查询词典 convert sorrow into strength

The artide focused on the cellule and molecule character of myocardic ischemia and ischemical reperfusion injury induced by strength training, the essential feature of strength training preconditioning and the signal transduction mechanism and the intra-cellular effector of myocardial preservation, proposing the research strategy, concrescencing the theory of contemporary strength training, clarifying some hot questions and important future directions on endogenous myocardial protection of strength training.

就力量运动引起相对心肌缺血及缺血再灌注损伤的细胞分子学特点、力量运动缺血预处理的基本特征及心肌保护作用的细胞信号转导机制与细胞内效应器及存在的问题进行阐述，提出研究策略。

The relationship between in situ target strength and depth of chub mackerel was established by selecting the length composition of mackerel was larger than 90%. Results showed that the in situ target strength of chub mackerel was changed significantly depend on depth up to 8.7 dB. And it indicated that the measurement of in situ target strength of fish with swim bladder should be modified by the relationship of target strength and depth, especially in chub mackerel, it may be led to overestimate the standing crop to 7.4 times of the assessment.

将科学鱼探所收录到的白腹鲭声学资料使用线性回归来检定现场标物反射强度与样本所在水深关系，检定结果显示出白腹鲭在不同水深时所反射的现场标物反射强度均会随著深度改变，并且呈现负相关的显著水准(p.01)，现场标物反射强度变动有8.7dB差异量，对白腹鲭鱼群现存量会超估7.4倍的差异。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

The results show that BFRC has favorable impact compressive strength and deformation;,and the impact compressive strength and deformation of BFRC is relational with strain rate and fibre volume content; with strain rate increasing, impact compressure strength and deformation enhance; the impact compressure strength of BFRC is better when the fibre volume content is 0.1%, and the deformation performance of BFRC is better when the fibre volume content is 0.3%.

研究结果表明，BFRC具有良好的冲击压缩强度和变形性能，且其冲击压缩强度和变形与应变率和纤维掺量有关；BFRC的冲击压缩强度和变形随应变率的增大而增加；纤维掺量为0.1%的冲击压缩强度较高，纤维掺量为0.3%时的变形性能较好。

The results show that the addition of cross-linker makes tensile strength of the material greatly increase. After the addition of dialdehyde starch, the tensile strength raises from 7. 2MPa to 13. 2 MPa. However, the strength of the material cross-linked by TDI greatly increases when the additive level is less than 10％ while the tensile strength of sample whose additive level is 20％ is even worse, which is mainly caused by the inner-flaw after cross-linking.

结果表明，交联剂的加入使材料的强度得到较大的改善，添加双醛淀粉后，材料的强度从原来的7.2MPa提高到13.2MPa，而添加TDI的材料在添加量10％以前强度有较大的提高，但20％添加量的样品的强度却很差，主要是由于形成的内部缺陷造成的。

Systematical researches were carried out on the cleavage strength of steel fiber concrete with 3 base strength grades,6 steel externalities and 4 fiber admixtures,and it is discovered that the cleavage strength of concrete increases as the base strength grade rises,and dumbbell-like,shield-like and hook-like steel fibers have good reinforcement effect while flat steel fiber has less reinforcement effect.

通过对3个基体强度等级、6种纤维外形、4种纤维掺量的钢纤维混凝土的劈拉性能进行系统研究，发现混凝土的劈拉强度均随基体强度等级增加而增大；哑铃、盾铃、端勾形钢纤维的增强效果较好，而平直形钢纤维的增强效果较小。

As for the factitiously specified allowable values,such as allowable deflection,allowable amount of wear,and so on,their magnitudes,which are confirmed on the basis of empirical formula,often have an interval value or a limit value,therefore they can be described suitably by minor type membership function, As for various strength values of parts,such as tensile strength,compression strength,contact strength and so on,their magnitudes,which are often confirmed only by approximate mean,can be described suitably with middle type membership function.

对于人为规定的各种许用值，如许用挠度值、许用磨损量等，根据经验公式确定它们的大小时往往有一个区间或一个极限值，宜用偏小型隶属函数描述，对于零件的各种强度值，如抗拉强度、抗压强度、接触强度等，实际中往往只能确定其近似的均值，宜用中间型隶属函数描述。

This project in business mark to enter a bid the course of authorized strength in have adopted broad unite to reach software valuation have adopted GBQ2. 0 editions list valuation software, at the same time, according to reinforcing bar have carried out the professional software of reinforcing bar take quantity; In the technical course of authorized strength of marking part , the authorized strength for the plan of construction progress has adopted dream dragon software, have carried out the layout of network plan, and for being under construction , the plane on-the-spot is also drawn up with dream dragon plane design software , includes main part and foundation mainly in which plane with decorate the construction plane on-the-spot of 3 projects arrange picture; For entering a bid the authorized strength of letter part, us adopt specification enter a bid letter text, guarantee the regularness of entering a bid.

本工程在商务标投标编制过程中采用了广联达软件计价采用了GBQ2.0版本的清单计价软件，同时，针对钢筋进行了专业钢筋软件的取量；在技术标部分的编制过程中，对于施工进度计划的编制采用了梦龙软件进行了网络计划的编排，并对施工现场平面亦采用梦龙平面设计软件进行编制，其中平面图主要包括主体，基础和装饰三项工程的施工现场平面布置图；对于投标函部分的编制，我公司采用规范的投标函文本，保证投标的正规性。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。