查询词典 convection heat transfer

The efficiency of mass transfer in 60% fraction of hole is higher than in 40% fraction of hole. When gas/liquid ratio is lower 10, the efficiency of mass transfer in new sieve baffle tray is higher than in traditional tray.A three-dimensional quasi-single phase computational fluid dynamics program with the RNG- turbulence model is presented for evaluating the performance of the new sieve baffle tray. The special feature of this model is taking into account the influence of heat transfer during the mass transfer and the influence of mass transfer in computing the flow field.

建立了以RNG模型为基础的三维拟单相流模型，该模型与其它研究者所建立的模型的最大进步是，前人在塔板流场的计算中没有考虑传质的影响，并且在传质过程中没有也没有考虑传热对传质产生的影响，实际上在传质过程中，抛开传热来计算和研究传质是不准确的，因为在传质过程中伴随着传热，并且传热和传质是互相影响、互相制约的，本文所建立的传热与传质模型，把传热和传质进行了有效的藕合。

For the turbulent developing flow of absorbing and isotropic scattering medium in a circular tube, the steady state heat flux of the coupled heat transfer of turbulent convection and thermal radiation under constant wall heat flux was investigated numerically.

对圆管内物性随温度变化的吸收-各向同性散射介质的湍流入口段，数值研究了定热流加热下辐射与湍流正在发展流耦合换热的稳态热流特征。

The conclusion of three burning methods mentioned above during the heat storage period is that the first method is the best one, which is propitious to keep higher blast temperature because of the heat exchange in the middle and blow of hot blast stove has been aggrandized through convection heat transfer caused by the added exhausted air quantity and increased flow rate.

以上三种燃烧制度，在蓄热期：第1种因废气量增大，流速加快，利于对流传热，强化了热风炉中下部的热交换，利于维持较高风温，第2种因废气量减少，不利于传热和热交换的强化，不利于维持较高风温，第3种由于废气大量减少，流速降低，传热减缓，蓄热量较少，不利于提高风温。

By Using the 3 D unsteady state heat transfer equation,the heat convection and radiation between the checker and the gas which flows through the checker holes,and the heat conduction among the checker in the chamber of the hot blast stove were studied.

应用三维非稳态热量传输方程，对高炉热风炉在燃烧过程中蓄热室内格子砖与气体之间的对流和辐射传热，以及格子砖内部的导热过程进行了耦合求解得到了在燃烧期内格子砖及燃烧过程中燃烧废气的温度分布情况及其随时间的变化规

By using the 2-D unsteady state heat transfer equation,the heat convection and radiation between the checker,the gas flowing through the checker holes and the heat conduction among the checkers in the chamber of the hot blast stove were studied.

应用二维非稳态热量传输方程，对高炉热风炉蓄热室内格子砖与气体之间的对流和辐射传热，以及蓄热体内部的导热过程进行求解，分析热风炉的不同操作制度对热效率的影响。

The phase-changing material supplies heat for indoor heating by heat conduction upwards and convection current, meanwhile heat supply of the phase-changing material is adjusted by air duct and indoor aeration speed, which further regulates and controls heat supply speed.

相变材料通过向上导热和对流为室内供暖提供基础供暖量，同时通过调控空气通道与室内的换气速率来调整相变材料的供暖量，起到进一步调控供暖速率的作用。

On base of the theory of polymeric melt filling flow in micro injection molding , the mechanism of convectional heat transfer for polymeric melt was discussed,and the effects of convectional heat transfer on the melt filling flow in micro injection molding were investigated with considering the model of convectional heat transfer coefficient.

在熔体流动理论的基础上，通过分析熔体的对流传热机理，并引入对流换热系数模型，对微注塑成型中对流换热系数对熔体充模流动进行了研究。

Based on the theory of heat and mass transfer for film type cooling, a mathematical model for the velocity distribution of a thin water film, the equations of mass and heat transfer, and evaporation cooling controlled by the latent heat transfer were established.

基于膜状冷却热、质传递机理，建立水膜薄层的速度分布，热、质传递方程和潜热蒸发冷却控制的数学模型。

In order to enhance heat transfer efficiency of reboiler which is widely used in petroleum and chemical system, phase change heat transfer and friction characteristics in several heat transfer enhancement tubes are studied, With a view to approach practical circumstances, cumene is chosen as organic working medium.

为了提高石化系统再沸器的传热效率，本文研究了几种强化沸腾与冷凝管的传热与阻力特性。为接近实际条件，选用异丙苯为工质。

Thirdly, fuzzy control method and PID method were used respectively to design temperature self-adjustment controller of carbon fiber concrete laminate beam,by the MATLAB simulation it is found that the PID method has higher speed but is more sensitive to the fluctuation of system parameter ,it is suit to the regulating when the heat transfer coefficient fluctuates diminutively and the structure has little heat transfer with the environment;fuzzy control can be adapt to the parameter variety in a large scale , it is suit to the regulating when the heat transfer coefficient fluctuates greatly.

分别采用PID和模糊控制策略设计了温差自调节控制器，通过MATLAB仿真研究得出：PID方式具有更快的调节速度，但对系统参数变化较敏感，适合系统与外界对流交换较微弱，对流参数波动不大时的调节；模糊控制能够适应系统参数在较大范围内的变化，适合对流参数波动较大时的调节。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48