查询词典 cooling by means of air

The furnace body's ф2200×1500 outer covering main body is made of 12mm steel plate,installed sensor in the lower part 45°of furnace body, the sensor is weight 2 ton induction iron cores made from top gear's W-151 the cold rolling 0.35m/m made by Wuhan Steel Silicon steel plate Factory, primary manufactured the water cooling coil from 10×10×2 copper pipe, and installed stainless steelwater cooling cover, the power Frequency Induction melting Furnace 's metal melting fluid namely the sensor sencondary loop, the entire electric furnace is a transformer actually, match a 6 grades self regulating transformer, shift gears by the electric tank control, the voltage may from low to high,divide 6 grade to rise to 380V, each grade of voltage is different, the output power is also different, the furnace temperature is also different along with different grade,so can suit smelting colored or black and so on different melting point metals, and may use as new furnace lining fireproof to smeltdiamantine drying furnace.

炉体由12mm钢板制成Ф2200×1500外壳主体，炉体下部45°安装有感应器，感应器由武钢硅钢片厂生产的最高档的W-151冷轧0.35m/m取向硅钢片制成重2吨感应铁心，初级由10×10×2铜管制成水冷线圈，并安装不锈钢水冷保护套，工频有芯熔炼炉的金属熔液即为感应器的次级线圈，整个电炉实际就是一个变压器，配套一台6档的自耦调压变压器，由电柜控制换档，电压可由低到高，分6级升到380V，每档电压不同，输出功率也不同，炉温也随档位不同而高低不同，以适应熔炼有色或黑色等熔点不同的金属，并可作新炉衬耐火冶金砂烘炉之用。

By restricting accumulation of negative integral elements when performing integration by a proportional integral control unit until the actual temperature of a cooling target fluid reaches the corresponding target temperature, the method having this feature enables the control of the fan revolution speed so that the fan revolution speed rises immediately when the actual temperature of the cooling target fluid exceeds the target temperature.

通过限制积累负积分元素时，表演融合，由比例积分控制单元，直到实际温度冷却液指标达到相应的目标温度，该方法具有这项功能可控制风扇转速，使风扇转速立即上涨时，实际温度的冷却液指标超过目标温度。

Based on cooling condition,considering potential heat of phase transformation,the temperature field of lap joint and non-lap joint of high carbon steel wire on STELMOR cooling line are calculated.

根据高碳钢线材的冷却条件，考虑了相变过程的相变潜热，计算出线材搭接点与非搭接点在斯太尔摩冷却线上的温度分布，计算结果与实测结果吻合较好。

Trans-Blot Plus Cell 170-3990 Trans-Blot Plus Cell With Plate Electrodes and Super Cooling Coil, includes 3 gel holder cassettes, buffer tank, lid with power cables, 6 fiber pads, 1 pack blot absorbent filter paper (26.5 x 28 cm, 30 sheets), roller, stirbar 170-3991 Trans-Blot Plus Cell and PowerPac HC Power Supply Accessories 170-3994 Trans-Blot Plus Gel/Cassette Assembly Tray 170-3995 Fiber Pads, 27 x 28.5 cm, 2 170-3996 Blot Absorbent Filter Paper, 26.5 x 28 cm, 60 sheets 170-3997 Stirbar 170-3998 Trans-Blot Plus Roller, 6 wide 170-39 Trans-Blot Plus Gel Holder Cassette With Clamps 170-4990 Trans-Blot Plus Super Cooling Coil 170-4991 Trans-Blot Plus Platinum Anode Plate Electrode 170-4992 Trans-Blot Plus Stainless-Steel Cathode Plate Electrode 170-4995 Trans-Blot Plus Cell Buffer Tank 170-4996 Trans-Blot Plus Cell Lid With Cables 170-4997 Gel Holder Cassette Clamps, for Trans-Blot Plus cell, set of 3 9 规格:说明:运用Mini-PROTEAN II 多道筛选仪,可以快速有效地筛选 40 种不同的抗体或血清,无需把western

转印条件可调，能在很大的分子量跨度上获得最佳转印效果*耐用的板式电极能产生强大而均一的电场，而且电极在槽内的位置灵活可换；不论运行1、2 或3 个转印夹，电极间距可调节到最小以获得最大的场强和转印效率*凝胶支架转印夹保证整个凝胶与印迹膜表面的均衡接触*转印夹的铰链设计能防止凝胶滑动，便于转印夹组装*颜色标记的转印夹及电极板确保在转印槽内的正确定向*特级冷却芯和冷却水循环器进行温度调节―可理想地用于天然酶或高强度转印，或用于延长转印时间时减少缓冲液的损耗*可选择的组装盘是凝胶三明治和转印夹组装的理想选择 Trans-Blot Plus 转印槽能从单向和双向大格式凝胶上均一、高效地转移蛋白―配合使用新推出的 PowerPac HC 电源，多数蛋白都可在1530 分钟内完成转印。

The effects of casting temperature, casting speed and intensity of cooling water on microstructure are investigated. The results show that when the casting temperature, casting speed and intensity of cooling water are 710 ℃, 100 mm/min, 0.05 m 3/min respectively, the micros...

