查询词典 cooling system

Process water cooling with open circuit is designed Two indrirect circulating systems are used, of which BF circulating system with flow rate of 1,900 t/h for BF proper and 600 t/h for stove HP circulating system used for cooling of tuyere and small cooler of cinder notch with flow rate of 330 t/h 1.2.1.4 BF structure The 450 m3 blast furnace is of stand free type with steel frame structure for supporting of 5 platforms and the skip bridge.

过程中的冷却水与开放电路设计两个indrirect系统循环使用，其中高炉循环水系统与流量1900吨/小时正确高炉和600吨/小时炉惠普循环系统用于冷却风口和小凉煤渣缺口流速为330笔/小时 1.2.1.3高炉结构 450 m3高炉是站在自由型钢架结构为支撑平台5和跳过大桥。

The optimized cooling circulation system improves flow velocity and rate of cooling water, strengthen the cooling effect.

优化设计冷却循环，提高冷却水的流速和流量，增强冷却效果。

Results show that the cooling capacity and the COP of the system vary with the variation of the operation conditions;system faults such as solution crystallization,overhigh working pressure, freezing of cooling water or chilled water will be caused if the variation of the operation conditions is out of range.

计算结果表明：系统的制冷量和COP随运转条件的变化而变化；运转条件的变化需要控制在一定范围内，否则将引发溶液结晶、工作压力过高、冷剂水或冷冻水结冰等系统故障。

Thermal comfort and indoor air quality requirements are presented; the contents cover the following topics:(1) Concept of air-conditioning,(2) Thermal principle,(3) Psychrometry and wetted-surface heat transfer,(4) Heating and cooling-load calculations,(5) Air-conditioning systems,(6) Fan and duct system,(7) Pumps and piping,(8) Cooling and dehumidifying coils,(9) Air-conditioning controls,(10) Absorption refrigeration,(11) Heat pump,(12) Cooling towers and evaporative condensers.

课程大纲本课程将介绍空调工程与系统设计，藉由湿空气线图讨论空气调节之过程，分析人体舒适与空气品质之需求，及各种空调设备系统之设计，内容涵盖如下：(1)空调的概念(2)热原理(3)湿空气与湿表面热传(4)加热与冷却负荷估算(5)空调系统(6)风扇与风管系统(7)泵与管路配置(8)冷却与除湿盘管(9)空调自动控制(10)吸收式冷冻系统(11)热泵(12)冷却水塔与蒸发式冷却。

The water chamber takes the shape of tilting cube, in favor of uniform distribution of cooling water on tube plate surface. The tube bundle is divided into two groups of zygomorphy according to the bisection system and it has eight support clapboards. The siphonopore center of each clapboard increases a certain distance corresponding to that of two tube plates and the cooling tube takes the shape of arch. The two-way cooling water of bisection flows through the condenser in opposite direction so as to improve the distribution of heat load for tube bundle. Around the throat of condenser, the final stage low-pressure heater, air extraction tube, intake device of bypass exhaust and the like are deployed.

它的特点是：水室呈倾斜立方体形状，有利于冷却水流在管板面上均匀分布；由于采用对分制，管束相应地分为左、右对称的两组，并且管束设有八块支撑隔板，每块隔板的管孔中心相对于两端管板的管孔中心依次抬高一定的距离，以使冷却管呈拱形状；对分制的两路冷却水以相反方向流过凝汽器，从而改善管束的热负荷分布；在凝汽器喉部布置了末级低压加热器，抽汽管道及旁路排汽接受装置等。

The gear box of Goldwind(750kW) set is based on taking enough experience from Goldwind(600kW), takes big flux cooling lubrication system to guarantee each bearing and toothing gear can get sufficient lubrication and cooling at any working time, the filtrating system has doubt filtrating fiction, has big capacity to take dirty dust, even if the main filtre is blocked, it can supply sufficent lubricant oil by backup filtre.

润滑金风750kW机组的齿轮箱在充分吸取600kW机组经验的基础上，采取大流量润滑冷却系统以保证每个轴承和啮合轮齿都随时得到充分的润滑和冷却，过滤系统具有双重过滤功能，纳圬容量大，即使在主过滤器被堵塞情况下，油仍能通过备份滤芯向系统提供清洁足量的润滑油。

The gear box of Goldwind(750kW) set is based on taking enough experience from Goldwind(600kW), takes big flux cooling lubrication system to guarantee each bearing and toothing gear can get sufficient lubrication and cooling at any working time, the filtrating system has doubt filtrating fiction, hasbig capacity to take dirty dust, even if the main filtre is blocked, it can supply sufficent lubricant oil by backup filtre.

润滑 金风750kW机组的齿轮箱在充分吸取600kW机组经验的基础上，采取大流量润滑冷却系统以保证每个轴承和啮合轮齿都随时得到充分的润滑和冷却，过滤系统具有双重过滤功能，纳圬容量大，即使在主过滤器被堵塞情况下，油仍能通过备份滤芯向系统提供清洁足量的润滑油。

At present, many foreign countries use low-level mold casting, its aim is to improve the cooling intensity, to reduce or eliminate a cooling air gap zone heating phenomenon, it is virtually non-existent secondary cooling of the quenched situation, ordinary flat ingot casting has been the crystallization of height reduced to 100 people, of course, this has required the operator to operate a high level or additional level of white dynamic control system.

目前，许多外国国家使用低级别的模铸造，其目的是提高冷却强度，以减少或消除地区差距的冷却空气加热的现象，几乎是不存在的二次冷却淬火的情况，一般小锭铸造一直减少到100人，当然，高度结晶，这需要经营者经营的高层次或白色的动态控制系统的额外的水平。

Making use of evaporative cooling technology for stator coil, static liquid level of system is not higher than stator line bar, also not lower than 2/3 of line bar beeline segment; when both copper ring down-lead and main lead-out line also adopt evaporative cooling method, static liquid level of system shall be prescribed by manufacturer in technical documentations.

6.1.3.4蒸发冷却系统液位要求定子绕组采用蒸发冷却技术时，系统静态液位不高于定子线棒，也不低于线棒直线段的2／3；当铜环引线和主引出线也为蒸发冷却方式时，系统静态液位要求由制造厂在技术文件中规定。

Center air-condition system is normally composed of refrigeration, freezing water system, cooling water system, cooling tower, terminal facility and fresh wind engine.

中央空调系统通常由制冷主机、冷冻水系统、冷却水系统以及冷却塔、末端设备、新风补充风机等组成。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