查询词典 cooling duct

Feed water tank in Boiler House b. Cooling Tower basin of Solvent Extraction Plant c. Cooling Tower basin of Refinery d. Overhead water tank through the water treatment plant.

饲料水箱在锅炉房湾冷却塔盆地溶剂萃取植物角冷却塔盆地炼油 4高架水箱通过污水处理厂。

Using FT age combined with results of multiple diffusion domain model of K feldspars a slow cooling process among 150～110℃ and cooling velocity of 3.4～9.5℃/Ma are obtained.

结合已有的钾长石多重扩散域模式结果，得到该段150℃至110℃温度范围的冷却过程（冷却速度为3.4～9.45℃／Ma）。

Since ventilation and evaporative cooling are the primary means for temperature adjustment in the duck house, a relationship for the traveling distance of water particles under various thermal environment was first established. This allows for the evaluation of efficiency of foggers for evaporative cooling. The relationship was then incorporated into a mathematical model based on the energy and mass conservation principle to simulate the transient change of outdoor temperature and humidity.

由於通风与喷雾降温为调节半开放式鸭舍内温度的主要方法，首先我们推导出雾粒在完全蒸发前移动距离与热环境条件的方程式，以计算於不同热环境条件下，不同大小雾粒的蒸发比率，从而评估喷雾降温的效率；次而利用质能平衡原理建立鸭舍内喷雾降温热环境模式，以计算及预测鸭舍内受外界热环境影响而产生的温湿度变化。

Hardness of malleable cast iron decreases with the increase of Si content after cooling and water quenching; while the hardness increases with the increase of Si content after furnace cooling and oil quenching.

在空冷和水淬后，可锻铸铁的硬度随硅含量的增加而降低；在炉冷和油淬后，可锻铸铁的硬度随硅含量的增加而升高。

To achieve the same final cooling temperature at constant cool-down different laminar cooling patterns play important roles in the cool-down rate along plate gauge and temperature distribution.

同等冷却速度下，为了达到相同的终冷温度，不同的层流冷却方式对中厚板厚度方向的冷却速度和温度分布产生重要的影响。

Q235 and 20MnSi billets are tested to produce BS 460MPa grade reinforced bar with postrolling residual heat treatment process. Influences of water-cooling stage, water pressure, the temperature at the entrance of cooling bed, compositions, steel grade and ageing on reinforced bar properties are studied.

以Q235、20MnSi钢坯为原料进行了用余热处理工艺生产英标460MPa级钢筋的试验，研究了水冷段数、水压、上冷床温度以及成分、钢种和时效对钢筋性能的影响。

The results show that BS 460MPa grade reinforced bar can be produced all from Q235 or 20MnSi billet by the remained heat treatment process but the production cost of the former is lower. When the water pressure minishes, the intensities of reinforced bar reduce; the higher the temperature at the entrance of cooling bed is, the lower the intensities are. Therefore, the commendatory process parameters are that five stages coolers should be opened, water pressure should be all 1.8～2.0MPa and the temperature at the entrance of cooling bed of Q235 reinforced bar should lower than 650℃. The typical microstructure(Q235): the surface layer is tempered sorbite; the transition layer is pearlite and ferrite, and the partial ferrite is acicular; the core is pearlite and ferrite and the grain fineness is 8～10 grade. The yield strength is reduced by 10～20MPa after natural ageing and it can be simulated by artificial ageing(100℃×2h or 200℃×1h).

结果表明，Q235和20MnSi钢都可以利用余热处理工艺生产出性能合格的钢筋，但前者的生产成本较低；水压减小，钢筋强度降低，上冷床温度越高，强度越低，推荐5段水冷器全开，水压均为1.8～2.0MPa，Q235钢筋的上冷床温度应控制在650℃以下；钢筋典型的金相组织（Q235）表层为回火索氏体，过渡层为珠光体+铁素体且部分铁素体呈针状，心部为珠光体+铁素体，晶粒度8～10级；自然时效后屈服强度下降10～20MPa，用人工时效可以模拟自然时效，工艺是100℃×2h或200℃×1h。

The kernel of the idea is that CPMJI that involves two-phase heat convection, jet impinging and full vaporization is used to enhance the heat transfer potential of cooling medium and obtain the best cooling effect.

该方法的核心是利用低温喷雾射流冲击的低温气液两相射流冲击和充分汽化的强化换热优势，充分发挥冷却介质的换热潜力以获得绿色高效的冷却效果。

The desired cooling rate was achieved by simultaneously adjusting the cooling rate of argon-jet through the inner induction heating copper coil and the output power of the high-frequency generator controlled by the computer.

理想的冷却速度是通过同时调整冷却速度氩射流通过内铜线圈感应加热和输出功率高频率发生器所控制的计算机。

The investigation focused on the parameters affecting cooling effectiveness, including: opening ratio, height of ripple board, diameter of holes and height of cooling passage.

研究隔热屏的四种结构参数开孔率、波纹板高度、孔径和冷却通道高度的改变对隔热屏冷却效果的影响。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。