查询词典 coupler

See also Acoustic Coupler.

参见Acoustic Coupler。

The results also show the sensitivity is enhanced for the pigments with a larger anilide ring. It is important to note that the photosensitivity is greatly increased when the coupler component changed ftom a 2-hydroxy-3-naphthanilide to a 2-hydroxy-11H-benzocarbazole-3-naphthanilide coupler. Clearly, conjugation effects favours to enhance the photosensitivity.

偶合基部分共轭环的扩大使蒽醌偶氮染料的光敏性增加，特别是偶合基萘环上扩大了一个咔唑环后，其吸收光谱大幅红移，光敏性提高了几十倍，这一结果对红外偶氮光导染料的设计合成具有重要参考价值。

The results of UV absorption show that λ max is not sensitive to the electronic effects exerted by the substituent in the coupler moiety. The λ max has a small red-shift when the anilide aromatic ring in the coupler moiety is larger. This indicates that the conjugation effect of the anilide ring with chorosorb is not very significant. It is important to note that a red-shift of 60-130 nm was observed when the coupler component changed from a 2-hydroxy-3-naphthanilide to a 2hydroxy-11H-benzocarbazole-3-naphthanilide coupler. The red-shift may be due to the conjugation resulting from the carbazole ring.

对上述三个系列偶氮染料吸收光谱的研究结果表明，偶合基酰胺芳环共轭环的扩大对偶氮染料在可见光区最大吸收红移作用不是很显著；当偶合基萘环上共轭环扩大了一个咔唑环后，其偶氮染料在可见光区的最大吸收大幅红移，跨入近红外染料行列，这一结果对红外偶氮染料的设计合成具有重要的参照价值。

The numerical analysis model of fiber coupler in the process offused biconical taper is constructed successfully. The numericalanalysis of fiber coupler in the process of fused FBT is accomplishedwith finite element software.

建立了光纤耦合器熔融拉锥有限元计算模型，实现了光纤拉锥流变全过程数值仿真，可预测分析器件制造参数对流变制造过程的影响。7。

Taking the fiber coupler as represent, aiming at the performanceproblem of the fiber coupler which is used in the market, such as theoptical performance differences of accepted products, technologicaloptimization and stability reflected by the low rate of finished products,how to reduce excess loss, and so on. From the view of manufacture of rheological formation, the research of experiment and theory has beendeveloped. The effects of rheological technological parameters such asdrawing speed and fused temperature on the optical performance,microstructure and the process of rheological formation have beeninvestigated. It is discovered that the present heating mode of combustinggas can\'t satisfy with the rheological manufacturing technological needof high performance fiber devices. A new resistance heating system is putforward, designed and manufactured, and a new fused biconical tapermachine is developed.

论文以光纤耦合器为代表，针对目前市场上广为应用的光纤器件存在的性能问题，如合格产品的光学性能差异，成品率不高所反映的制备工艺优化与稳定问题，如何进一步降低附加损耗等，从光纤耦合器流变成形制造的角度，分析了流变制造工艺参数如拉锥速度与熔融温度及其扰动对流变制造成形过程、微观结构与器件光学性能的影响，发现现有燃烧气体火焰的加热方式不能满足高性能光纤器件的流变制造技术要求，提出、设计并制造了一种新型的电阻加热系统和熔融拉锥机。

Therefore, we utilize optical switch to switch over two routes P1 and P2 which are normal feeder fiber P1 and protecting fiber P2. Signal pass P1 and P2 and through 2X2 coupler, splitter, and 2X1 coupler into the drop fiber. Finally pass through WDM coupler and filter into ONU.

传输时利用光开关切换成两路路径P1和P2，分别为在正常下的P1馈线光纤和发生错误时切换成P2保护光纤，再经2X2耦合器、分歧器和2X1耦合器，进入终端光纤，最后经分波多工耦合器和滤波器后进入光网路单元。

For a given mechanism, the coupler points passing through two acceleration poles are the double points on the loci of acceleration poles described on the coupler plane. Furthermore, the two mechanisms with a coupler point tracing through two acceleration poles are synthesized by utilizing the derived parametric equations.

接著，利用耦杆平面之加速度极心轨迹的交点，作为机构中可通过两个加速度极心的耦杆点，并且配合已推导出来之参数式，合成通过两个加速度极心的机构。

Now there are four major types of FGCs: separated structure based on Mach Zehnder interferometer, dissymmetric structure based on 100% coupler, dissymmetric structure based on 0 coupler and symmetric structure based on 100% coupler.

光纤光栅耦合器主要有4种结构：基于MZ干涉仪的分离型、基于100％耦合器的非对称型、基于0耦合器的非对称型和基于100％耦合器的对称型。

By compared maximum coupler force and maximum acceleration of car body with common slack coupler at condition of train starting,braking,emergency braking and releasing,we verified that small slack coupler is better than common slack coupler in dynamics performance.This paper also calculated the train dynamics performance parameter with different buffer and braking system,running in different line and using different operating method.

本文利用列车纵向动力学模拟程序，计算了齐齐哈尔车辆公司研制的13号小间隙防脱车钩的纵向动力学性能，通过比较各个车钩间隙下列车最大纵向车钩力和列车最大加速度的数值，得出小间隙车钩在列车启动工况、常用制动工况、紧急制动工况、缓解工况的纵向动力学性能都较原有车钩性能优异的结论。

According to the requirements of 3 dB-coupler in adjacent-channel duplexers and the basic principles of 3 dB-coupler, a narrow band 3 dB-coupler is analyzed which can applied to digital TV field.

根据数字邻频双工器中对三分贝耦合器的要求和三分贝耦合器的基本原理，对应用于数字电视领域的一款窄带三分贝耦合器进行了分析。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。