查询词典 crack

Changes suddenly in the net joining reason place steel bar section, has the stress concentration, creates the pan partial crack compared to bend the region the crack to widen generally about 25%, this may through cause the lap joint to be located the stress to compare the narrow view the stipulation to solve, may cause the joining reason place crack opening not to surpass the standing operating procedure.

在网片搭接端头处钢筋截面突然变化，产生应力集中，造成板面局部裂缝比一般受弯区域的裂缝加宽25％左右，这可通过使搭接接头位于受力较小处的规定来解决，可使搭接端头处的裂缝宽度不超过标准规定。

Although the theory believed, the cast-in-place concrete floor crack is a phenomenon which avoids with difficulty, but through the design, the construction and a series of strict technical management measure, reducing and avoiding the crack is completely feasible.in fact it also has quite many projects not to have the naked-eye obviously crack.

虽然理论认为，现浇混凝土楼板裂缝是难以避免的现象，但通过设计、施工等一系列严格的技术管理措施，减少和避免裂缝是完全可行的，实际上也有相当多的工程未发生肉眼可见的裂缝。

Through studying mechanism of drilling string failure in the action of interaction of cyclicstresses and corrosion, we find fracture source is accord with pitting corrosion inside surface ofdrilling string, crack from pitting corrosion lead to drilling string failure, the process of drillingstring failure is new drilling string → corrosion pit forming and crack initiation → corrosionfatigue crack propagation→piercement or fracture.

通过研究在钻柱交变应力和腐蚀的交互作用下的机理发现，腐蚀疲劳裂纹源与钻杆内壁蚀坑对应，蚀坑萌生裂纹造成钻柱失效，钻柱腐蚀疲劳破坏过程归结为：新钻杆—蚀坑形成及裂纹萌生—裂纹扩展—刺穿和断裂。

The crack occured in silica brick generally includes surface crack and layer crack.

硅砖中裂纹包括表面裂纹和层裂。

Self-fluxing Fe-Cr-Ni-B-Si alloy prowders are laser clad on medium carbon steel substrate of dimensions 80×35×10mm〓. The investigation results of this clad layer are: micro-defects, micro-cavity and occluded forin substance, are the micro-cracks and crack resourses in clad layer; crack of coating propagates along the boundary of two kinds of eutectic sutructure; The included angle θ between the cracking direction and laser scanning direction in multitrack overlapping clad is smaller than that in one-track clad because of crack propagating along crystalline growth direction and crystalline direction in overlapping zone being different from it in one-track clad.

在调质态的45〓钢表面，采用预置粉末法进行FeCrNiBSi合金的多道搭接激光熔覆，对其熔覆层进行分析表明：多道搭接激光熔覆层裂纹扩展方向与激光扫描方向间的夹角θ与单道熔覆时相比明显变小，前者θ0°，后者θ角基本都为90°，这主要是因为多道搭接时，搭接区结晶方向发生了变化以及裂纹沿结晶方向扩展所致；激光熔覆层裂纹大多是以覆层与基材交界面的孔洞、熔覆层内不同方向共晶团间的显微缩孔、夹杂物的边界等三种显微缺陷作为裂纹源，并沿低熔点物相形成元素偏析造成弱化膜的共晶团界面扩展延伸。

The VCL method and the displacement method are used to calculate the Stress Intensity Factors of semi-elliptical surface crack at the root of pipe screws, on the basis of which a simplified calculating model for screws contact is put forward so as to analyse the fracture intensity for oil drill pipe screw coupling. For the semi-elliptical surface crack with different shape and deep ratio at the root of female and male screws and the corner of male flange, the SIF has been studied systemically under inter-pressure, tension, bend and torsion loads and the approximate formulas encluding the structure parameters of oil drill pipe screw coupling, deep ratio and the shape parameters of surface crack are developed.

对工程实际中的多种石油钻杆接头螺纹连接件，就公螺纹齿根、母螺纹齿根、公螺纹台阶转角处存在的不同形状、不同厚度比的半椭圆表面裂纹，在拉伸、内压、弯曲、扭转多种载荷作用下的应力强度因子作了系统研究，在大量有限元计算基础上，建立了包含接头结构参数、裂纹形状、厚度比在内的近似计算公式。

The rub-impact between rotor and stator often occurs because the rotor shaft stiffness decreases following the occurrence of the crack in the rotor shaft, and thus the coupling fault with rub-impact and crack is hackneyed fault type. Based on the nonlinear dynamical model of the cracked rotor-bearing system with rub-impact, the stability of the periodic motion and instability way were studied in unbalance-rotating speed plane and rotor/stator clearance- rotating speed plane and crack depth- rotating speed plane, and the main results were validated by the experiment.

转子轴承系统裂纹故障的出现会引起转子系统转静件之间碰摩故障的发生，因此裂纹碰摩耦合故障也是转子系统常见的故障类型，本文在裂纹碰摩耦合故障转子轴承系统的非线性动力学模型基础上，分析了系统在不平衡量-转速、碰摩间隙-转速、裂纹深度-转速等参数域内，周期运动的稳定性及其失稳规律，并用实验验证了主要理论结果。

By creating the gap the hoof at the area of the quarter crack no longer takes a pounding which keeps the crack open in essence the area Floats giving the crack a chance to mend.

通过创建差距，胡夫在该地区的季度裂纹不再是以冲击，其中存有裂纹公开联络，在本质上面积联络 floats 给予打击一个机会改过自新。

Graph 1 fore-and-aft hot crack pursues if the hot crack form of model of 2 local hot crack pursues show 3 times.

图1纵向热裂纹图2局部热裂纹典型的热裂纹形式如图3所示。

The influence of thedifferent parameters, such as blank-holder condition, thickness of blank sheetand material pattern on the wrinkle and the crack is analyzed. FLD is used tojudge the crack on the multi-point forming process successfully. The predictionof crack accords with the experiment ones, which shows choosing the properparameters can eliminate or restrain the defects, and also benefits the MPFtechnique and the shaping analysis.

本文对使用弹性介质和无弹性介质的多点成形过程进行了对比，指出使用弹性介质时在满足成形精度的前提下可以明显改善工件的成形质量，并通过对不同厚度和弹性模量的弹性介质对压痕的抑制作用进行了对比分析，探讨了最佳的弹性介质参数。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了