查询词典 control rod

Forecastle deck to be arranged with two sets of hydraulic anchor windlass / mooring winch combination, each with one chain wheel, one warping head and one control rod.

首楼甲板上设置2台液压起锚系泊组合锚机，各有1个链轮、1个副卷筒和1根控制杆。

These actuators are easy to install by mounting near the fuel system and direct connecting to the fuel control rod or lever.

这些驱动器是易于安装，由安装附近的燃油系统和直接连接到燃油控制杆或杠杆。

Fig. 601 Check for the valve fitting into the fusel age con t our and presence of the control rod gap

检查阀门同机身轮廓的吻合和控制杆缝隙值。

The clutch control rod of the topping lift winch suddenly jumped out from its original position and the topping lift wire rope freely ran out.

千斤绞车离合器控制杆跳出原位，千斤索松脱。

In this thesis, firstly, some main models have been checked on their accuracy, and the reliability of MACORS code has been verified by the RELAP5/MOD2 code on five transient conditions for QSNP: loss of flow; loss of offsite power; incontrollable control rod withdrawal; the feed-water temperature increasing and the feed-water lost. The results obtained are very satisfactory. Secondly, MACORS is used to calculate the operating and accident transients for QSNP, and the analysis results are significant to real engineering. And finally for MNRS, MACORS is used to simulate the steady-state natural circulation heat-removed capacity and the transient behaviors from forced circulation to natural circulation. Some important conclusions are obtained by the analysis results.

本论文首先从各方面对核动力系统中最主要的、热工水力特性最复杂的反应堆和蒸汽发生器进行单独验证和理论分析，其次分别利用RELAP5/MOD2程序和MACORS程序对秦山核电站的双环路失流、全厂断电、反应性事故引入、主给水参数变化及丧失主给水五种瞬态工况进行了计算，结果符合很好，从而证明了本程序模型的准确合理性，选择数值方法的有效性和编制程序的正确性；尔后，利用MACORS程序对秦山核电站的多种运行及事故瞬态进行了分析，得出了具有工程价值的结论；对船用核动力装置的稳态自然循环载热能力以及相应参数的特性、强迫循环与自然循环的过渡工况等进行了仿真分析，所得结论对我国核动力船舶的设计，运行以及安全审评具有重要的意义。

The results gained from MACONP are indentical with that of RETRAN02/MOD2 program. Then, Incontrollable Control Rod Withdrawal ATWS , Loss Of Offsite Power ATWS , Turbine Trip ATWS and Loss Of Feedwater ATWS are analyzed emphatically. Based on the LOFW-ATWS analysis, the sensitivity analyses of the influence of some conditions on ATWS process are conducted, such as pressurizer relief valve blocking, putting pressurizer spray in, no turbine trip and decrease of moderator reactivity coefficient. The simulating results agree well with corresponding results of RELAP5/MOD2, both analyses consequences are consistent in the main.

本论文首先应用MACONP程序分析了秦山核电站的汽轮机保护停车瞬态，包括&压力有控制&和&压力无控制&两种情况，所得结果与RETRAN02/MOD2的计算结果吻合；然后着重分析了该电站的控制棒失控提升ATWS、失去厂外交流电源ATWS、汽轮机保护停车ATWS和失去主给水ATWS，并在LOFW-ATWS分析的基础上就稳压器释放阀卡死、稳压器喷淋投入、汽轮机不脱扣和慢化剂反应性系数减小等对ATWS进程的影响作了敏感性分析，仿真结果与RELAP5/MOD2的仿真结果符合良好，对结果进行分析所得到的分析结论也基本一致。

So here we are in October, after another spectacular regular season and unfulfilling postseason, and Rodriguez is in control.

现在已到十月，在一个令人惊奇的球季和让人失望的季后赛后，该是A Rod主宰自己合约的时候了。

The solution: find the plunger adjustable arm or gear from the speed control rod protruding ears slot prolapse, should re-open the fuel pump is installed correctly; also check whether the cross-slot wear and tear is too large, if found dead in parked for seca column position, should be demolition of repair or replacement parts; injector should be able to check the plunger is serious wear and tear, deputy returned to the oil valve gasket is worn; demolition injector, check whether the coupling of needle stuck in the closed position, needle and the injection hole Does burning, according to test results even to repair or replace parts.

解决办法：发现柱塞调节臂或齿轮凸耳从调速拉杆槽中脱出，应拆开喷油泵重新正确安装；同时检查叉槽是否磨损过大，如发现柱塞卡死在停供位置，应拆卸进行修复或换新件；喷油无力应检查柱塞副是否严重磨损，回油阀垫圈是否磨损；拆卸喷油器，检查针阀偶件是否卡死在关闭位置，针阀与喷油孔是否烧损，根据检查结果进行修复或更换偶件。

At the same time, the speed of diesel engine, the control rod travel of accelerator and its change rate are chosen as input parameters, the current position of step motor's rotor is chosen as the feedback parameter.

考虑到控制系统结构的简化及控制的可靠性，电控系统的控制策略确定为以柴油机转速、油门位置及油门变化率作为输入参数，同时以步进电机实际运行位置作为反馈参数的开环控制方式。

The control rod drive mechanism housing of nuclear power plant is installed on the reactor pressure vessel head by welding and interference fit.

核电站主设备控制棒驱动机构管座是通过焊接和过盈配合共同作用安装在压力容器顶盖上。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。