查询词典 cooling system

Be different from the incrustation,the growth region of sludge can proliferate the surface of the cooling water system contanting water.Even on the edge position such as the feeding air compatment and water collector of the cooling tower the sludge also grows.

和水垢不同，污泥生长的区域可以遍布在所有和水接触的冷却水系统的表面上，即使在很边缘的部位如冷却塔的送风室和收水器也会有污泥生长。

In order to investigate the effect of cooling nonsolvent on the membrane preparation via TIPS, EVOH/PEG300 system was chosen and two kinds of cooling nonsolvent were used.

选择EVOH/PEG300体系，研究并讨论了不同的冷却介质对膜结构和结晶性能的影响。

This study is focusing what the variation of cooling coils pipe pitch and deposit direction, which will affect the temperature distribution of the epitaxy produce zone for rotation dick type of MOCVD system, the cooling coils is at the bottom of the reaction chamber. In other, we also consider what the different if they has exhaust device at reaction chamber too.

本研究主要是对转盘式有机金属化学气相磊晶系统反应腔底部冷却管排之管排间距或摆置方位等之变化，对磊晶工件区之温度分布影响；同时，也对冷却管排底下空间中亦做若有抽气时之温度分布差异分析。

Under normal conditions,one cooling water pump and one heat exchanger of closed-circuit cooling water is satisfiable for the requirements of the overall system.

正常情况下一台冷却水泵和一台闭式循环冷却水热交换器可满足整个系统所需的冷却水量，夏季需投运2台冷却水换热器满足机组运行要求。

The cooling load of air-conditioning system is a nonlinear model with dynamic and indeterminacy.The traditional way is difficult to predict cooling load to a nicety and celerity.

空调系统负荷是一个典型的具有动态性、不确定性等随机特性的非线性模型，传统方式难以实现准确、快速地预测空调系统动态负荷。

The purpose of this study is the exploitation of new dedicated outdoor air conditioning system, and use the PLC to control the refrigerant loop to make the same machine to achieve three models: cooling、heating and dehumidify with cooling model.

本研究开发新型独立式外气空调系统，并将程式撰写於可程式控制器来控制冷媒回路使同一台机组下达到三种模式包括︰冷气模式、暖气模式与低温低湿模式。

The result shows, the optimized design hold shorter investment recoveryperiod, larger NPV value and higher energy utility than the design that is planed onlyby experience, under sufficing the same cooling, heating and power load, this method is all-purpose for design of system for combined heat, cooling and power based ongas turbine.

结果表明：在满足相同冷热电负荷的情况下，优化模拟后得到的设计方案较单纯以经验确定负荷的设计方案有更高的NPV值，更短的投资回收期，且前者较后者有更好的能源利用率，优化模拟对基于燃气轮机的三联供系统设计有很好的普适性。

The result shows, the optimized design hold shorter investment recoveryperiod, larger NPV value and higher energy utility than the design that is planed onlyby experience, under sufficing the same cooling, heating and power load, this methodis all-purpose for design of system for combined heat, cooling and power based ongas turbine.

结果表明：在满足相同冷热电负荷的情况下，优化模拟后得到的设计方案较单纯以经验确定负荷的设计方案有更高的NPV值，更短的投资回收期，且前者较后者有更好的能源利用率，优化模拟对基于燃气轮机的三联供系统设计有很好的普适性。

The atomizing set takes advantage of the condensing water and external water, and atomizes them and sprays them to the surface of the condenser and refrigerator to degrade the condensing temperature and pressure, The system changes the single wind-cooling into mixed-cooling and tremendiously degrades the condensing temperature and pressure, decreases the high and low differential pressure of compressor, degrades frequent startup and operation is difficult.

空调雾化器该雾化节能装置是利用冷凝水或经过水处理后的外接水将其雾化，并将水雾喷洒到空调器或冷库冷凝器表面，使空调器或冷库单一的风冷变成风冷和雾化水冷却的混合式冷却，从而大大降低冷凝器的冷凝温度和冷凝压力，减少压缩机的高低压差，降低了压缩机由于高温保护造成跳机频繁或启动困难的现象，不仅增加了压缩机使用寿命，而且对空调器有显著的节能效果——制冷量增加，输入功率减少。

In accordance with the problems such as lower cooling effect and corrosion of the water treatment of the cooling water system of ammonia condenser ,the water treatment program of the water quality was optimized,and the water treatment effect before and after the program were summarized.

针对氨冷凝器冷却水系统水处理存在的冷却效果差和腐蚀问题，提出水质处理的优化方案，总结了优化前后的水处理效果，结果表明：使用新方案后，氨冷凝器的冷却效果得到明显的改善，冷凝排气压力降低，氨排压4机运行时为1。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。