查询词典 cooling by means of air

The cooling capability of water-cooling and oil-cooling was small and the currentdensity of the stator winding was low.

水外冷和油冷的最大冷却能力比较小，定子绕组的最大电流密度也比较低。

The result shows that the cooling capacity increases with increasing generator heat transfer. The coefficient of performance of the system increases when the quantity of the generator heat transfer is increased from 6 kW to 7 kW, however it decreases in the range of 7 kW-9 kW. When the fan frequency increases, the temperature of liquid ammonia leaving condenser decreases, while the cooling capacity and the COP of the system increases. When the flow rate and inlet temperature of water/glycol increases, the evaporator takes more heat away and the cooling capacity and COP of the system increases.

其结果可发现当发生器加热量增加，系统温度增加系统冷冻能力增加，但其COP於6 kW-7 kW 系统COP会有先增加，於7 kW-9 kW，系统COP会有下掉的趋势；在冷凝器方面，当风扇频率增加，冷凝器温度降低时，冷凝器出口冷媒随之降低，系统冷冻能力会有所提高，COP亦增加；在蒸发器方面，蒸发器卤水出口温度及卤水流量增加，可以使蒸发器带走更多的热量其系统冷冻能力及COP也就会相对增加。

Bell-type furnace from a shrouds,two furnace Block,two in the hood,a componet cooling enclosures,shrouds-rolled steel used welding of molding,using energy-saving lining all the latest technology fiber module structure,for the Top All Permian High-pressure wave fiber Banding hanging flattened,high aluminum screw linked with resistance bands Top fast-cooling cooling installation Double doors.

罩式炉由一台加热罩、两台炉座、两台内罩、一台冷却罩组成，加热罩采用钢板卷制密焊成型，炉衬采用节能型最新技术全纤维模块结构，炉顶为全纤维波浪叠法高压捆扎吊平顶，高铝螺钉挂装电阻带，炉顶安装双孔快冷降温门。

If the applied power is due to a initial use not the temporary power failure, the cooling temperature is set to the middle value in the cooling temperature range, and then controls loads such as a compressor and a blowing fan in the refrigerator to the driven so that the inside of the refrigerator is cooled according to the set cooling temperature.

如果是缘于首次使用而非暂时电源故障，就把冷却温度设定冷却温度范围的中间值，然后控制电冰箱的压缩机、风扇等负载，使其运转，以便冷却冰箱内部。因而，能把电冰箱的冷却温度设定到接近用户先前设定的温度控制状态。

The total static loads and dynamic loads are summed as 4.692W and 38.4W, respectively. And comparison between the double-wall cooling method and the cooling tube method for the 77 heat shield has been discussed to provide the thermal parameters for flow process simulation. The critical thermal parameters of the main components of the QWR cooling system were determined for parallel arranged QWR cryostats. The mass flow and time for cool-down of the QWR to 4.2K was also estimated.

本文在详细描述恒温柜冷却系统的基础上，详细计算了4.2K冷质量与77K冷屏的辐射漏热，同时，还对恒温柜内部支撑系统计算了变物性下的导热漏热，得出了恒温柜系统的静态和动态热负荷分别为4.692W和38.4W，并分析比较了液氮冷屏采用夹层冷却方式与铜管缠绕冷却方式的优缺点，为流程模拟的参数确定提供了依据。

Main contents of the thesis are as follows: Description of the present usage of liquid cooling system, presentation of a new type of liquid cooling system and description of its work principles; Design of the liquid cooling system, which mainly deals with the design and collating calculating of serpentine condenser and heat exchangers adopted in this system. Meanwhile, the model chosen calculating of compressor、thermal expansion valve、plate evaporator、water pump and the like equipment used in the system are also carried out.

本文的主要内容如下：对液冷源使用现状进行了描述，提出了一种新型液冷源系统并对其工作原理进行了阐述；对系统进行了设计，主要对系统中所采用的管带式冷凝器和水侧空/液换热器进行了设计和校核计算，同时对系统中所用到的压缩机、热力膨胀阀、板式蒸发器、水泵等配套设备进行了选型计算；分别对制冷系统和冷却液循环系统进行了数学建模。

Rated at extraction conditions, one pump is running, because the cycle of water to reduce the system's water resistance decrease the flow of water pumps 12274T / H, head will drop to 15.0-16.0 m, in the extraction steam turbine at the maximum operating conditions, the recycled water to meet the system requirements to run a pump, because of substantial reduction in the volume of water supplied, so that substantially improve pump head, a direct result of the cooling tower water gushing, increase淋水device with a flow rate of the sink, fill up water in the hot淋水exchange reduce the time and reduces the cooling effect of cooling towers.

在额定抽汽工况下，一台水泵运行，由于循环水量减少、系统的水阻下降，水泵的流量12274T/H，扬程将下降至15.0-16.0米，在汽轮机在最大抽汽工况时，为满足循环水系统要求运行一台水泵，由于供水量大幅度减少，使水泵扬程大幅度提高，直接造成冷却塔涌水，加大淋水装置配水槽的流速，水流在淋水填料上热交换的时间减少，降低了冷却塔的冷却效果。

Sewage FRP cooling tower rotation atomized spray cooling tower, roof fan, axial fans, centrifugal fan, ventilation pipe and products based on user selection of the cooling tower, the transformation of the user Laota the ideal product.

污水玻璃钢冷却塔喷射旋转雾化冷却塔，屋顶风机，轴流风机，离心风机，通风管道系列产品并可根据用户对冷却塔的选型，老塔的改造得到用户的理想产品。

This method requires heating and cooling on the same platens. This controlled cooling is done with special "ramping" controllers coupled to solenoid valves on the cooling system.

此方法要求采用同一压台同时带有加热和冷却功能，此控制冷却功能是通过同冷却系统的螺旋阀相联接的特殊&斜线&控制器实现的。

Thermoprproperties of 7 nucleators -CaCl2·6H2O composites such as borax, SrCl2·6H2O,Ba2·8H2O were researched with gradually cooling method and TGA-DSC under room temperature cooling,open system and icewater cooling, closed system.

用步冷曲线法和TGA-DSC联用研究了室温冷却开放体系和冰水浴冷却封闭体系两种工况下硼砂、SrCl2·6H2O、Ba2·8H2O等7种成核剂-CaCl2·6H2O复合体系的储热性能，探讨了工业级CaCl2·6H2O原料中主要杂质NaCl和MgCl2对成核剂成核作用的影响。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48