查询词典 condition equation

The phase of optical wave can be recovered by the intensity transport equation under the paraxial approximation For the optical system with diffraction limit, it is difficult to get the boundary radical slope of phase and sample in the circular domain boundary when using the intensity transport equation to recover the phase, consequently, we reviewed an algorithm mentioned in the reference ［4］, namely, the equation, computation domain and boundary condition are changed, then the phase is reconstructed by the multigrid method and corrected at last Moreover, the experiment system is set to testify the algorithm, and the recovered phase from the intensity data detected by CCD is compared with the result from phase retrieval algorithm, it is found that the phase reconstruction error can reach 017 λ in the case of non-uniform intensity distribution, as a result, the method is suitable for the phase recovery with low wavefront sensing accuracy.

在傍轴近似条件下，可以利用光强传播方程对畸变波前进行相位恢复。对于衍射受限的光学系统，很难获得相位的边界径向斜率值作为边界条件，此外，要获得精确的圆域边界采样值也并非易事。为了克服上述困难，进一步研究了相位恢复改进方法，即改变了方程的表示形式、计算区域和边界条件，并用多重网格法进行求解获得重构相位，最后再将其修正。为了验证算法的精确性，搭建了实验系统对算法进行实验验证，将由CCD探测的光强分布进行计算得到的相位分布与相位恢复算法的结果进行比较，证明在光强分布非均匀的情况下，该方法恢复的相位均方根误差能够达到017 λ，可以适用于波前传感精度要求不是很高的相位恢复。标签自适应光学相位恢复相位修正光强传播方程 adaptive optics phase retrieval phase correction intensity transport equation

Then, the kinematic model is modeled and the mobility is discussed in the paper. And the motion condition equation of the robot is gotten in sequence.

然后，建立了机器人的运动学模型，并讨论了机器人的移动性问题，得出机器人存在运动的条件。

Condition equation was set up to maintain the spectral properties in IHS image fusion, and a new model of fusion was established based on the simplified process.

通过对新模型的分析，本文提出了保持IHS 融合光谱特性的条件方程，通过对模型有效的简化进而提出了新的融合方法。

According to the development condition of zero flux plane, it can be divided into steady condition equation and variation condition equal ion.

在计算时段内，根据零通量面发育状态不同可分为零通量面稳定条件下的计算公式和零通量面移动条件下的计算公式。

In this paper, we invert the condition equation into a complete nonlinear partial differential equation, and study some properties of the solution of this equation from a theoretical point.

本文把其条件方程转化为一个非线性偏微分方程，从理论角度探讨了一下此方程的解的一些性质。

The last time when the valves open and close the boundary condition equation and heating systems in the other boundary condition equations, one-dimensional unsteady flow equations of motion and the joint solution of continuity equation, we can find the non-dimensional opening when the valve changes, heating system to calculate changes in surface pressure.

上回阀启闭时的边界条件方程与供热系统中的其它边界条件方程、一维不定常流动的运动方程和连续方程联解，就可以求出当止回阀无量纲开度变化时，供热系统各计算截面压力的变化情况。

However the lower order traditional absorbing boundary conditions are only effective for the incident waves with smaller incident angles. A fourth-order absorbing boundary condition equation based on Higden's ABC is deduced in this thesis, and a new algorithm is presented to automatically select the Higden's parameters.

本文基于Higdon提出的吸收边界条件方法，推导出四阶吸收边界条件方程，并提出了一种新的吸收边界条件角度参数的自动选择方法，使该吸收边界条件能够吸收全角度(0～90度)入射波。

A fourth-order absorbing boundary condition equation based on Higdon's ABC is deduced in this paper, and a new optimal algorithm is presented to automatically select the parameters of Higdon's ABC.

