查询词典 cooling by means of air

In view of the cooling water temperature difference in central air conditioning systems typically setting at 5℃,from the visual angle of economic and technology,establishes mathematical models to analyse the effect of the cooling water temperature and temperature difference on primary and operating costs of the cooling water systems.

针对目前集中空调系统冷却水温差大多采用5℃的情况，从经济技术的角度出发，以集中空调冷却水系统为研究对象，建立了冷却水温度与温差对冷却水系统各部分成本的影响的数学模型。

Carlos CAROSS commonly used air-conditioning modules from the basic cooling capacity 18KW to 200KW, with a single module and dual cooling system cooling system module.

卡洛斯CAROSS空调的常用基本模块从18KW到200KW制冷量，有单制冷系统模块和双制冷系统模块。

Holds that the air volume under the wet cooling condition should be taken as an assessment criterion in stead of that when dry cooling, that the fin pitch of the coil pipe should be optimised to keep proper cooling capacity, and that the number of water passages should be doubled to reduce the resistance within the limits stipulated in the standard and to improve the heat transfer conditions.

认为应以湿工况风量作为对风机盘管机组的考核标准，应合理确定盘管肋片的片间距以保证表冷器的供冷量，应改进水路结构，降低水阻力。

The cooling system is more suitable for the purpose of: heat recovery and forced-air cooling, water cooling has high specific heat capacity, it stores a lot of heat energy, have higher density.

水冷系统更适合热回收的目的：与风冷相比较，水冷具有较高的比热容量，它存储了大量的热能，有较高的密度。

The plate wet air cooler combines the technical advantages of plate heat exchangers with dry cooling and evaporative cooling. When hot climates in summer, water spraying runs and outlet temperature of hot fluids plays down because heat transfer is enhanced by evaporative cooling.

板式湿式空冷器结合了空冷、蒸发冷却与板式换热器的技术优点，在夏季气温较高时，启用喷淋装置湿工况运行，采用喷淋水蒸发冷却强化空冷器换热以达到降低工艺流体出口温度的目的。

Based on the air-conditioning properties of radiation cooling with evaporative cooling, the precise distribution of moisture and cooling load is carried out using psychrometric chart.

根据蒸发冷却和辐射供冷的热湿处理空调特性，利用焓湿图分配其热湿负荷。

The water chamber takes the shape of tilting cube, in favor of uniform distribution of cooling water on tube plate surface. The tube bundle is divided into two groups of zygomorphy according to the bisection system and it has eight support clapboards. The siphonopore center of each clapboard increases a certain distance corresponding to that of two tube plates and the cooling tube takes the shape of arch. The two-way cooling water of bisection flows through the condenser in opposite direction so as to improve the distribution of heat load for tube bundle. Around the throat of condenser, the final stage low-pressure heater, air extraction tube, intake device of bypass exhaust and the like are deployed.

它的特点是：水室呈倾斜立方体形状，有利于冷却水流在管板面上均匀分布；由于采用对分制，管束相应地分为左、右对称的两组，并且管束设有八块支撑隔板，每块隔板的管孔中心相对于两端管板的管孔中心依次抬高一定的距离，以使冷却管呈拱形状；对分制的两路冷却水以相反方向流过凝汽器，从而改善管束的热负荷分布；在凝汽器喉部布置了末级低压加热器，抽汽管道及旁路排汽接受装置等。

They are generally two different types of cooling system:water-cooling system and air-cooling system.

他们通常是二个不同的类型冷却系统：水-冷却系统和空气-冷却系统。

At present, many foreign countries use low-level mold casting, its aim is to improve the cooling intensity, to reduce or eliminate a cooling air gap zone heating phenomenon, it is virtually non-existent secondary cooling of the quenched situation, ordinary flat ingot casting has been the crystallization of height reduced to 100 people, of course, this has required the operator to operate a high level or additional level of white dynamic control system.

目前，许多外国国家使用低级别的模铸造，其目的是提高冷却强度，以减少或消除地区差距的冷却空气加热的现象，几乎是不存在的二次冷却淬火的情况，一般小锭铸造一直减少到100人，当然，高度结晶，这需要经营者经营的高层次或白色的动态控制系统的额外的水平。

Changes of the level of thermal environment reduce cooling load effectively in case of the all-air cooling system while the radiation-panel system does not reduce cooling load even though the targeted thermal condition is relaxed.

在热环境水平发生变化时，采用全空气制冷系统可有效降低制冷负荷；而采用辐射板制冷系统时，即使目标热环境已经放宽，也不能降低制冷负荷。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48