查询词典 contact area

The deformation of conductive particles in pure metal connected by anisotropically conductive adhesives has been investigated using finite element analysis. The results indicate that the increment in stresses of the conductive particles begins at the contact area toward the boundary through the centers of conductive particles when the reduction in height increases. When stress is over the yield strength, the similar behavior was observed. So the deformation of conductive particles is not uniform, which means that the deformation of conductive particles is the same as the stress does.

采用有限元模拟分析了各向异性导电胶连接的纯金属导电颗粒的变形过程，研究结果表明，随着压下量的增加，导电颗粒的应力增加由接触面开始，经中心区域向导电颗粒的周边扩展，大于屈服强度的应力变化与此相似，因此导电颗粒的变形是不均匀的，即导电颗粒的变形由接触面开始，经中心区域向周边区域进行。

The effect of the density of MeO (volume fraction,%) on the contact area of the molten pool and fusion force was discussed in details.

结果表明：与第二相MeO的密度、热导率及体积分数等物性参数对熔池接触面积的影响相比，电弧输入能量的影响才是最主要的。

The results showed that there are stress concentration increase in contact area between tooth and post with mesial tooth structure decrease in PV force.

结果发现当受PV力时，牙根柱在残缺齿质交角处应力会随著齿质缺损越多而有明显集中。

I used a nylon washer to cushion the spring topcap contact area.

我着了个尼龙垫圈垫在与盖子接触部分

If the gap exceeds 1/16 inch (1.6 mm) and there is less than 70 percent contact area, then the gap shall be packed with non-tapered steel shims.

如果缝隙超过1/16英寸(1.6 毫米)或者充分接触未达到70%，则需采用非锥形的夹铁填塞缝隙。

These phenomena is due to porous effect and high contact area from mesoporous molecular sieves.

这些现象是由於中孔洞分子筛的孔洞效应和高接触面积所导致。

With our Air Pillow the contact area between head and pillow is increased which supports your neck vertebrae as well as your head enabling you to enjoy a really good "nights" sleep

头部枕入气枕后，由于接触面较大，更利于承托你的脊椎和头部，让你享受舒适的睡眠

In China, the roller bearing cone bit is now equipped with short cylindrical roller, which has stress centralization on the edge, and it easily causes fatigue failure on the contact area.

国内现有牙轮钻头滚动轴承多采用短圆柱滚子轴承结构，滚子边缘处存在应力集中现象，使得轴承接触表面极易发生疲劳破坏，为提高牙轮钻头滚动轴承杭接触疲劳寿命，提出在牙轮钻头滚动轴承中来用凹端圆柱滚子的方案。

In China, the roller bearing cone bit is now equipped with short cylindrical roller, which has stress centralization on the edge, and it easily causes fatigue failure on the contact area.

国内现有牙轮钻头滚动轴承多采用短圆柱滚子轴承结构，滚子边缘处存在应力集中现象，使得轴承接触表面极易发生疲劳破坏，为提高牙轮钻头滚动轴承抗接触疲劳寿命，提出在牙轮钻头滚动轴承中采用凹端圆柱滚子的方案。

The traverse grinding can be assumed as the sum of several stepwise plunging grindings with respect to the grindings contact area. The dynamic model of workpiece and grinding wheel stepwise plunging grinding was set up in the form of closed loops.

基于再生颤振机理，以切入磨再生颤振建模为基础，将外圆纵磨过程简化为多步以磨削接触区为磨削宽度的小切入磨的叠加，建立了工件、砂轮小宽度切入磨动力学模型并对其稳定性进行了研究。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了