查询词典 contact surface

The image forming device also includes a pressing body which is provided on the main frame and is slidable in a direction along a straight line orthogonal to a rotational center shaft of the electrostatic latent image carrier and a rotational center shaft of the developer carrier, and an operating unit which operates the pressing body to press a bottom surface of the developing unit by sliding the pressing body in a direction of the straight line and to hold the pressing body so that the developer carrier is maintained under a state making contact with the electrostatic latent image carrier.

该成像设备还包括：一个按压机构，该机构设置在该主框架上，并在按压方向上沿着这样直线的方向滑动，其中该直线垂直于静电潜象载体的旋转中心轴和显影剂载体的旋转中心轴；以及一个操作装置，该操作装置通过在直线的方向上滑动该按压主体以按压显影单元的底面，并保持该按压主体，从而该显影剂载体保持在与静电潜象载体接触的状态。

The surface spalling and fatigue failure may occur after a long time of service, during wheel-rail rolling contact.

摘要钢轨钢的接触疲劳一直为铁路运输部门和研究机构所重视。

The result indicated that we can get stable homopolymer and copolymer emulsion with uniform size distribution, when the ratio of sodium polyether sulfovinate modified polysiloxane to sodium lauryl sulfate was two, the quantity of the emulsifiers ranged from 6% to 8%, the quantity of initiator ranged from 0.4% to 0.8%, the stirring speed ranged from 200rpm to 250rpm, the polymerization temperature was 80 centigrade degree. As for the copolymer emulsion, the more the TRIS content in the monomers, the larger the water contact angle of their films became, namely, the surface energy of the copolymer films increased with the TRIS content in the monomers. In addition, the glass-transition temperature of the copolymers ranged from high temperature region to low temperature region with the increasing of TRIS content in the monomers.

结果表明：当乳化剂用量在6%～8%、改性乳化剂与十二烷基硫酸钠复配比为2：1、引发剂用量在0.4～0.8%、聚合温度为80℃、搅拌速度在200～250rpm时，得到的均聚物和共聚物乳液稳定，而且粒径分布均匀；对于共聚物乳液来说，随着单体中TRIS含量的增加，所得聚合物膜的水滴接触角增加，即其表面能增加：另外，随着共聚单体中TRIS含量的增加，共聚物的玻璃化转变温度从PMMA的Tg的高温区向PTRIS的Tg的低温区移动。

Use a Fluke non-contact thermometer to read the surface temperature of uninsulated steam lines, valves and fittings

用福禄克非接触式测温仪可读取非隔热蒸汽管道、阀门和接头、收集器以及冷凝物回流管的表面温度。

As climactic changes forced the Pau'ans to follow the water and animals below ground, and avoid the ever-increasing hyperwinds that swept the surface, the Pau'ans and Utai made first contact and eventually established a peaceful and mutually beneficial society.

气候变化迫使帕安人追随着水源和动物来到了地下。为了逃避掠过行星表面不断增强的超级风暴，帕安人和优泰人发生了第一次接触并最终建立了一个和平、互利的社会。

In this case only a part of the top surface of the pin is in contact with the moulding; the rest abuts on to the fixed mould plate when the mould is closed.

在这种情况下，只有顶杆顶面的一部分和塑件接触；其余部分当模具闭合的时候紧挨着定模板。

New type ZPW21A ZPW21B is desinged to meet GMP standard .An inproved type of ZPW21.Its pressing area is sealed with four polymethyl methacrylate doors to be isolated with outside environment.The parts contact the material are made of stainless steel or their surface is specially antisepticized to avoide pollution.

ZPW21A、ZPW21B是按药品GMP要求设计的新机型，压制室采用四开门有机玻璃封闭结构，与外界环境隔离，室内与物料接触的各构件均采用不锈钢制成或者表面经过特殊防腐处理，避免物料受污染提高片剂质量和方便清洁。

This machine has a highly polished large diameter drying cylinder which burnishes the surface in contact to give a high glaze; the underside of the paper is rough.

这机器有一个大直径，表面极度光滑的烘缸。纸面和它接触后，被磨平光滑；纸底则粗糙。

This machine has a highly polish ed large diameter drying cylinder which burnishes the surface in contact to give a high glaze; the underside of the paper is rough.

这机器有一个大直径，表面极度光滑的烘缸。纸面和它接触后，被磨平光滑；纸底则粗糙。

In surface grinding experiments of casehardened 16MnCr5 a close correlation between the related grinding power Pc and the maximum average temperature Tmax in the contact zone between workpiece and gr...

而磨削表层金相组织状态和发生烧伤主要决定于接触区的温度，因而可以应用相对容易测量计算的单位面积磨削功率P_c来识别这些状态。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。