查询词典 connector

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

This connector is a cylindrical (barrel-shaped) connector used to splice together two lengths of thick Ethernet coaxial cable.

这种连接器是一种圆柱形连接器，用于将两根以太网粗同轴电缆结合在一起。

The cap device includes a cap body having an inside transfer path for connecting an inlet opening for introducing the fuel and an outside transfer pipe, a fixed outer cap including a connector for fixing a discharge opening into which the transfer pipe is inserted, and an elastic opening/closing section in which the cap body is elastically compressible by the connector, and wherein the inside transfer path opens during the compression.

盖帽体具有用于将引导燃料的入口和外部输送管连接的内部输送通路。被固定的外盖帽包括使内部插有被固定的外盖帽的排放口固定的连接器，盖帽体通过连接器可弹性地被挤压在弹性开启/关闭部分中，挤压时内部输送通路开启。采用本发明的燃料箱即使燃料箱急剧摇摆或倾斜于其侧面也可以连续而平稳地提供燃料。

A new kind of fiber connector-tapered fiber connector is investigated in this paper.

介绍了一种新型的光纤连接器一锥形光纤连接器。

The tablet monitor also includes a first connector having two parts, each provided at the handle and the supporting stand, and each having a shape to correspond to each other to be detachably connected to each other, and a second connector having two parts, each provided at the monitor main body and at the supporting stand, and each having a shape to correspond to each other to be detachably connected to each other.

图形输入板监视器还包括第一连接器，它有两个部件，分别位于手柄和支撑架上，并且每的形状都彼此相适应以可拆卸地彼此连接，以及第二连接器，它有两个部件，分别位于监视器主体和支撑架上，并且每个形状都彼此相适应以可拆卸地彼此连接。

When the expansion board is not present, three jumpers must be inserted between pins 1-2, 5-6, and 7-8 on the expansion connector, as shown in Figure 12 - Expansion Board Connector Pin Out.

没有扩展板的时候，必须在插脚1-2， 5-6， 7-8之间插入3根跳线，如表12所示－扩展板连接器外围插脚。

The DC power supply wire and connector wire drawn from power supply box should wiring buried wire as possible, exposed wire must be fixed by holding latch; Notch on the ground between transmitting antenna support and receiving antenna support, so that bury power supply wire and connector wire, geosyncline's surface need be covered with stainless steel bead.

从电源盒引出的直流电源线及连机线，应尽可能布暗线，明线须用卡固定；发射天线架与接收天线架之间须在地面开槽，以便埋下电源线及连机线，地槽表面需用不锈钢压条封盖。

With the overall structure made of stainless steel, the sensor uses standard Hertzman connector and Hummel water-proof connector.

整体结构采用不锈钢材质，信号引出采用标准赫兹曼接头和胡默尔防水接头。

MMCX series RF coaxial connector is a more more small than miniature and insert mode MCX series RF coaxial connector.

MMCX系列射频同轴连接器是比MCX更小的微型插入式同轴连接器，被广泛使用在对体积和重量都有要求的小型通信设备和网络设备中。

I use the connector with the male housing in the plane, and the female/male connector on the charger.

我使用的连接器与男性房屋，在飞机上，与女性/男性连接器，充电器。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。