查询词典 condenser

Therefore, at the time of installation and maintenance of condenser, the vacuum system precision of condenser should be achieved as far as possible.

因此，在凝汽器安装与维修时，应尽可能使凝汽器真空系统达到严密。

In order to obtain higher vacuum degree for condenser, the saturation temperature of steam inside the condenser should approach the temperature of cooling water in all likelihood.

为使凝汽器获得较高的真空度，就要使凝汽器内蒸汽的饱和温度尽可能接近冷却水温度。

The purpose is to increase the hot exchange potentiality of the steam condenser and improve the vacuum of the steam condenser.

通过对2号汽轮机低压缸排汽通道进行优化改造试验，发挥了凝汽器铜管的热交换潜力，提高了凝汽器真空度。

Since the condenser pressure depends on condensation temperature, the factor influencing condensation temperature is also the factor influencing vacuum degree of condenser.

由于凝汽器压力取决于凝结温度，因此，影响凝结温度的因数也就是影响凝汽器真空度的因数。

In the operation, many factors have influences on vacuum degree of condenser, among which the main factors are: inlet temperature of cooling water, flow rate of cooling water, tube bundle surface cleanness of condenser and vacuum system tightness, etc.

在运行中，影响凝汽器真空度的因数很多，其中主要有：冷却水进水温度、冷却水的流量、凝汽器管束表面的清洁状况，以及真空系统的严密性等。

The steam condensation, condenser vacuum and the condenser performance are improved.

正确合理地模拟和预测凝汽器壳侧汽相流动和传热特性，对凝

The tube bundle is the main composition of condenser. Its reasonable arrangement and layout can determine the condenser vacuum degree, condensate supercooling and oxygen content.

管束是凝汽器的主要组成部件，管束的排列方式和布置是否合理，对凝汽器的真空度、凝结水的过冷度和含氧量均起着决定性作用。

With the established model, the optimization model of condenser is proposed to determine the best vacuum value of condenser and energy loss resulted by deviation of some main operation parameters, reduce the energy loss by optimize the controllable parameters.

在此基础上，建立发电功率与凝汽器真空的优化模型，确定热力系统各主要参数对汽轮机功率的影响以及凝汽器真空的运行应达值，以机组的最优运行为目标，优化可控参数，达到降低能耗的目的。

The influence of the seal water temperature of water ring vacuum bumps on the condenser pressure is analyzed quantitatively,and the relationship between the condenser pressure and the unit efficiency was identified with equivalent enthalpy drop method.

定量分析电厂水环式真空泵密封水温度对凝汽器压力的影响，并利用等效焓降法得到凝汽器压力与单元机组效率的关系，从而得到真空泵密封水温度和单元机组经济性的定量关系。

Condenser is made up of heat exchange components, tube-bearing board, cover of water tank, casing of condenser and airproof parts, etc.

冷凝器由换热元件、承管板、水箱盖、冷凝器壳体和密封件等组成。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。