查询词典 converter

The semiconductor optical amplifier- cross gained modulation wavelength converter in the core node is used to transfer the payload from the old label to the new label to achieve the label erasion and insertion.

基于此光标记系统，研究Mach-Zehnder调制器的消光比、半导体光放大器的偏置电流、接收模块的输入功率、泵浦光功率、探测光功率对误码率的影响，以及转换波长与转换效率的关系。

It is located in the exhaust gas stream between engine and the three-way catalytic converter.

它位于机器和三向催化转换器中间的废气流中。

Elevating the valid time of using the cell, and using the cell more rationally. The MCU AT89C51 was used as its main CPU and combined with display module, A/D converter, expended memory and watch dog technology in order to satisfy the need; a new type of infrared wireless technology was used to transmit the data collected and was given the real circuit design picture.

能更有效、合理地使用和保养电池组，提高电池使用寿命；该系统采用单片机主机AT89C51结合显示、模／数转换、扩展存储和看门狗技术；数据传输采用RS-232串口转红外无线技术进行传输，并给出了具体电路设计图示。

The main points andcontent of the paper are indicated as following:(1) Producing cobalt matte by carbothermal reduction and pyritesulfuration of nickel converter slag at high temperature A mineralogical study of coverter slag shows that the most of cobaltand nickel exist in fayalite of a kind of silicate minerals as a form ofoxide and the rest of cobalt and nickel and most of copper in slag assulphide.

论文的主要研究内容和结果如下：(1)转炉渣高温还原硫化制备钴冰铜转炉渣的矿物学研究表明，在转炉渣中大部分钴、镍以氧化物形态"溶"于铁橄榄石等硅酸盐类矿物中，其余钴、镍及大部分铜以硫化矿形态赋存于转炉渣中。

The question of unbalance on PS PWM DC-DC FB converter is discussed, and the solution is proposed.

介绍了桥式变换器的不平衡问题及解决方法和参数确定。

By adding ferrochrome into the converter and using the process of blowing, Ti was removed from the alloy and the nitrogen content in the molten steel was reduced to a very low level, thus greatly decreasing Ti hazard.

通过在转炉中加入铬铁吹炼去除合金中的钦，并且钢水中氮含量很低，最大程度降低了钛的危害。

Using the data dealing method for the saturated solubility, thermodynamic properties of Fe-C-Cr melt were calculated and the temperature dependence of thermodynamic properties also obtained, and the thermodynamic analysis of de-carbonization with blowing oxygen was carried out while medium carbon and low carbon ferrochrome were smelted using high carbon ferrochrome with converter practice.

利用碳饱和溶解度数据处理方法，计算了Fe－C－Cr熔体的热力学性质，得到Cr对C的话度相互作用系数与温度的关系式，并分析了高碳铬铁转炉法吹炼中低碳铬铁时吹氧脱碳的热力学行为。

An alloy of ferromanganese is added to the molten metal as it is poured from the converter into the ladle.

是工具理性在教育中的具体化。10。人们在钢水轻炉倒进钢水桶时，放进一些锰铁合金。

The phosphorus content in the first heat steel of converter steelmaking after fettling was higher than normal operation and some times even higher than the standard limitation.

转炉大补炉后冶炼第一炉钢时钢中磷含量容易偏高，有时甚至超出钢种要求的磷含量上限。

The whole sintering process of SHS converter fettling materials can be divided into three steps. The first step is the decomposition reaction of carbonates and sodium nitrate, which is an endothermic reaction. The second step is the SHS reaction, i. e. thermite reaction, the metal of Al reacts with CO〓, O〓, NO〓, Fe〓O〓 to form Al〓O〓. The speed of thermite reaction is very quick, and accompanied with large amount of heat emission and temperature rise. The third step is the reaction of spinels formation. The Al〓O〓 produced by SHS reacts with MgO to form spinels.

整个SHS补炉料的烧结过程分三步进行：第一步为碳酸盐、硝酸钠的分解反应，属于吸热反应；第二步为SHS反应即铝热反应，金属铝粉与CO〓、O〓、NO〓、Fe〓O〓等反应生成Al〓O〓，反应速度很快，并伴随有巨大的放热和温度升高；第三步为合成尖晶石的反应，SHS反应产物Al〓O〓与MgO反应生成尖晶石。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48