查询词典 constant pressure

Heat absorbed or radiated during a change of phase at a constant temperature and pressure.

在恒定的温度和压强下某物质改变状态时所吸收或放出的热量。

This model was finely fitted by theexperimental results and was used to calculate the activation area,which was 0.127 〓/mol with little dependence of subphasetemperature. The positive activation area indicate that there is anincrease in area when the activated complex is formed, increasingthe surface pressure should decrease the rate constant and that theactivated complex is unimolecular in nature.

在一系列实验曲线的基础上，我们提出测量的面积变化应该由聚合中分子结构变化引起的急剧的瞬时面积变化与随后的与此面积变化相反的弛豫过程两部分组成，并据此提出一种反应动力学模型，此模型与实验结果相当吻合，此模型用于处理聚合速率的紫外光强依赖性，得到聚合速率常数近似与光强成二次幂指数关系；此模型也被用于计算活化面积，发现活化面积为〓，几乎与温度无关。

If the substrate material of planeness badnessand scaleslinearlywith in large, solid, it is difficult to maintain a constant business card printing and membership card making pressure, it is very prone to business card printing and membership card making pressure, imprinted holdout attachthemselves poor and ink color piles'quality.

如果承印物质料的裂缝量欠好，伸缩性不小，浮松性不不对，难以保留恒定的制卡和会员卡制作压辛，很便当爆发制卡和会员卡制作压辛不平衡、痕迹不朱层附着不牢和不朱色发花质量弊病的。

The relationships between gas pressure and volume in the pressure accumulator under the conditions of the state of constant temperature and thermal isolation are measured, and practical gas polytropic exponent is fitted.

对蓄能器气体等温状态变化和绝热状态变化下的气体压力-容积变化特性进行实验测试，并拟合出实际的气体多变指数。

For the simplist thermal consolidation problem with instantaneous constant surface temperature and uniform initial pore-pressure, analytical solutions of excess pore-water pressure and temperature are derived and compared in detail, respectively. The results show that the thermo-mechanical coupling item in the thermal consolidation equation can be ignored.

2对最基本的地表骤然受常温且初始孔压均布的一维热固结问题，分别求得了考虑和不考虑热力耦合的超静孔压和温度增量的解，并通过详细比较，表明可以忽略热固结方程中热力耦合项对固结的影响。

Methods: Compare the forged alumina by low-pressure, constant-temperature dryness with by accustomed pressure dryness and traditional smithing dryness.

以低压恒温干燥法煅制的枯矾与传统火煅及常压恒温干燥法煅制的枯矾质量进行比较。

The experiment, simulating the depletion drive development with constant-volume, studied the influence of gas production of a single layer when double layers commingled production under different initial pressures, the changing rule of pressure, gas production contribution of a single layer, gas recovery efficiency, prorating production and initial pressure difference of high-Low gas reservoir on production.

结合气藏实际，采用气藏天然岩心，建立了高低压双气层无窜流物理模型，实验模拟气藏定容衰竭开采方式，研究了不同初始压力双气层合采时单层产气、压力变化规律，单层产量贡献特征，气层采收率，配产、高低压气层初始压差对生产的影响等方面，取得了一定的认识。

By using the pules echo ultrasonic technique with 10 MHz. the ultrasonic velocities of the amorphouse carbon and their pressure dependence have been measured in the pressure up to I GPa. We have calculated its second, third- and combinations of forth-order elastic constants, and have researched its Gruneisen constant.

本文报导了利用10MHz超声脉冲&回波重合法&，测量非晶碳的声速及其在1GPa压力以内的变化规律，得到非晶碳的二阶弹性常数，三阶弹性常数及组合的四阶弹性常数，从而进一步计算和研究非晶碳的Gr？

In a general way, auxiliary time is associated with the structure of filter press characteristics of slurry and application of automatic system, given thickness of filter chamber filtration pressure squeeze pressure, moisture of filter cake, we can regard it as a constant which is independent of production capacity.

众所周知，厢式压滤机一个完整的工作周期还包括滤饼卸除、滤布清洗和重装滤机等不产生滤液的辅助工作时间，在给定滤室厚度、过滤压力、压榨压力的情况下，就可以认为辅助时间是与压滤机的生产能力无关的一个常数。

Single factor experiments were done with the factors including the width of protrusion and the trolley's velocity, which showed that the surface frictional coefficient decreases with the width of protrusion increasing, and doesn't change with the trolley's velocity changing, which was consistent with the results of the orthogonal experiment. A theoretical model of the horizontal projection of a corrugated bionic surface's contact area was built, which showed that the contact area's horizontal projection decreases with width and interval increasing respectively and that the ratio of the contact area's horizontal projection and the vertical load decreases with the vertical load increasing. It indicated that the surface frictional coefficient decreases with the above three factors increasing respectively. Finite element modeling and analysis of interactions of a plate and soils was done using ANSYS, which showed that the plate frictional coefficient is little relative to soil elastic modulus and decreases with vertical surface pressure and that trolley's pull and vertical displacement of bionic surface's control pilot keep constant almost during the plate being pulled. Finite element modeling and analysis of interactions of a corrugated bionic surface and soils was done using ANSYS, which showed that surface frictional coefficient is little relative to soil elastic modulus and decreases with bionic surface's structural parameters and vertical pressure increasing. However, the three factors all didn't affect the surface frictional coefficient remarkably on the condition of 90% dependability. For the first time, bionic surfaces were applied to screw piles, which formed bionic screw piles, and the contrast experiments showed the bionic screw pile had certain resistance-decreasing effects.

建立了波纹型仿生曲面与土壤的接触面积的水平投影的理论模型，表明接触面积的水平投影A随着波纹型仿生曲面突起宽度、两相邻突起间距的增大而减小，接触面积的水平投影与波纹型仿生曲面表面垂直载荷之比随着波纹型仿生曲面表面垂直载荷的增大而减小，进而得出仿生曲面摩擦系数随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小；利用ANSYS软件对平板与土壤的相互作用进行了有限元建模与分析，表明平板摩擦系数与土壤弹性模量关系不大，而随着表面垂直载荷的增大而减小；平板牵引过程中台车牵引力和仿生曲面控制节点垂直方向位移基本保持不变；利用ANSYS软件对波纹型仿生曲面与土壤的相互作用进行了有限元建模与分析，表明波纹型仿生曲面系数在一定范围内基本不受土壤弹性模量的影响，随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小，但在可信度为90％的前提下，三个因素影响都不显著；首次将波纹型仿生曲面应用于与土壤作用方式以挤压为主的螺旋桩，形成仿生螺旋桩，并与普通螺旋桩进行了沉桩对比试验，表明波纹型仿生曲面应用于螺旋桩桩体表面具有明显的降阻作用。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新