查询词典 critical temperature

We get the critical temperature and the critical exponents both in periodic system and quasiperiodic system.

这为热力学相变的量化提供了一个很好的方法。

A SCF is defined as a substance above its critical temperature and critical pressure.

超临界流体是在其临界温度与临界压力之上的物质。

The results show that the experimental results are in good agreement with the values of viscosity in a part of temperature range that has been reported, with the relative error of less than 2.5%; In the process of ascent and descent temperature, the irreversible phenomenon of the curve of viscosity versus temperature V presents interzone characteristic, and the break of viscosity at critical temperature reflects jump change of melt structural information; It is one to one correspondence between viscosity and atomic size, and this relation is consistent with the Hall-Petch formula in expression way.

结果表明：实验结果与已报道的部分温度区间内的黏度值基本一致，相对误差低于2.5％；升温和降温过程中，黏度－温度关系曲线V的不可逆现象具有区间特征，临界温度时黏度的突变反映出熔体结构信息的跳跃变化；黏度与原子集团尺寸之间存在一一对应关系，该关系在表达上符合Hall-Petch公式。

Isobutane has a specific gravity of 0.56, a boiling point of 11°F at 14.7 psi, a vapor pressure of 72 psia at 100°F, a critical temperature of 275°F, and a critical pressure of 529 psia.

异丁烷的相对密度为0.56，在14.7磅/平方英寸压力下的沸点为11°F，在100°F温度下的蒸气压力72磅/平方英寸，临界温度为275°F，临界压力为529磅/平方英寸。

Electronic laminating machine this behavior particularly acute exceeded the critical temperature to master film covering the work area, not only complex, as well as well so that the markinf matozoa near the cross-linking reaction, matozoa issued the curing approximate hard, so that when it again when heated intenerated reluctant, covered with plastic film operation the correct temperature control methods, and that is fine is extremely close to master the cross-linking reaction temperature of the resin coated temperature.

电子复膜机这种现象特别明显）恰到好处地掌握覆膜温度临界工作区域，不仅复合效果好，同时还使热熔胶体接近交联反应的热点，胶体的固化近似发硬、这样当其再度受热时就不会轻易软化，覆膜操作正确的温度控制方法，就是精细掌握这种极为接近交联反应温度的覆膜温度。

On the basis of referring the foreign and domestic literatures and systematically generalizing the former research results, firstly, from the adsorption gas, coal spontaneous combustion and the heat resolves, thesis analyzes the ignitable gas occurrence. Secondly, though the experiment station of coal spontaneous combustion, thesis obtains the critical temperature 60 ℃～ 100 ℃, splits temperature 100℃～ 150 ℃, the fission temperature 150℃～ 180 ℃ and the speed-up temperature 210℃～ 250 ℃ and ignitable gas release rules in the several temperatures sections according to the results. Finally according to fire resource and the catastrophe theory, ignitable gas explosion characteristic and the influence factors have been conducted of the qualitative investigation and the quantitative determination. The gas explosion control technologies are put forward. It has built the certain foundation for the effective prevention gas explosion accident occurrence.

本论文采用理论分析和实验模拟相结合的综合研究方法，首先从煤层吸附瓦斯、煤氧复合过程及煤高温热解三方面对采空区可燃性气体的产生进行分析；其次通过对大型煤自然发火实验测试台的应用，根据实验结果得到临界温度60℃～100℃、干裂温度100℃～150℃、裂变温度150℃～180℃和增速温度210℃～250℃等几个温度段的可燃性气体释放规律；最后根据爆炸引火源，结合瓦斯爆炸流变-突变理论，对可燃性气体爆炸特性及影响因素进行了定性研究和定量测定，提出瓦斯爆炸事故的控制对策，为有效预防瓦斯爆炸事故的发生打下了一定的基础。

First of all, this paper analyzes the distributing situation of sectional temperature of two steel frame models within an hour utilizing the transient thermal analyse module of ANSYS;Secondly, carries on the failure analysis to two steel frame models at high temperature and obtains the fire-resistant limit and critical temperature of steel frame, utilizing the static nonlinear analyse module of ANSYS and considering the influence of geometry nonlinearity and material nonlinearity; Finally, according to the fire-protection designing requirement of structure, deduce a method to computer the thickness of fireprotection layer for steel structure and ask out the thickness of fireprotection layer of two steel frame models according to this method .

首先，利用ANSYS瞬态热分析模块，分析出两个钢框架模型在一小时内钢框架的截面温度场分布情况；其次，利用ANSYS静力非线性分析模块，综合考虑几何非线性及材料非线性影响，对钢框架模型在高温下进行失效分析，分析出两个钢框架的耐火极限及临界温度；最后，根据结构防火设计要求，推导出一种钢结构防火层保护厚度的计算方法，并据此方法求出两个钢框架模型的防火层厚度。

Firstly, based on the analysis of viscosity data, combined with other methods, a new method is proposed to calculate the viscosity of saturated vapor of halides. The calculation can be done on condition that the critical temperature, critical pressure, critical specific volume, molecular weight and the eccentric factor are known.

在理论研究上，一方面对于卤代烃的饱和蒸气粘度进行了研究分析，并结合其他理论推算方法的优点，提出了一种推算卤代烃的饱和蒸气粘度的新方法，该方法在已知临界温度、临界压力、临界比容、分子质量、偏心因子的情况下，便可以计算在有效对比温度范围内的饱和蒸气的粘度，本方法的适用范围是对比温度T〓在0.5-0.95之间，其对饱和蒸气粘度推算的平均偏差不超过5％。

The results at zero-temperature and finite temperature are analyzed,the possibility and critical temperature of Mott metal-insulator transition is also inv.

在绝对零度和有限温度对结果作了分析，讨论了Mott 金属-绝缘体相变的转变温度。

On condition that the critical temperature and critical density or critical specific volume are known, the density of saturated liquid can be calculated with high accuracy.

利用该方法在已知临界温度和临界比容或临界密度的条件下，可以对所有乙烷系氟里昂的饱和液体密度进行推算，该方法推算的平均偏差不超过1%，最大偏差不超过1.5%，可满足CFCs替代物研究和应用的需要。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。