查询词典 copper-manganese

For choosing a material to interfere with IR and laser,the IR and 10.6μm laser transmissivity of micron-copper powders of different components were tested in the smoke chamber,when the concentration of the smoke reached 1.0 g·m-3,the transmissivity of 1~3μm,3~5μm and 8~14μm IR under 30%,and the transmissivity of 10.6μm laser under 20%,the attenuation ability of red copper powders,green and red copper powders and green copper powders to IR and 10.6μm laser increased gradually.At the same time,the interferent...

为选择一种能够遮蔽红外与激光的烟幕干扰材料，在烟幕箱中测试了组分配比不同的微米铜粉的红外与10.6μm激光烟幕透过率，当烟幕浓度为1.0 g.m-3时，1~3μm，3~5μm，8~14μm红外的透过率均小于30%，10.6μm激光的透过率小于20%，红光铜粉、青红光铜粉和青光铜粉对红外与10.6μm激光的衰减能力逐渐增强；同时测试了微米铜粉对红外热像仪的干扰效果，浓度为2.0 g.m-3时，青光铜粉能够完全遮蔽红外热像仪。

High dose copper induced decrease ofⅠ,Ⅱ,Ⅳ-2 content and increase ofⅢof spectrin. High dose copper can also decrease SA, PE content and increase SM, PS content.These showed that high dose can induce injury of erythrocyte by changing elementary structure and moity of membrane protein and membrane phospholipid, which may be one of the mechanisms of goat erythrocyte damage induced by high dose copper. 2. High copper caused the decrease of SOD and GSH-PX activity and the increase of MDA content.

高铜能引起红细胞膜收缩蛋白Ⅰ、Ⅱ及区带Ⅳ-2蛋白含量均显著降低，而区带Ⅲ蛋白含量明显增高，红细胞膜唾液酸含量降低，磷脂酰乙醇胺含量降低，神经鞘磷脂和磷脂酰丝氨酸含量升高，表明高铜能够改变红细胞膜蛋白和磷脂等基本结构和组成成分，这可能是高铜致羊红细胞损伤的机制之一。

We report here on the characterization of copper-plated screen-printed electrodes modified by different clay minerals for the same purpose. The results indicated that clay minerals could improve oxidative and reductive currents of copper through the adsorption of copper ion on the surface of clay minerals. Nontronite showed the largest improvement in reductive currents of copper among the three clay minerals studied.

以不同黏土矿物修饰在镀铜网版印刷电极上进行电化学分析结果指出黏土矿物可促进铜的氧化还原电流量，此增大的部分与铜离子在黏土矿物表面吸附有关，三种黏土矿物中以多铁蒙特石修饰的对铜的还原电流量增加最大。

In these experiments, we have choosen the activated carbon as the support, and copper nitrate, copper acetate and copper sulfate were used as precursors to prepare the supported activated carbon-copper catalysts. Toluene was chosen as pollutant for activity test.

本实验选择活性碳当担体，而前驱物为硝酸铜、醋酸铜、硫酸铜制备金属活性相为铜之触媒，并假设目标污染物为甲苯来进行实验探讨。

The copper anode slime produced in one copper smelter domestically was pre-treated with pressure acid leaching method and the leaching behavior of copper,tellurium and selenium in copper anode slime was studied.

以国内某铜冶炼厂所产的铜阳极泥为原料，采用加压酸浸的方法对该铜阳极泥进行预处理，对铜阳极泥中铜、碲、硒等元素的浸出行为进行了研究。

Since the enhanced contraceptive action of copper-bearing intrauterine device is commonly attributed to copper ions released as a result of copper corrosion, this thesis focused on the investigation of various factors probably affecting the corrosion behavior of copper in the case by in vitro measurements.

为配合各种新型含铜宫内节育器[如含消炎痛VCu IUD、Tcu IUD、γ型IUD及含左旋18-甲基炔诺酮的Cu IUD]的研制与临床应用，探索对避孕起关键作用的铜在各种情况下的腐蚀行为及影响因素，本文对几种新型Cu IUD在宫腔内可能涉及的腐蚀类型及影响因素进行了研究。

The results show that in Cu/Copper-coated graphite composite,the volume density and the electrical conductivity decreased with the increasing of copper-copper-coated graphite,while the graphite in it is fairly well-distributed and the copper helps to form the three dimensional net-shape,thus making the composite have better electrical conductivity than the c...

