查询词典 container

An inserter is an iterator adaptor ( Section 9.7, p. 348) that takes a container and yields an iterator that inserts elements into the specified container.

插入器是一种迭代器适配器（第 9.7 节），带有一个容器参数，并生成一个迭代器，用于在指定容器中插入元素。

If the low temperature and bethhoron bakeout of chemical molecules key is not fully cross-linked prefilming, not only no adhesion, having oftinned the offeris stick dirty, counterproductive, as printed on the next step for ink adhesion, so that separation oftinned difficulties for the chromatography (oftinned intine, on the back of the container appears sticky dirty would pollute the contents in the container).

如果烘烤温量伯矮，树脂洋的化学不合子键未充不合接联固化成膜，非但无附着力可言，还会变成马口铁背背粘脏，不入现不正印，下道工序因油不朱粘连，使马口铁不合弛艰难，感化套色（马口铁背背解容器边壁，不入现粘脏会浑浊容器洋的不形式物）。

This paper analyzes the Dalian Container iron rail inter-modal environment for the development, including the revitalization of the old industrial bases in northeast Chinas macroeconomic environment, and build Dalian shipping center for northeast Asia regional environment, but also on national and local rail container iron multimodal transport laws and regulations and policy environment.

本文分析了大连铁路集装箱海铁联运的发展环境，这其中包括振兴东北老工业基地大的宏观环境，建设大连为东北亚航运中心的区域环境，也包括国家和地方上对铁路集装箱海铁多式联运的法规、政策环境。另外，大连市铁路集装箱海铁多式联运软硬件方面的设施状况也是本文的重要内容。

The container terminal is a key part of container transportation chains and its inner logistics system is a typical network.

集装箱码头是整个集装箱运输网络的枢纽，其内部的物流系统是一个典型的网络结构。

On the basis of the last development of container transportation,combining with the design and production practice,the landside layout plan and key points for container terminal are discussed emphatically in the paper.

根据集装箱运输方面的最新发展，结合设计和生产实践，重点讨论集装箱码头陆域布局规划和设计的要点。

LoadMaster packing crates master design software is the company's core product, is to raise the rate of container weapon and the container stuffing the highest rates of packing design software.

LoadMaster装箱大师装箱设计软件是本公司的核心产品，是提高集装箱率的利器，是集装箱装箱率最高的装箱设计软件。

It often happens that the parachute is too difficult, or even impossible, to extract from it's container (especially for less aggressive persons) because of too much Velcro, or deployment pins which are too long. In certain cases, if the pilot's in a spin, it's not even realistic to grab the handle of many parachute systems. After having mounted a parachute on a harness, it's vital to do a hang check to verify that the deployment handle is truly easy to grab and that the parachute can be pulled from the container with minimal effort and in any variety of pilots position and circumstances. Seems obvious, but almost no one actually does it!

而时常发生的情况是由于过多的尼龙搭扣，或者保险销过长导致备份伞很难，甚至是根本不可能从吊带里面抽出来（尤其是对于那些体力较差的飞行员）；在某些状况下，比如在螺旋当中，很多备份伞系统的备份伞手柄根本就不可能抓到；因此在安装好备份伞之后务必要做悬挂检查：将吊带吊起来，自己坐在上面模拟在各种飞行状态下是否能够轻易而迅速的抓住手柄将之抛出来；显然，没有多少人做过这个模拟。

The paper carries out mechanical analysis of the weight distributing of goods in loading container based on analysis of packing and tansporting environment, and draws the formula of the ratio of the weight of loading goods and the maximum loading weight W/W0, and the length distributing ratio of loading goods α=l/L under the condition that the bending quadrature produced by part load is within the range of the maximum bending quadrature. It also gives the graph that the sum deflection of mudsill and underside girder can reach high-point value with the length of bottom distributing varying, when the loading amounts of container of 20ft and 40ft are given. Furthermore, it provides the relation graph of an eccentric rate of loading goods and the allowed loading amount. For on-site safety loading work, it has certain guidance and reference value.

在分析包装件运输环境的基础上，对装载集装箱的货物重量分布进行了力学分析，得出局部负荷产生的弯矩如在最大容许弯矩范围以内时，装载货物重量与最大载货重量之比W/W0，同装载货物的长度分布率α=l/L的关系式；绘出了20 ft和40 ft集装箱在装货量一定时，随着货物底分布长度的变化，底梁和下侧梁之合计挠度达到极限值的曲线图；绘出了装载货物的偏心率与容许装货重量的关系图；对现场安全装载作业有一定的指导作用和参考价值。

Technology from Ipifini Inc., Natick, Mass. The technology uses pre-filled ampoule-like "buttons" on the surface of the beverage container which allow consumers to select which variations they'd like to dispense into the base liquid in the container.

技术，从Ipifini公司，纳提克，马萨诸塞州的技术采用预填安瓿样"按钮"表面上的饮料容器让消费者选择的变化，他们希望免除并入基液体的容器。

OR B. Before pouring into assembled nurser, warm liquid in separate container and cool to separate container and cool to lukewarm (At least 15 minutes if boiled).

或b。在涌入组装nurser ，温暖液在不同的容器，分离容器冷却和冷却，以不冷不热的（至少15分钟，如果煮）。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。