查询词典 cooling

Lever Ball Float Steam Traps biggest advantage is not subject to pressure,temperature,cooling water flow fluctuations,continuous drainage,a water that row,the minimum cooling degree 0℃,能使best efficiency heating equipment;lever float steam trap valve seat total in the following level,forming awater seal,no steam leakage;itsPlug Valves minimum working pressure 0.01Mpa,the maximum back pressure rate of≤85%;interior with exhaust,lever float steam traps use the most advanced components as the automatic emptying of diaphragm valves,can automatically exclude non-condensing gas,very sensitive,high quality work and long service life.

杠杆浮球式蒸汽疏水阀的最大优点是不受压力、温度、冷凝水流量波动的影响，连续排水，有水即排，最小过冷度为0℃，能使加热设备达到最佳工作效率；杠杆浮球式蒸汽疏水阀的阀座总处于液位以下，形成水封，无蒸汽泄漏；它的最低工作压力0.01Mpa，最大背压率≤85%；内部带有排气装置，杠杆浮球式蒸汽疏水阀采用最先进的膜盒元件做为自动排空气阀，能自动排除不凝结气体，非常灵敏，工作质量高，使用寿命长。

The electroncooling time value and its dependence on some parameters must beknown in design of the cooler scheme and studies on beam propertiesin a cooler ring because the cooling time characterizes the speed ofcooling. Generally, calculation of the cooling time is based upon thecooling force.

本论文的重点就是从理论上修正了电子冷却力的普遍形式，由此对电子冷却过程进行了计算机模拟，首次解决了冷却时间的理论计算问题。

Based on the fault tree of the cooling water system in asphalt gas decontaminating for carbon calciner,quantified evaluating system of reliability of cooling water system is set up by using of quantified analysis theory of fault tree.

在建立焙烧炉沥青烟气净化系统中冷却水系统故障树的基础上，运用故障树定量分析理论，建立了冷却水系统可靠性定量评价体系，对该系统发生故障的概率作出判断，从而能够及时、合理地确定冷却水系统的状况，以便及时采取应变措施，保持系统可靠运行

The present paper analyzes causes to the breakdown of the wire rod such as the central shrinkage cavity and carbon segregation, surface transverse cracks, harmful structure of bulky pearlite and web shaped carbonide and puts forward a few relevant measures for improvement in the physical product quality and reduction of fracture rate of the wire rod including proper control of the casting temperature,drawing speed, intensity of secondary cooling as well as adjustment of the intensity of control rolling and accelerated cooling and optimization of the drawing parameters.

通过对中心缩孔和碳偏析、表面横裂纹、粗大珠光体或网状碳化物不良组织等引起断丝原因的分析，提出通过合理控制浇注温度、拉速、二冷强度、控轧控冷强度及拉拔工艺参数等措施，改进盘条实物质量，降低断丝率。关键词 SWRH82B/SAE1080；脆断；质量分析；工艺控制

Can be created, and the collinear cooling channel consisting of three associated cooling holes is obtained.

这种智能关联的两洞造成嵌入式之间的关系固体多用直通道。

There are temperature cell and press cell in the colling sleeve, so it can automatically check unusual cases and makes camera automatically secede fire-box under unsual cases, camera be actuated by the lead screw whirl, and the MCS controls the engine turn, then make the lead screw whirl. For protecting the camera cooling sleeve be cooled by double air cooling.

在该系统的冷却套上安装有温度和压力传感器，因而能自动检测出异常情况并使摄相机在异常情况下自动退出炉膛，通过电气控制线路控制电动机的转动带动丝杠旋转从而控制摄像机的进出，为了保护摄像机采用了双重气冷的方式进行冷却。

Regenerative cooling is the most widely used method of cooling a combustion chamber and is accomplished by flowing high-velocity coolant over the back side of the chamber hot gas wall to convectively cool the hot gas liner.

再生冷却是最广泛使用的方法冷却燃烧室和是通过流动的高冷却速度超过回到会议厅一侧的热气体墙convectively冷却热气体班轮。

The purpose of this study is the exploitation of new dedicated outdoor air conditioning system, and use the PLC to control the refrigerant loop to make the same machine to achieve three models: cooling、heating and dehumidify with cooling model.

本研究开发新型独立式外气空调系统，并将程式撰写於可程式控制器来控制冷媒回路使同一台机组下达到三种模式包括︰冷气模式、暖气模式与低温低湿模式。

Comparing with conventional air handling process, the liquid desiccant air-conditioning system can dehumidify air without cooling down to its dew point. Meanwhile, counteraction cooling and heating can be avoided, which usually happened in conventional air handling process and led to huge energy waste. In addition, during the air handling process no condensation water separates out of the air in the liquid desiccant air-conditioning system, thus, avoid fungi thrives in moist environment of traditional air handling process. Not only being applied in dehumidification process in summer, the system can also realize humidification process in winter conditions efficiently.

与传统的空气处理方式相比，采用溶液式空气处理方式，具有如下优越性：取消了冷凝水表面，消除了霉菌等生长所需的潮湿环境；既可以对空气除湿处理，又能实现冬季对于空气的加湿处理过程；可方便调节处理后的相对湿度，不再是常规冷凝除湿方式中接近100%相对湿度的出口空气参数；避免了常规空调系统冷凝除湿后温度过低还需再热带来的冷热抵消问题；可以充分利用低品位能源如太阳能和废热实现溶液再生，节省系统电耗。

The furnace body is made ф2200×1500 the outer covering main body by the 12mm steel plate, lower part the furnace body 45° the installment has the sensor, the sensor orientation silicon steel plate is made the weight 2 ton induction iron cores by Wuhan Steel Corporation Silicon steel plate Factory production top gear's W-151 the cold rolling 0.35m/m, primary is made the water cooling coil by 10×10×2 the copper pipe, and installs the stainless steel water cooling restricting, the power frequency has the core smelting furnace's metal melt fluid namely for the sensor sencondary coil, the entire electric stove is a transformer actually, the necessary 6 grades from the pair regulating transformer, shift gears by the electricity cabinet control, the voltage may from low to high, divide 6 promotions to arrive at 380V, each grade of voltages are different, the output is also different, the furnace temperature along with the files position is also different, but the height is different, adapts smelts colored or the black and so on melting point different metals, and may make the new furnace lining to smelt diamantine drying furnace fireproof.

炉体由12mm钢板制成Ф2200×1500外壳主体，炉体下部45°安装有感应器，感应器由武钢硅钢片厂生产的最高档的W-151冷轧0.35m/m取向硅钢片制成重2吨感应铁心，初级由10×10×2铜管制成水冷线圈，并安装不锈钢水冷保护套，工频有芯熔炼炉的金属熔液即为感应器的次级线圈，整个电炉实际就是一个变压器，配套一台6档的自耦调压变压器，由电柜控制换档，电压可由低到高，分6级升到380V，每档电压不同，输出功率也不同，炉温也随档位不同而高低不同，以适应熔炼有色或黑色等熔点不同的金属，并可作新炉衬耐火冶金砂烘炉之用。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。