查询词典 cooling

If more than the upper one-third of the medium has acquired a pink color, the medium may be restored once by heating the containers in a water-bath or in free-flowing steam until the pink color disappears and by cooling quickly, taking care to prevent the introduction of nonsterile air into the container.

如果超过上部三分之一的培养基已经呈粉色，可以用以下方法恢复该培养基一次：在水浴锅中或者自由流动蒸气中加热该容器，直至粉色消失，并迅速放凉，须小心防止非无菌空气进入到容器中。

In term of different case. Saturated steam and cooling water can be inputted in the empty roller to adjust speed of roller.

辊筒内部为空心，可以根据使用要求，通入蒸汽或冷却水，用来调节辊筒的温度。

By using simplified diffusion equation,the element diffusion model was built for 12-slab stack cooling process.

根据氢和碳的元素扩散规律，可知板坯堆冷工艺可以促使氢的扩散，但对中心碳偏析影响不大。

This paper analysed the actuilities of reusing the cooling energy in the process of separating sodium sulphate from the brine by refrigeration,and the condition of the refrigeration system.

文摘：分析了冷冻提硝工艺中冷量回收利用的现状和制冷系统工况，提出了使冷量回收利用措施更加合理的思路。

Removal of hardness of cycle-cooling water with sodium aluminate is studied in this paper.

本文以偏铝酸钠处理循环冷却水。

In this paper two cooling equipments are analysised in the temperature falling process of the sodium aluminate concentrate solution ,energy saving mechanism and benefit are discussed and estimated.

针对铝酸钠精液降温过程中的两种降温设备进行了对比分析，并对板式换热器的节能机理和节能效益进行了论述及估算。

The flow parameters, which controlled the heat transfer phenomena in the coolant channel of the piston, are identified; the experimental facilities and program will be established in accordance with the parametric conditions experienced by a real marine diesel engine. The experimental result for the flow within smooth-walled duct under the reciprocating motion will be used as the reference datum to assess the results for the study of heat transfer augmentation. As an attempt to enhance the cooling performance, the ribs will be installed in the coolant channels which flow was orthogonal mode for the piston moving direction. Finally, the results obtained for the tests with heat transfer augmentation devices will be compared with the smooth-walled test results.

本研究计画利用座标转换理论，对受到与往复运动正交方向之流场进行参数分析，建立控制此流场热传性能之参数后，模拟实际船舶主机运转时活塞之冷却情形并进行实验量测，作为评估活塞冷却之基准，然后应用现行已实用於工业界的技术，在与往复运动正交方向之圆形冷却通道中加装凸起物以增加热传效能并予以测量其热传系数及其相关之物理现象，据以讨论此流场受往复力之影响，在周向不同位置之热传情形以及其与平行於往复运动方向之流场的差异。

E, the small-caliber valve welded on the valve to take over Cheng Zhongyi cooling measures.

e中、小口径阀门焊接过程中止回阀宜对阀门采取冷却措施。

E, the small-caliber valve welded on the valve to take over Cheng Zhongyi cooling measures.

e中、小口径阀门焊接过程中宜对阀门采取冷却措施。

The effect of the configuration parameters of sub slot, the distribution of winding's cooling ducts, and the diameter of slot wedge on mass flow rate distribution in radius ducts was presented.

研究副槽结构、转子槽楔出风口直径、转子径向风道布置等对转子径向风道流量分配的影响。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48