查询词典 contact angle
- 与 contact angle 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Experiments exposed that the inner flow of tooth space in the micro-channels was proved to be cycled flow after fully development. For the more, low velocity vortex cavities existed in the vertex angle and inner side of bend angle of straight angle micro-channel, while back flow only appeared in the internal side of bend angle of round angle micro-channel. It's easy to take place deposition in the low velocity vortex cavities, which is the main cause of blocking.
试验发现各类微通道齿间内流充分发展后是一种重复性流动,平角微通道顶角和转角内侧存在低速涡旋区,圆角微通道只在转角内侧出现回流,颗粒在低速涡旋区易发生沉积,是造成堵塞的主要原因。
-
For class III malocclusion there are no significant differences in Ls-SGo,Li-SGo,upper lip length , lower lip length , Cm-Sn-Ls, upper lip angle of inclination and Li-H line . There are significant differences in lower lip angle of inclination , mentolabial sulcus angle , upper lower lip angle , H angle.
安氏Ⅰ类错合患者与安氏Ⅲ类错合患者相比,在上唇突点到SGo距离、下唇突点到SGo距离、上唇长、下唇长、鼻唇角、上唇倾角和下唇突点到H线距这些测量指标上无显著性差异;其他表示唇部形态和位置的指标,下唇倾角、颏唇沟角、H角、上下唇角都有显著性差异。
-
Therefore, the electronic angle measurement also has code-degree angle measuring plate, grating-degree angle measuring plate and coding degree angle measuring plate combination, as well as the form of four kinds of dynamic measuring angle.
因此,电子测角也就有编码度盘测角,光栅度盘测角和编码度盘结合测角,以及动态测角等四种形式。
-
Germany TOP imported pneumatic angle seat valve types: internal thread pneumatic angle seat valve, welding-type pneumatic angle seat valve, flange type pneumatic angle seat valve, clamp-type pneumatic angle seat valve.
德国TOP进口过滤器类:法兰Y型铸钢过滤器、法兰Y型不锈钢过滤器、丝口不锈钢过滤器、蒸汽过滤器、天燃气过滤器、篮式直通过滤器、T型过滤器。
-
Shoulder joint angle and wrist joint angle changes have nothing to do with shooting distance; shoulder joint angle speed and wrist angle joint angle speed have nothing to do with shooting distance.
四、 不同距离投篮肩关节角度、腕关节角度变化与距离远近无关;肩关节角速度、腕关节角速度变化与距离远近无关。
-
Through the computer simulation,analyzing the effects of pitch angle,roll angle,roll angle rate,sink rate,angle of attack and side angle on the track of ejection and save life height .
为提供弹射座椅多模态控制输入参数选择的理论依据,通过计算机仿真,比较分析了俯仰角、滚转角、滚转角速度、下沉率、迎角、侧滑角等弹射启动时飞机状态参数对弹射轨迹和安全救生高度的影响。
-
When medical instrument draft condition becomes poor and the internal temperature rises reaching the controlled temperature of bimetallic strip temperature control unit, the normally closed stationary contact and normally closed moving contact disconnect to make main circuit power interruption and instrument stopping work, at the same time normally closed moving contact and normal open stationary contact switching-on, indicating light working, prompting the medical instrument being stopped because of superheating.
当医用仪器通风条件变差,内部温度上升,达到双金属片温控器的控制温度时,常闭静触点和常闭动触点断开,主电路供电中断,仪器停止工作,同时常闭动触点与常开静触点接通,指示灯工作,提示医用仪器因过热而停机。
-
With morphology characteristics of erosion concave of Ag and Pd contact materials in nitrogen and air being compared, influence on erosion, welding and breakdown voltage of contact for nitrogen and SF_6 being analyzed, influence on contact for the formic acid, toluene, carbinol and distilled water being analyzed, it was showed that the influence on performance parameters of relay contact for various atmospheres is very com...
通过比较触头材料Ag和Pd分别在氮气和空气中侵蚀凹坑的形状特征,分析了氮气和SF6等气氛对触头侵蚀、熔焊、耐压的影响,及甲酸、甲苯、甲醇、蒸馏水等对触头的影响,表明各种气氛对继电器触头性能参数的影响十分复杂,该影响涉及对电弧运动规律的影响和与材料的化学反应。
-
The results show as follows: Due to unfitting between the wheel tread and profile of Frog No. 9, two-point contact occurs between the wheelset and frog and the contact patches become narrow and long; the Von Mises stress and contact force in the area of the contact patch between the tread close to the flange and the frog are so great that they go far beyond the yielding limit and enter the plastic deformation stage; this will lead to serious wearing of wheelset treads and frogs.
结果表明,由于车轮踏面与9号辙叉的型面不配合,轮对与辙叉形成两点接触,且接触斑狭长,靠近轮缘处踏面和辙叉接触斑的应力及接触力非常大,其数值远远超过材料的屈服极限,进入塑性变形阶段,这将导致车轮踏面与辙叉的磨耗严重。
-
The essay discusses the calculation and selection of body-form co-efficient for double contact lines suspension in urban mass transit, analyzes the affection from wind displacement of contact line, calculation of span , curvature of mast and calculating load and recommends that the shield between contact lines shall be considered for wind load of multi-contact lines.
对城市轨道交通双导线接触网悬挂风载体型系数进行了计算选用方面的探讨,并对接触线风偏移、计算跨距、支柱挠度和计算荷载的影响进行了分析,建议多导线的风载情况应考虑导线间的屏蔽作用。
- 相关中文对照歌词
- Intro
- First Contact
- Contact High (Demo)
- Angles
- Angle Park
- Contact
- Cypher With Self
- Contact
- I Have The Touch
- Contact High
- 推荐网络例句
-
Vishnu entered a dark fourth dimensional dream that did not support his field or continued life.
毗瑟挐进入了一个第四密度的黑暗梦想,那里并不支持他的能量场或继续生命。
-
Leaders and decision-making persons use it to collect the data, including the information of unit work, handing in fee, oweing fee, prepaying fee,changing and afterpaying and account transfering of joining-insurance employee, and account paying of all kinds of insurances from hospitalization insurance institutions.The collected data is picked up, organized, switched and showed to user.
该子系统主要面向各级领导、决策分析人员;从各个医疗保险经办机构和定点医疗机构采集数据,包括在各个医疗保险经办机构处理的单位办公信息,单位缴费、欠费、预缴费信息,参保职工变更信息,参保职工增减变动信息,参保职工补缴信息,参保职工帐户划拨信息:包括各定点医疗机构处理的各险种帐户支出信息,各险种的统筹金支付信息等;将采集的数据提取,组织和转换,然后展示给用户。
-
BaTan focus on the town in order to speed up the construction of the town as an opportunity to carry first to target in order to handle the project for a breakthrough to achieve industrialization and urbanization as a development engine.
八滩镇以加快重点镇建设为契机,以进位争先为目标,以项目突破为抓手,把实现工业化、城镇化作为发展的重要引擎。