查询词典 convert sorrow into strength

Dynamic mechanical analysis,mechanical properties and the thermal dilatability measurements were used to study the effects of SF content on dynamic mechanical properties,impact strength,bending strength,bending modulus,specific strength,specific modulus,wear resistance and thermal dilatability.

采用动态力学、力学性能、热膨胀性能等测定研究了剑麻纤维的加入量对复合材料的动态力学性能、冲击强度、弯曲强度、弯曲模量、比强度、比模量、耐磨性能、热膨胀性能的影响，用扫描电镜观察了材料冲击断面和磨损面的形态。

The result shows that the phenomenon of the sudden jump of permeability occurs at the peak strength and keeps very low unchanged permeability before the peak strength for diorite. But limestone's permeability gradually increases with increasing deformation before and after the peak strength.

实验结果表明，闪长岩的渗透率在峰前很低且基本不变，在峰值强度时产生"突跳"现象，石灰岩的渗透率在岩石强度峰值前后随岩石变形逐渐增大。

Based on electro-characteristic and double electric layers models, directional mechanisms of soy protein molecular are analyzed for the first time on DC heating condition. After the main factors which effect soy protein gels transparency and strength being studied on DC heating condition, the different affects on soy protein gels transparency and strength by DC heating and water bath heating are analyzed and compared, and the transparent mechanisms of soy protein gels are further explored. In addition to temperature action as water bath heating, DC heating is added as electric field directional action. As a results, heating rate is increased. Directional range degrees of soy protein molecules are raised. These advantage the increase of soy protein gels transparency and strength. Microstructures of soy protein gels forming on DC heating condition are observed by SEM and the results showed that ordered structure of transparent soy protein gels on DC heating condition is more ordered than that of transparent soy protein gels on water bath heating condition.

首次从大豆蛋白的电特性和双电层模型上分析了直流电加热条件下，大豆蛋白分子定向的机理；通过对直流电加热条件下影响大豆蛋白凝胶透明性和强度主要因素的研究，分析和比较了直流电加热与水浴加热对大豆蛋白凝胶透明性和凝胶强度的不同影响，又进一步探讨了大豆蛋白凝胶透明的机理；直流电加热除了水浴加热中的温度作用以外，又增加了直流电场的定向作用，提高了加热速率，提高了大豆蛋白分子定向排列的程度，有利于蛋白质凝胶透明性和强度的提高；利用SEM对电场下大豆蛋白凝胶微观结构的观察，进一步证明了直流电加热比水浴加热形成的透明大豆蛋白凝胶微观结构具有更高的有序性。

Know to all, the way to bond disjunct advertising poster surfaces, we usually use mucilage, such as the 502 glue to join them together in one, but the means have a lot of disadvantages, such as:(1)Almost all of these kinds of bond are harmful on human health;(2)When work, the operation is slow and is not too satisfied in strength with the glue, to get a good strength, usually we must proceed a special handling, such as whet the surface to make the surface not smoothed, so it may cost more workers;(3)The air temperature may influence the stick strength, in low temperature environment, the bond effect maybe bad.

知道所有的方式，债券间断表面的广告海报，我们通常使用粘胶，如502胶加入他们在一起，但手段有很多缺点，如：（ 1 ）几乎所有这些种债券是有害于人类健康；（ 2 ）当工作，行动是缓慢的，而不是太满意的强度与胶水，得到良好的强度，通常我们必须特别处理，如刺激的表面，使表面不光滑，因此它可能花费更多的工人；（ 3 ）空气温度可能会影响到坚持的力量，在低温环境中，债券可能坏的影响。

This design wants to design a complete set of three axes five speed gearboxeses , it mainly include three parts : The first part , to make sure the basic parameter of the gearbox assurance ; The second part, The contact strength verify-check and the flection strength verify-check of each wheel gear of the gearbox, mainly verify whether each wheel gear satisfy various strength conditions with according to the giving parameter ; The third part , to progress verify-check intension of the axes Four-part cent, to calculate the life of the bearings.

本次设计是要设计一部较为完整的五档变速器，其中主要包括三部分：第一部分，变速器基本参数的确定；第二部分，变速器的各档齿轮的接触强度校核和弯曲强度校核，主要是根据所给的参数来验证各档齿轮是否满足各项强度条件；第三部分，进行轴的强度校核；第四部分，轴承的寿命计算。

The research development of ultimate strength of hull structure is summarized and the calculation method of ultimate strength of stiffened plate,hull plated grillage and hull girder is analyzed as well as the trial research on ultimate strength of hull structure .

综述了船体结构极限强度的研究现状，分析了加筋板、船体板架和船体梁极限强度的计算方法以及船体结构极限强度的试验研究。

The results show that the density of gritstone is decreased gradually as the temperature increasing; so that it can be ignored; the longitudinal wave velocity is linearly decreased when the temperature increasing, and decrease rate of it follows the law of conic; R is one temperature point, which makes the law of tensile strength of gritstone after high temperature follows the law of parabola; and the maximal tensile strength appears when the operative temperature is R. After the temperature is higher than 700 ℃, tensile strength is small and change range is small when the temperature is increased.

结果表明，高温后粗砂岩的密度随试验温度的升高减小幅度很小，几乎可忽略不记；高温后试件中纵波波速的传播随温度升高基本呈线性降低，而减小率呈二次曲线规律变化；存在一个温度点R，使高温后试件的抗拉强度呈开口向下抛物线关系变化，且在R温度作用后试件抗拉强度达到最大；当试验温度大于700 ℃后，试件的抗拉强度变得很小，且当温度升高时变化幅度也很小。

Life expectancy of anti-impact ability and strength are determined, will be used in high strength steel impact strength Level.

抗撞击能力和寿命都由材料的强度来决定，将受到所使用的高强度钢的强度等级的影响。

Finally, by studying on using saw blades with different matrices cutting different stones, a basic compatibility rule about matrices and stones was concluded, say, when cutting a hard, high quartz and high alkalifeldspar content and strong bonded stone, a high impact strength and low wear-resistance matrix should be chosen; otherwise, when cutting a soft, low quartz or no quartz content and weak bonded stone, a high bending strength, low impact strength and high wear-resistance matrix should be chosen.

最后，通过对不同性能结合剂的锯片切割不同石材的切削寿命和磨损状态分析，得出了锯片结合剂性能与岩石性质之间的一般性匹配原则：即对于坚硬的、高石英含量的花岗岩，宜选用高强度、高冲击韧性、低耐磨性和对金刚石具有良好粘结性能的结合剂；对于低硬度、无石英或低石英含量的易切削花岗岩，宜选用高强度、高耐磨性和低冲击韧性的结合剂。

A formula of rock resistant coefficient is derived based on unified strength theory, which can be adopted to obtain rock resistant coefficient in other situations or strength thoeries simplified by assuming the parameter value in the formula. The strength differential effect, intermediate principal stress effect and the ground water permeation effect are considered in the formula.

基于统一强度理论，将巷道围岩视为多孔介质，考虑地下水渗流作用的影响，推导出了巷道围岩抗力系数计算统一公式，改变公式中的参数可以退化为其他围岩条件或者其他强度理论条件下的围岩抗力系数计算公式。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"