本文基于Higdon提出的渐进吸收边界条件方法，推导出四阶吸收边界条件方程，并提出了一种新的吸收边界条件角度参数的优化选择方法。

In this topic, the dynamic analysis methods for piezoelectric vibrator are studied systematically based on the theoretical model, FEM numerical experimentation and FEM governing equation for given compound-mode vibrator, and some valuable conclusions are obtained. The main work accomplished is summarized as follows: 1.Elaborate the main modeling methods for piezoelectric vibrator and the significance and necessity to study the dynamic characteristics of piezoelectric vibrator which emphasize the urgency of this paper. 2.Take the bending deformation induced by piezoelectric ceramic as example, the energy transfer mechanism of electric energy to mechanical energy are analyzed; the motion and force transfer mechanism are analyzed for the longitudinal-bending vibrator. 3.Based on mode assumption and Hamilton principle, the coupling model of piezoelectric vibrator of linear USM is built; moreover, the equivalent circuit model is obtained and a coupling equation represents the relation between electric parameters and mechanical parameters is derived which provides foundation to match the vibrator and driving circuit. 4.Combine the constitutive equation of piezoelectric ceramic with elastic-dynamical equation, geometric equation in force field and the Maxwell equation in electric field and the corresponding boundary condition equation, the FEM control equation for piezoelectric vibrator of USM to solve dynamic electro-mechanical coupling field is established by employing the principle of virtual displacement. The equation lays the foundation to study the non-linear constitutive equation of piezoelectric ceramic driven by high-power. 5.Define the dynamic indexes of characteristic of vibrator and carry out variable parameters simulation by calculating the model parameters and the electric characteristics of vibrator are simulated according to the equivalent circuit model. By numerical experimentation, the working mode of vibration of vibrator and the shock excitation results of the working frequency band which provides the mode frequency to realize bimodal are analyzed. Detailed calculation of the electro-mechanical coupling field parameters is made by programming the FEM control equation.

本课题从理论模型、有限元数值试验、有限元控制模型等方面以复合振动模式振子为例对超声电机压电振子的动力学特性及其分析方法进行了全面系统地研究，得出了许多有价值的结论，主要概括如下： 1、阐述了目前针对超声电机压电振子的主要建模方法，对压电振子动态特性的研究意义和必要性进行了论述，突出了本文研究内容的迫切性； 2、以压电陶瓷诱发弹性体发生弯曲变形为例，分析了压电陶瓷通过诱发应变来实现机电能量转换的机理；对基于纵弯模式的压电振子的运动及动力传递机理进行了分析； 3、基于模态假定，利用分析动力学的Hamilton原理，建立了面向直线超声电机压电振子的机电耦合动力学模型，并据此建立了压电振子的等效电路模型，导出了电参量与动力学特性参量的耦合方程，为压电振子与驱动电路的匹配提供了依据； 4、从压电陶瓷的本构方程出发，综合力场的弹性动力学方程、几何方程、电场的麦克斯韦方程以及相应的边界条件方程，采用虚位移原理，建立了压电振子动态问题机电耦合场求解的有限元控制方程，为研究其大功率驱动下的非线性本构模型奠定了基础； 5、界定压电振子的动力学特性指标，对压电振子的机电耦合动力学模型参数进行计算及变参数仿真；依据等效电路模型，对压电振子的电学特性进行了仿真分析；通过有限元数值实验，对压电振子工作模态附近的模态振型及工作频率附近的频段进行了激振效果分析，找出了实现模态简并的激振频率；利用有限元控制方程，通过编程计算，对压电振子的力电耦合场参数进行了详细计算，得出了一些有价值的结论。

The third thermal boundary condition equation joined with the degradation rate of interior wall was used to get the contour of interior wall vs. time under the condition of identical heat flux between fluid and solid in axis direction. The numerical simulation results agrees well with that of measurements.

在气流与固壁之间的热流量沿轴向一致的条件下，通过加入降解退移速率的第三类热边界条件方程，求解出不同时间管内壁面轮廓沿轴向变化情况，模拟值与试验结果基本吻合。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。