结果表明，铸造温度为710℃，铸造速度为100mm/min，冷却水强度为0.05m3/min时的低频半连续铸锭组织均匀细小，呈现近球形，边部和中间部位的晶粒大小差别较小，其平均晶粒尺寸分别为28μm和29μm。

An improvement on the die casting technology of aluminium hub includes drilling hole at the position of die, where the function of die is not affected, for preventing gas from coming into molten aluminium, mounting safety valve to the exhaust opening of die casting case for keeping proper pressure to save electricity and shorten die casting time, and increasing the water-flowing area of cooling disk or ring for higher cooling effect.

一在不影响模具本身功能部位钻孔增加排气通道，解决了压铸过程中产生的气体进入铝水问题。可使铝轮减少气孔。在压铸机箱体排气口部位，安装安全阀，能使压铸机箱体内保持适当的压力，工作时少进气、少排气，起到节电不堵浇口，缩短压铸时间，提高产量。冷却盘、冷却环改进后，增加了过水面积，提高了冷却效果。

The influence of cooling conditions on the quality and metallurgical properties of sinters was studied in lab.The results show,that the heat preservation cooling is the best.

通过实验室体系研究了不同的冷却制度对烧结矿质量以及冶金性能的影响，对比分析结果表明，采用保温冷却综合效果最好，在冷却过程中采用变风量冷却对于提高烧结矿成品率有利。

My company is bell south Nanchang Chemical Industry Ltd. unit (formerly JMC Chemical Industry Co., Ltd.) Our main products are: 1, vehicle vibration damping pad and insulation film series, mainly used in cars, driving from alternate space hot, noise, the role of shock absorber; 2, metal coating pre-treatment agent series, including series in addition to oil, rust agent, phosphating agent; 3, automobile radiator coolant advanced series, for the liquid cooling type internal combustion engine cooling system, from antifreeze, anti-boil, corrosion resistance, the usefulness of scale; 4, the company has other products: paint remover, anti-rust oil, cutting coolant, PVC sealant, aluminum chemical conversion agent, paint mist coagulant , waste water treatment agent. 5, ethylene glycol, such as the sale of chemical raw materials, cheap, quality assurance.

我公司是南昌南铃化学工业有限公司下属单位（原江铃化学工业有限公司）公司主要产品有：1、汽车用阻尼隔热垫和减振胶片系列，主要用于汽车、驾乘空间起隔热、隔音、减震的作用；2、金属涂装前处理剂系列，包括系列除油剂、除锈剂、磷化剂等；3、汽车用高级水箱冷却液系列，用于液冷式内燃机冷却系统，起防冻、防沸、抗蚀、阻垢的功用；4、公司其它产品有：脱漆剂、防锈油、切削冷却液、PVC密封胶，铝材化学转换剂，漆雾凝聚剂，废水处理剂等。5、公司出售乙二醇等化工原料，价格便宜，质量保证。

The main products are: 1, 2 cooling pipe adjustable plastic, metal cooling pipe 3, machine tool companies annex the raw materials used in the production of new imported materials, and advanced production technology and products fashionable and varied colors, complete specifications, a large number The inventory.

公司生产所用的原料属全新进口料，加上先进的生产工艺，产品款式新颖，颜色多样，规格齐全，大量的库存。

On the instrument cabinet, there is power switch, start switch, stop pushbutton, main engine exhaust thermometer, lub oil pressure gauge, lub oil thermometer, cooling water thermometer, main engine revolution indicator, starting battery voltmeter, cooling water high temperature and lub oil low pressure alarm device; beside the gear box, there is working oil pressure gauge, lub oil thermometer, lub oil low pressure alarm , working oil low pressure alarm and lub oil high temperature alarm.

本船主机有机带控制报警仪表箱，仪表箱上设有电源开关、启动开关、停车按钮、主机排气温度表、滑油压力表、滑油温度表、冷却水温表、主机转速表、启动蓄电池电压表、冷却水高温及滑油低压报警装置；齿轮箱机旁配工作油压力表、滑油温度表、滑油低压报警、工作油低压报警及滑油高温报警。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。