英语人>网络例句>cooling water 相关的网络例句
cooling water相关的网络例句

查询词典 cooling water

与 cooling water 相关的网络例句 [注:此内容来源于网络,仅供参考]

The cooling system is more suitable for the purpose of: heat recovery and forced-air cooling, water cooling has high specific heat capacity, it stores a lot of heat energy, have higher density.

水冷系统更适合热回收的目的:与风冷相比较,水冷具有较高的比热容量,它存储了大量的热能,有较高的密度。

The plate wet air cooler combines the technical advantages of plate heat exchangers with dry cooling and evaporative cooling. When hot climates in summer, water spraying runs and outlet temperature of hot fluids plays down because heat transfer is enhanced by evaporative cooling.

板式湿式空冷器结合了空冷、蒸发冷却与板式换热器的技术优点,在夏季气温较高时,启用喷淋装置湿工况运行,采用喷淋水蒸发冷却强化空冷器换热以达到降低工艺流体出口温度的目的。

They are generally two different types of cooling system:water-cooling system and air-cooling system.

他们通常是二个不同的类型冷却系统:水-冷却系统和空气-冷却系统。

The resultsillustrated that the cooling effect of water-cooling and oil-cooling was not very good.

在该实验平台上对水外冷和油冷作了大量的实验,实验结果表明水外冷和油冷的冷却效果不是很好。

The cooling capability of water-cooling and oil-cooling was small and the currentdensity of the stator winding was low.

水外冷和油冷的最大冷却能力比较小,定子绕组的最大电流密度也比较低。

The result shows that the cooling capacity increases with increasing generator heat transfer. The coefficient of performance of the system increases when the quantity of the generator heat transfer is increased from 6 kW to 7 kW, however it decreases in the range of 7 kW-9 kW. When the fan frequency increases, the temperature of liquid ammonia leaving condenser decreases, while the cooling capacity and the COP of the system increases. When the flow rate and inlet temperature of water/glycol increases, the evaporator takes more heat away and the cooling capacity and COP of the system increases.

其结果可发现当发生器加热量增加,系统温度增加系统冷冻能力增加,但其COP於6 kW-7 kW 系统COP会有先增加,於7 kW-9 kW,系统COP会有下掉的趋势;在冷凝器方面,当风扇频率增加,冷凝器温度降低时,冷凝器出口冷媒随之降低,系统冷冻能力会有所提高,COP亦增加;在蒸发器方面,蒸发器卤水出口温度及卤水流量增加,可以使蒸发器带走更多的热量其系统冷冻能力及COP也就会相对增加。

The preparative technique of solid lubricant is cold-press sintering method.The micro-structure , friction surface, lubricant transfer film surface of base material was characterized by SEM; XRD was used to do phase analysis. The degrees of crystallinity of pure PTFE under the different conditions of water cooling, air cooling and furnace-varying cooling were made comparison by XRD. The thermal stability of pure PTFE and solid lubricant was analyzed by DSC-TG; The composition and valence state of elements in the surface of carbon fiber ,solid lubricant before and after friction test and lubricant transfer film were characterized by XPS; The frictional property of solid lubricant was tested by pin and disk test rig .

用SEM表征原料微观结构、摩擦表面及润滑转移膜表面形貌:用XRD进行原料物相分析,及比较水冷却、空气冷却、随炉冷却三种工艺条件下的纯聚四氟乙烯树脂的结晶度;用DSC-TG分析纯聚四氟乙烯树脂及固体润滑剂的热稳定性;用XPS表征碳纤维表面、固体润滑剂摩擦前后表面、润滑转移膜表面的元素组成、价态变化;用销盘式摩擦磨损试验机对固体润滑剂进行摩擦性能测试;采用专用的台架模拟试验机对固体润滑剂镶嵌轴承套与钢轴摩擦副间的摩擦磨损性能进行测定;用莱次偏光显微镜测试固体润滑剂的硬度;用材料试验机测试固体润滑剂的抗压强度等。

Main contents of the thesis are as follows: Description of the present usage of liquid cooling system, presentation of a new type of liquid cooling system and description of its work principles; Design of the liquid cooling system, which mainly deals with the design and collating calculating of serpentine condenser and heat exchangers adopted in this system. Meanwhile, the model chosen calculating of compressor、thermal expansion valve、plate evaporator、water pump and the like equipment used in the system are also carried out.

本文的主要内容如下:对液冷源使用现状进行了描述,提出了一种新型液冷源系统并对其工作原理进行了阐述;对系统进行了设计,主要对系统中所采用的管带式冷凝器和水侧空/液换热器进行了设计和校核计算,同时对系统中所用到的压缩机、热力膨胀阀、板式蒸发器、水泵等配套设备进行了选型计算;分别对制冷系统和冷却液循环系统进行了数学建模。

Airflow passes radiator core at high speed from front to rear to accelerate cooling of the coolant water flowing across the radiator core, thus enhancing cooling effect of the cooling system to the engine.

空气流由前向后高速通过散热器芯,使流经散热器芯的冷却水加速冷却,从而加强了冷却系对发动机的冷却作用。

When Carp vehicle fuel economy stick to the running car engine cooling system of water tanks (also called the "expansion of the pot"), after the car in a moving process, the engine heat and heat transfer to the cooling liquid, heating and cooling liquid Carp Festival Oil rods in the "Bioglass" play a role and have a lot of negative ions, with a lot of negative ion engine coolant along the cylinder piston and the cylinder head outer space waterways cycle, formed around the cylinder piston engine of the electromagnetic field.

当卡普汽车节油棒投放到汽车发动机冷却系统副水箱里后,汽车在行驶过程中,发动机发热并将热量传递给冷却液,受热的冷却液与卡普节油棒中的&Bioglass&发生作用并产生大量的负离子,充满大量负离子的冷却液沿着发动机活塞缸体和缸盖外壁的水道空间循环,形成环绕发动机活塞缸的电磁场。,发动机活塞缸中的混合燃料气体在这种电磁场作用下,形成阿萨卡瓦效应,燃烧增强、爆发力增大、燃烧效率提高,从而降低汽车燃料消耗、提高发动机动力、显著减少尾气排放。

第7/500页 首页 < ... 3 4 5 6 7 8 9 10 11 ... > 尾页
相关中文对照歌词
40 Water
Cooling
Hot Water Burn Baby
Wade In The Water
Cool Cool Water
Water Whippin'
I Go Swimming
Water
Water
Wade In The Water
推荐网络例句

But this is impossible, as long as it is engaging in a market economy, there are risks in any operation.

但是,这是不可能的,只要是搞市场经济,是有风险的任何行动。

We're on the same wavelength.

我们是同道中人。

The temperature is usually between 300 and 675 degrees Celsius.

温度通常在摄氏300度到675度之间。