查询词典 crack on

Self-fluxing Fe-Cr-Ni-B-Si alloy prowders are laser clad on medium carbon steel substrate of dimensions 80×35×10mm〓. The investigation results of this clad layer are: micro-defects, micro-cavity and occluded forin substance, are the micro-cracks and crack resourses in clad layer; crack of coating propagates along the boundary of two kinds of eutectic sutructure; The included angle θ between the cracking direction and laser scanning direction in multitrack overlapping clad is smaller than that in one-track clad because of crack propagating along crystalline growth direction and crystalline direction in overlapping zone being different from it in one-track clad.

在调质态的45〓钢表面，采用预置粉末法进行FeCrNiBSi合金的多道搭接激光熔覆，对其熔覆层进行分析表明：多道搭接激光熔覆层裂纹扩展方向与激光扫描方向间的夹角θ与单道熔覆时相比明显变小，前者θ0°，后者θ角基本都为90°，这主要是因为多道搭接时，搭接区结晶方向发生了变化以及裂纹沿结晶方向扩展所致；激光熔覆层裂纹大多是以覆层与基材交界面的孔洞、熔覆层内不同方向共晶团间的显微缩孔、夹杂物的边界等三种显微缺陷作为裂纹源，并沿低熔点物相形成元素偏析造成弱化膜的共晶团界面扩展延伸。

The VCL method and the displacement method are used to calculate the Stress Intensity Factors of semi-elliptical surface crack at the root of pipe screws, on the basis of which a simplified calculating model for screws contact is put forward so as to analyse the fracture intensity for oil drill pipe screw coupling. For the semi-elliptical surface crack with different shape and deep ratio at the root of female and male screws and the corner of male flange, the SIF has been studied systemically under inter-pressure, tension, bend and torsion loads and the approximate formulas encluding the structure parameters of oil drill pipe screw coupling, deep ratio and the shape parameters of surface crack are developed.

对工程实际中的多种石油钻杆接头螺纹连接件，就公螺纹齿根、母螺纹齿根、公螺纹台阶转角处存在的不同形状、不同厚度比的半椭圆表面裂纹，在拉伸、内压、弯曲、扭转多种载荷作用下的应力强度因子作了系统研究，在大量有限元计算基础上，建立了包含接头结构参数、裂纹形状、厚度比在内的近似计算公式。

The rub-impact between rotor and stator often occurs because the rotor shaft stiffness decreases following the occurrence of the crack in the rotor shaft, and thus the coupling fault with rub-impact and crack is hackneyed fault type. Based on the nonlinear dynamical model of the cracked rotor-bearing system with rub-impact, the stability of the periodic motion and instability way were studied in unbalance-rotating speed plane and rotor/stator clearance- rotating speed plane and crack depth- rotating speed plane, and the main results were validated by the experiment.

转子轴承系统裂纹故障的出现会引起转子系统转静件之间碰摩故障的发生，因此裂纹碰摩耦合故障也是转子系统常见的故障类型，本文在裂纹碰摩耦合故障转子轴承系统的非线性动力学模型基础上，分析了系统在不平衡量-转速、碰摩间隙-转速、裂纹深度-转速等参数域内，周期运动的稳定性及其失稳规律，并用实验验证了主要理论结果。

By creating the gap the hoof at the area of the quarter crack no longer takes a pounding which keeps the crack open in essence the area Floats giving the crack a chance to mend.

通过创建差距，胡夫在该地区的季度裂纹不再是以冲击，其中存有裂纹公开联络，在本质上面积联络 floats 给予打击一个机会改过自新。

Graph 1 fore-and-aft hot crack pursues if the hot crack form of model of 2 local hot crack pursues show 3 times.

图1纵向热裂纹图2局部热裂纹典型的热裂纹形式如图3所示。

The influence of thedifferent parameters, such as blank-holder condition, thickness of blank sheetand material pattern on the wrinkle and the crack is analyzed. FLD is used tojudge the crack on the multi-point forming process successfully. The predictionof crack accords with the experiment ones, which shows choosing the properparameters can eliminate or restrain the defects, and also benefits the MPFtechnique and the shaping analysis.

本文对使用弹性介质和无弹性介质的多点成形过程进行了对比，指出使用弹性介质时在满足成形精度的前提下可以明显改善工件的成形质量，并通过对不同厚度和弹性模量的弹性介质对压痕的抑制作用进行了对比分析，探讨了最佳的弹性介质参数。

Presently research and evaluation method on it are very limited. Through bending creep test at 0C and bending test at -10C, this thesis studies the crack resistance at different aging condition. Research shows that the aging procedure will greatly reduce the asphalt mixtures crack resistance.

目前对此的研究和评价方法还较少，本文对短期老化和长期老化后的沥青混合料进行了O℃弯曲蠕变试验和-10℃弯曲试验研究，分析了不同老化状态下沥青混合料的低温抗裂性能。

They say that she is a hard nut to crack, but I think I can crack it.

据说她是个难对付的女人，但我有办法。

In order to calculate the crack expansion life in the action of variable amplitude load for the metal bar with V-shaped notch, the formula of bar fracture frequency was obtained theoretically by setting a size of bar fracture region applied in the engineering. Based on it, the mathematic expression of crack expansion life of bar V-shapednotch tip in the action of variable amplitude load was built.

针对金属棒料在变幅载荷作用下需要较精确地获取其V形槽尖端裂纹扩展寿命的问题，通过给定一个工程上能接受的瞬断区尺寸，获得了棒料断裂频率的计算公式，在此基础上，建立了变幅载荷作用下棒料V形槽尖端裂纹扩展寿命的数学表达式。

Forecasting crack and it's distribution mode is almost equivalent to forecasting oil and gas, so it is important to correctly understand underground crack in exploratory development.

可以说对裂缝及其分布规律的预测几乎等价于对油气的预测，所以对地下裂缝的正确认识对油气的勘探开发具有重要的意义。

In the days of sailing vessels the crew were afraid they would be becalmed on the ocean.

在使用帆船的时代，船员们担心他们会因为无风而无法在海洋上航行。

As long as foreign donors pay the PA's salary bill, few expect a new intifada.

只要外国继续为巴权力机构的薪水买单，希望发动新暴动的人便寥寥无几。