same fault(both cross sectionally and areally).

通过模拟实验和实例对断层垂向封闭的差异性进行了研究，表明由于封闭空间变化造成同一条断层垂向封闭性在空间上存在着差异性，由于封闭条件和机理演化造成同一条断层垂向封闭在时间上存在着差异性，由于封闭对象改变造成同一条断层垂向封闭能力存在着差异性，在相同条件下，同一条断层垂向封油能力强于垂向封气能力。

Cross Stitch Patterns Online Shamrock Cross ...

交叉缝合模式在线酢交叉。。。

The observation of the sheet microstructure showed that under same rolling reduction be cause of the shearing stress of the cross-shear region in the cross shear rolling pro cess, it made the metal subjected more practical shearing strain and resulted in the increasing of the strength and deep drawing earing of the alloy sheet.

通过金相显微镜及电镜观察表明，在同样的几何变形程度下，由于异步轧制中搓轧区的作用，使金属经受更大的实际切变形，结果经异步轧制合金板的强度高，深冲制耳率也高。

Cross stitch patterns, cross stitch afghan patterns, shoulder bag ...

交叉缝合模式，跨缝阿富汗模式，肩袋。。。

The results showed that the fiber had the function of absorbing toluene and trichloroethylene after introducing HEMA into macromolecules, and the absorptive process obeyed Hill equation of sigmoidal model.Toluene and trichloroethylene absorbency increased with the increase of mass fraction of HEMA,and their maximum absorbency was 10 g/g and 21 g/g,respectively.The ratio of remaining fiber also increased with the increase of mass fraction of HEMA to make organic liquid retention ratio strengthen.Furthermore,dynamic mechanical performance of the fiber was affected by mass fraction of HEMA obviously, and the segments movement was influenced more obviously.At the same time,mass fraction of HEMA had a great impact on the surface and cross section morphologies,especially,many cavities existed in surface, and cross section had a lot of holes with asymmetric size when mass fraction of HEMA was equal to 15 wt%.

结果表明，HEMA引入大分子后，所得纤维对有机液体甲苯、三氯乙烯具有吸附功能，且吸附过程符合sigmoidal模型中的Hill方程；随HEMA质量分数的增加，纤维对甲苯和三氯乙烯的饱和吸附量增大，对甲苯和三氯乙烯的最大吸附量分别可达10 g/g和21 g/g；随HEMA质量分数的增加，纤维剩余率增加的同时，使纤维对甲苯和三氯乙烯的握持能力增强；HEMA质量分数对纤维动态力学性能有突出影响，特别是链段运动受其影响更为明显；HEMA质量分数对纤维表面和断面形貌均有显著影响，特别是当HEMA质量分数为15 wt%时，所得纤维表面出现了许多空洞，其断面存在许多尺寸不均的空洞。

Cross做To make the sign of the cross upon or over as a sign of devotion.

划十字：在…上画十字以示虔诚动词讲，这个意思经常被忽略。

To fulfill the need of the application of RP technique in medical domain, reverse CAD modeling from medical cross sections is systematically studied in this dissertation. Firstly, Some algorithms related to the research of this dissertation are studied. New algorithms for orientation and inclusion test for simple polygon, an error constrained automatic faring algorithm for B-spline curve and a theorem regarding the termination criterion for subdivision of triangular Bézier patch are proposed. Then based on similarity between contours of adjacent sections, a methodology for surface reconstruction from cross sections is presented. Finally, a virtual measuring method is proposed.

本文针对RP技术在医学领域应用的需要，系统研究了基于医学断层轮廓数据的反求CAD建模理论和方法：(1)在基础算法研究部分，提出了简单多边形方向及点在多边形内外判断的新方法、三角Bézier曲面片离散的误差控制定理和一种带误差约束的B样条曲线的自动光顺方法；(2)提出了一种基于相邻层轮廓相似性的医学断层轮廓数据曲面重构方法；(3)提出了一种称为"虚拟测量"的曲面模型处理方法。

In 1929 some improvements were announced to what was now called the '33/8" Super Exe': the mandrel bore was increased to 1/2"(but 17/32" in reality, so allowing a 1/2" bar to pass clear through), the saddle carried a conventional compound slide rest with a T-slotted cross slide and swivelling top slide and, happily, the 10 tpi Acme-form cross feed screw had the outer flat rim of its handwheel engraved with a micrometer scale - an improvement mirrored simultaneously on the 4-inch lathe.

在1929年宣布了一些改进的话现在称为'33月8日"超级可执行'：在轴孔增加到1 / 2 "（但17/32 "在现实生活中，这样使1 / 2 "酒吧，通过明确的通过），鞍进行常规复合幻灯片其余的T型槽交叉旋转顶端幻灯片和投影片，并令人高兴的是， 10 TPI公司的Acme形式跨了饲料螺钉外单位辋其手刻有一微米尺度-改善镜像同时在4英寸车床。

The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.

主要做了如下几个方面的工作：对伸臂位于顶部的单层框架—筒体模型进行分析，提出了等效转动约束的概念和转动约束刚度的表达式。

Male cats normally do not need aftercare with the exception of the night after the anesthetic.

男猫通常不需要善后除了晚上的麻醉。