查询词典 cover charge

The structure of Deng Ta Community is non-profit andrelies on volunteer work. Membership, as well as most activities,is free of charge. As much as possible, no money is involved: wewant to promote a moneyless society. However, donations areaccepted in order to cover basic running expenses.

灯塔成长社区是非盈利性的组织，主要依靠志愿者工作，因而绝大多数的活动应该是免费的，尽可能少的卷入物质和金钱关系，我们希望提供一个非物质的社区（我们欢迎和鼓励成员之间的物物交换，这一工作可以通过有组织的清晰的途径进行）。

A 20% charge will be made to cover cost of rehandling and reinspection.

另外还要预付20％的费用用于重新装卸和重新检查。

As he passed the Ruhmkorff coil charge through the tube, he determined that the cover was light-tight and turned to prepare the next step of the experiment.

当他通过Ruhmkorff线圈通过管费，他认定，涵盖了光紧，转向准备下一步的实验。

This amount, and noadditional charge, is subtracted from the total when we reissue thecheck to cover the cost of the stop payment request.

我们重新签支票的时候要从总额里扣除这20元（意思是你得承担这20元的费用）。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

A 20% charge will be made to cover cost or reh and ling and reinspection.

另外还要预付20%的费用用于重新装卸和重新检查。

A 20% charge will be made to cover cost or rehandling and reinspection.

另外还要预付20%的费用用于重新装卸和重新检查。

Thou sawest thy America, thy lifetask, and didst charge to cover like the transpontine bison.

你瞧见了你的美国[304] ，你毕生的事业，像大洋彼岸的野牛那样，为了交配而猛冲过。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

Material is one-time 30~50ml injector 1 pair, one-time glove 1 pair, rubber cap 1 (one-time infusion implement the rubber cap) that go up, the 100~150ml of nose raise fluid that already had had is filled inside clean container, temperature 38~40 ℃. 2 methods little patient takes right skew slope, handlers is abluent both hands wears a glove, open one-time injector, the 50ml injector piston after deciding gastric canal is inside the stomach is abandoned, the tit joins the stomach is in charge of, nose raise fluid is slow enter injector inside, raise gastric canal to come fore-tooth 10~20cm height, have the aid of of fluid of raise letting bazoo is gravitational slowly flow into a stomach inside, warm boiled water rinses conduit after the end, cover with rubber cap finally on the stomach provides terminal. 3 advantages (1) operation goes to the lavatory simply.

为减少误吸的发生，将传统的鼻饲法进行了改良，经临床应用效果满足，现报告如下。1材料一次性30~50ml注射器1副，一次性手套1副，橡皮帽1只(一次性输液器上的橡皮帽)，清洁容器内盛已备好的鼻饲液100~150ml，温度38~40℃。2方法患儿取右侧斜坡位，操作者洗净双手戴上手套，打开一次性注射器，确定胃管在胃内后将50ml注射器的活塞弃去，乳头连接胃管，鼻饲液缓慢倒入注射器内，提高胃管至门齿10~20cm高度，让鼻饲液借助重力缓缓流入胃内，结束后温开水冲洗管道，最后用橡皮帽套上胃管末端。3优点(1)操作简单方便。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。