查询词典 consolidation pressure

Abstract］ objective to understand the medical institutions in the use of pressure steam sterilizer in the effect and the influencing factor,explore regulatory measures.methods with the spot investigation and scene examination,3mtmattest pressure steam sterilization and biological indicator train was used to monitor the effectiveness of disinfection.results in the monitoring of the 238 chinese medical institutions equipped with pressure steam sterilizer 337 units,the sterilization rate was 95.2%,medical institutions had different levels of disinfection and sterilization equipment,a large gap was between the level of management,equipment failure,non-standard operation,operator training without sterilization were the main reasons for failure.conclusion in medical establishment with the pressure steam sterilizer,antiseptic qualified rate is not too high,strengthening the pressure steam sterilizer purchase card management,standardizing the operation,stepping up supervision are the key to increase pressure steam sterilizer sterilization effect.

目的 了解医疗机构使用中压力蒸汽灭菌器使用效果及影响因素，探讨监管措施。方法采取现场调查及现场检测相结合的方法，采用3mtmattest压力蒸汽灭菌生物培养指示剂进行消毒效果监测。结果在监测的238家医疗机构中共有压力蒸汽灭菌器337台，灭菌合格率为95.2%，各级医疗机构对消毒灭菌设备的管理程度差距较大。设备发生故障、操作不规范、操作人员未经培训等是造成灭菌不合格的主要原因。结论医疗机构使用中压力蒸汽灭菌器灭菌合格率不高，加强对压力蒸汽灭菌器进货索证管理，规范操作，加大监管力度是提高压力蒸汽灭菌器灭菌效果的关键。

The calculation and experiment results show that the maximum lifting pressure performance decreases with the increase in throat diameter of channel of variable section, water flux of low pressure and pressure ratio of steam nozzle, and has its minimum value with water nozzle annular space. The coefficient of maximum lifting pressure performance may be as high as 26. In the design of steam injector, the larger pressure ratio of steam nozzle and the smaller water nozzle annular space are selected, the higher lifting pressure performance could be obtained.

计算及研究表明：极限升压能力随变截面混合腔喉部直径、被升压的低压水流量和蒸汽喷嘴压比增加而降低，随环形水喷嘴间隙的变化出现了最小值；计算得出变截面超音速汽液两相流装置的极限升压能力可达26；在设计升压装置时应尽可能选取较大的蒸汽喷嘴压比和较小的环形水喷嘴间隙。

It works as shown in Figure 2b, when the work when the system is high pressure, EF mouth also in high pressure, high pressure Balance Valves unloading of oil equivalent one-way valve open and the unloading valve 3 1 contact; when the pressure exceeds the safety valve unloading having a set pressure, unloading relief valve to open, the return oil through oil path b to uninstall the spool 4, left, unloading Safety valves valve spring to overcome the spring force 5, unloading spool shifted to the right, EF population of high-pressure oil through direct discharge port T Dutch tank.

其工作原理如图2b所示，当工作系统处于高压状态时，EF口也处于高压状态，高压油打开等值卸荷单向阀3与卸荷安全阀1接触；当压力超过卸荷安全阀调定压力时，卸荷安全阀开启，其回油经油道b到卸载阀芯4左端，克服卸载阀弹簧5的弹簧力，卸载阀芯右移，EF口的高压油经T口直接卸荷油箱。

As a result of diamond, cubic boron nitride of high prices, with good wear resistance, and the consolidation of their manufacturing and general abrasive abrasive abrasive different consolidation, with the exception of super-hard abrasive layer, there are transition layer and matrix.

由于金刚石、立方氮化硼的价格高、具有很好的耐磨性能，用它们制造的固结磨具与普通磨料固结磨具不同，除超硬磨料层外，还有过渡层和基体。

On the base of analysis concerning Tianjing and Tanggo-Xingang soil properties and observation results of settlements, some rules of settlement of buildings in the area were obtained. Final settlements, settlements at end of construction and the time of final settlement were discussed. Tests used for determining paramcters of four models were introduced. The parameters in Duncan-Chang model are determined from isotropic consolidation test and the parameters in Gong-Xiannan model from Ko consolidation tests while the parameters in the model proposedin chapter 2 from the equal increment stress ratio test and ones in the bounding surface model developed in chapter 3 from the effective stress-path of CIU test.