结果表明，随镀铜石墨含量的增加，铜-镀铜石墨复合材料的密度和导电性降低，但其组织中石墨分布更均匀，并且铜有利于构成三维网状，使该复合材料具有更好的导电性。

Showed that the core business of the western mining for lead, zinc, copper mining and lead, zinc, aluminum smelter, the company is now mainly owned and controlled Xitieshan Lead-Zinc Mine have been the Ada copper polymetallic ore, copper tournament even Tong, Gacun silver polymetallic ore and Yulong Copper Mine.

表明，在西部矿业铅的核心业务，锌，铜开采和铅，锌，铝冶炼厂，该公司目前主要拥有和锡铁山铅锌矿控制一直是阿达铜多金属矿，铜比赛甚至塘，呷村银多金属矿和玉龙铜矿。

The mainly conclusions in our research are as flowing: tungsten trioxide powders with 100 nm primary particle are obtained by spray drying,calcination and wet milling process, and an average size of quadric particle composed of agglomerated particles is 0.64 μm; tungtsen powders with 39 nm grain size and 60 -100 nm primary particle are produced directly from previous tungsten trioxide using one step reduction in hydrogen at 700℃, and an average size of quadric particle of tungsten powder is 2.91 μm; tungsten trioxide and copper tungstate compound powders with 100 nm - 200 nm primary particle are produced using ammonia metatungsten and copper nitrate as raw materials by spray drying,calcination and wet milling process;the compound powders are transformed completely into tungsten and copper compound powders by reduction in hydrogen at 700℃,in which tungsten grain size is 59 nm and copper grain size is 51 nm; primary particle size of compound powders is 80 - 120 nm,and an average size of agglomerated quadric particle is 1.86 μm; tungsten nitride powders with 35 nm grain size are prepared from tungsten trioxide powders by nitrogen treatment thoroughly in pure ammonia at 650℃, and an average size of agglomerated quadric particle is 0.64 μm in normal temperature.

研究结果表明：采用喷雾干燥—焙烧—球磨工艺可以制备出粒度约为100nm的WO_3粉体，它们在团聚后形成的二次颗粒平均粒度为0.64μm；采用一步直接氢还原方法可在700℃下从上述WO_3粉体制备出晶粒尺寸为39nm的、一次颗粒粒度为60-100nm的W粉体，其二次颗粒的平均粒度为2.91μm；以偏钨酸铵、硝酸铜为原料，采用喷雾干燥—焙烧—球磨工艺可制备出一次粒度为100-200nm的WO_3和CuWO_4混合粉体；采用氢还原工艺可在700℃下将这种粉体完全转变为W、Cu复合粉体，其中W的平均晶粒粒尺寸为59nm，Cu的平均晶粒尺寸为51nm；复合粉体的一次颗粒尺寸为80-120nm，在常温下团聚后形成的二次平均粒度为1.86μm；采用纯氨氮化工艺可以在650℃下由WO_3粉体制得WN，其晶粒尺度为35nm，在常温下团聚后的二次平均粒度为6.4μm。

Tianjin, Zhi-xiang Precision Electronics Co., Ltd. is a Taiwanese joint venture. In January 1998 in the mainland to set up Johnson hardware factory in Dongguan, in July 2001 in Kunshan, Jiangsu to establish Ho Li Precision Electronics Ltd., with the market development and customer demand and in December 2006 the establishment of Jinnan District in Tianjin, Zhi-xiang precision Electronics Co., Ltd., mainly engaged in import of beryllium copper, phosphor bronze plate, yellow copper, S301, S304 stainless steel plate, aluminum material, SK5, SK7 high-carbon steel and high-conductivity copper a variety of different materials such as copper metal materials, meanwhile, should customers request a variety of sizes of sub-section, shear processing.

天津志翔精密电子有限公司是一家台商合资企业。1998年1月在大陆东莞设立德昌五金厂，2001年7月在江苏昆山设立合利精密电子有限公司，随着市场的发展与客户的需求与2006年12月在天津津南区设立志翔精密电子有限公司，主要经营进口铍铜、磷青铜板、黄铜板、S301、S304不锈钢板、铝材、SK5、SK7高碳钢及高导电红铜铜等多种不同材质的金属材料，同时，应客户要求可进行各种尺寸的分条、剪切加工。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。