根据天津市区及塘沽新港地区的地基土质情况以及沉降观测资料，分析了该地区建筑物沉降的一些规律，讨论了最终沉降量，完工时的沉降量以及沉降稳定时所需要的时间，介绍了确定各模型参数所需要的试验：Duncan—Zhang模型参数根据等向固结的三轴试验确定；龚晓南Ko固结模型根据Ko固结三轴试验确定；本文建立的非线性弹性模型根据等向增量应力比试验确定，边界面模型参数可根据固结不排水剪切试验的有效应力路径确定。

Biot's consolidation theory was used to serve as a frame working with the nonlinear elastic model or with elasto-plastic model in the program. Nonlinear elastic model includes Duncan-Zhang model, Gong Xiannan Ko consolidation model and the model proposed in chapter 2. Elasto-plastic model in the program includes Mohr-Coulomb model, Drucker-Prager model and the bounding surface model developed in chapter 3. The program can be used in cases of plane problem and axisymmtric problem.

FOR，针对软土地基的变形特点，该程序以Biot固结理论为框架，可以进行线弹性，非线性弹性和弹塑性的有限元计算，在非线性弹性模型中包括了Duncan—Chang模型、龚晓南Ko固结模型和本文建立的非线性模型，弹塑性模型中包拓了Mohr—Coulomb模型，Drucker—Prager模型以及本文中建立的边界面模型，该程序可以考虑平面问题也可以考虑轴对称问题。

The patients achieved complete remission after induction course would enter the next grouping:the patients,aged 15-45 years, who had suitable donors and transplantation will were assigned to allogeneic stem-cell transplantation,and for the rest,they would be assigned to accept chemotherapy or autologous stem-cell transplantation randomly.CT and ASCT group both received early intensification and consolidation therapy orderly,which contained high-dose methotrexate,intermediate/high-dose cytarabine and high-dose or high-fraction cyclophosphamide,followed by ASCT or re-induction,later consolidation and maintenance chemotherapy for CT group.

符合入组条件的成人非Ph+ALL患者纳入研究，患者接受标准VDCP±L诱导治疗达到完全缓解(complete remission，CR)后进入下一阶段分组研究：年龄≤45岁，有合适供者及移植意愿者接受异基因造血干细胞移植allogeneic stem cell transplantation，Allo-SCT其余患者根据意愿分别接受自体造血干细胞移植(autologous stem cell transplantation，ASCT和化疗Chemotherapy。

The essential difference between a merger and a consolidation is that a merger results in one of the constituent companies being the surviving company as the other constituent company is merged into it whereas a consolidation results in a new consolidated company distinct from either of the constituent companies.

合并与整合的主要区别在于，合并需要其中一个成员公司作为留存公司，而另一个成员公司则并入；整合则需要成立一家新的公司，与其中的任何一个成员公司有所区别的整合公司。

Getting a debt consolidation quote is very much desirable when searching for a debt consolidation service or company.

获得债务合并报价，是非常可取的时候，寻找一个债务合并服务或公司。

The influence of consolidation is analysis by the improved transfer function method and finite different method that is used to calculate the consolidation degree.

本文运用差分法计算变荷载下多层地基的固结度，进而结合上述改进的传递函数法分析固结对路堤桩的影响。

This immediately brings us to the next part of this article: creating an output "replace function".

下面进入文章的第二部分：建立一个"缓存处理函数"。

He was elected as an International Ornithological Committee member in 2002 during the 24th IOC held in Beijing.

现为中国鸟类学会理事和WPA 专家组成员。2002年被推选为国际鸟类委员会委员。