查询词典 concrete layer

The repair of the cement concrete pavement is very difficult, there are two kinds of measures mainly both at home and abroad: the first one is adding asphalt concrete layer, the second one is adding cement concrete layer.

对水泥混凝土路面的修复比较困难，国内外常用的措施主要有两种：第一种为加铺沥青混凝土面层，第二种为加铺水泥混凝土面层。

YTS compound is mainly used to warm foaming agent concrete foam insulation, foam concrete insulation, thermal insulation layer of the production, it could cement, magnesia, lime, gypsum, powder, sawdust, fly ash, sand, Pak Nai paper sludge and other raw materials, foam, made of foam concrete, wall board, lath, block, hollow brick, heat pipe protection kits, roof insulation foam board and other lightweight building materials, also can be used for the production of roofing insulation layer.

HTD-1型复合发泡剂主要应用于地暖泡沫混凝土绝热层、泡沫混凝土隔音、保温垫层的生产，其可对水泥、氧化镁、石灰、石膏、石粉、锯末、粉煤灰、沙、造纸废渣白泥等多种原材料发泡，制成泡沫混凝土、隔墙板、板条、砌块、空心砖、实心砖、热力管道保护套、屋顶隔热板等多种轻质泡沫建材，也可用于屋面保温隔热层制作。

Based on Three Gorges Project, the following aspects about the three typical embedding manners are studied:(1) The border condition of cyclic symmetry is applied to the finite element models with contact among cushion layer, penstock and concrete. The effects of elastic modulus, thickness and placement extent of cushion layer on the stress of its around concrete are analyzed. It is suggested that the ratio of thickness to elastic modulus can be used as an important parameter in the design of cushion layer.

因此，本文结合三峡工程建设实践，在收集和总结前人经验的基础上，以大型通用有限元分析软件ANSYS为平台，对不同埋设方式的巨型蜗壳结构进行以下几个方面的研究：(1)引入循环对称边界条件，考虑垫层-钢板-混凝土之间的接触摩擦，建立有限元模型；并对垫层敷设范围、垫层厚度和弹性模量等设计关键参数进行了优化，并把"垫层弹性模量与垫层厚度之比"作为参考指标进行设计。

For the slope protection,domestic and foreign have various methods,such as:clean surface, and shotcrete stone surface and the use of concrete,asphalt,riprap,etc.,but these have a fatal weakness,the use of clean face,and shotcrete stone surface and the use of concrete,asphalt,riprap protection methods such as the slope,often due to excessive destruction of the human impact of the original natural and ecological environment.so that the entire road is almost formed a gray line,and While these protective measures outside the slope formed a protective layer of solid layer,but if there is a protective layer of water into the lower water flow and form,these protective measures will also be destroyed.

对于边坡的防护，国内、国外均有多种方法，比如：抹面、喷浆、石砌护面以及利用混凝土、沥青、抛石等等，但这些都有着致命的弱点，利用抹面、喷浆、石砌护面以及利用混凝土、沥青、抛石等方法进行防护的边坡，往往由于过多的人为影响破坏了原来的自然生态环境，使整条公路几乎形成一条灰色的路线，同时，这些防护措施虽然在边坡外面形成了一层坚固的防护层，但只要有水渗入防护层下部并形成水流时，这些防护措施也将被冲毁。

When the thickness of the concrete layer is 50 mm, and that of the asphalt layer is less than or equal to 150 mm, an increase in strain at the bottom of the concrete layer with the increased load is significantly greater.

当厚度的混凝土层是50毫米，吗沥青面层的小于或等于1.5毫米，增加在紧张的底部的混凝土层增加负荷显著增加。

The cement concrete road surface is made up of road bed and road surface , two major parts ,, and form various kinds of shops of road surface to build layer, one layer of location and function in it, divided into surface layer , the basic unit and cushion layer mainly.

水泥混凝土路面是由路基和路面两大部分组成的，而构成路面的各种铺筑层，按其所处的层位和作用，又主要分为面层、基层和垫层。

In addition, some modifications on several computational methods are also presented. Using LMTO method the electronic structure of several systems are studied, and some results are obtained. They are: The ideal Nb (100) surface has three surface states, the multi-layer relaxed surface has two surface states. The surface energy of the ideal surface is higher than that of the relaxed surface, that means that the multi-layer relaxed surface is more stable than the former one, which supports the LEED results. The mono-layer relaxed Ag (111) surface is the most stable one among several" stable surface models"presented by several researchers. The surface energy of Ag (111) surface is higher than that of surface Ag (001), which supports some experimental results such as different reaction rate at different surface orientations for the same material. The surafce states of Si (111) surface not only locate near the Fermi level, but also in the valence band, which agrees well with Cohen's conclusion. Si (111)-H is an effective model for analysing the surface states and H adsorbed on the back surface is a good method for improving the convincingness of the results obtained on thinner slab models. The surface stability depends on three different kinds of MoSi〓(001) surfaces, the surface with mono-layer Si is the most stable one, and the surface with Mo at the first layer is the most unstable one among them. These are consistant with the Kemoda's experimental results. The valence bands of clean or K adsorbed CdTe (111) surface agrees well with the synchrotron radiation studies. The surface of CdTe (111) consists of four kinds of surface models which show different surface electronic structures and different surface structure stabilities. The conclusion agrees well with Wu's experimental work. The different absorbed alkali metals on the CdTe (111) surface give different adsorption characteristics which have relations not only with the valence electrons, but also with the core ones of the alkali metals. The electonic structures of Si-C alloys are different from that of Si-Ge alloys, and the energy band gaps of Si-C alloys do not increase linearly with Carbon concentration, our conclusion supports Alexander's results, but conflicts with Soref's one.

现分述如下： LMTO方法及其应用方面：1）通过对Nb（100）表面电子态分析发现清洁理想表面有三个表面态，多层弛豫表面有两个表面态；表面能大小说明多层弛豫表面更稳定，支持了LEED结果。2）通过对采用不同方法获得的几种不同Ag（111）表面稳定结构的表面能计算分析，给出了单层弛豫表面为Ag（111）表面的最稳定结构；从Ag（111）单层弛豫表面和Ag（001）表面的表面能比较，发现了Ag（001）表面表面能要比Ag（111）小的，表明了同种物质不同表面取向将表现出不同物理、化学性质，这是与实验中得出的结论是吻合的，3）通过对Si（111）表面态分析，不仅发现了Si（111）表面不仅具有居于费米能级附近的悬挂键所对应的表面态，而且还有很多表面态位于价带能量范围内，与Cohen等结果一致，H饱和slab模型背表面相当于增加了slab层的厚度，是一有效的变相增加slab层厚的方法，弛豫表面较清洁理想表面价带谱们低能端的少许移动，预示着总能降低，说明弛豫表面较清洁理想表面稳定。4）MoSi〓具有三种表面，从费米能级上态密度值大小得到单层Si表面最稳定，Mo原子为表层原子的表面最不稳定，双层Si原子表面居中的结论，这与Kemoda等人实验结果是一致的。5）通过对CdTe（111）表面表面电子态、表面结构稳定性及表面H、碱金属吸附的电子结构系列研究，不仅得出了CdTe（111）清洁及碱金属K吸附价带谱与同步辐射光电子谱相吻合的结果，而且发现了CdTe（111）表面具有四类不同原子近邻特征，表现出四类不同的表面结构及电子结构特征：不同表面态分布、不同的表面结构稳定性（表层原子与次层原子成三键有一悬挂键的表面要比表层原子与次层原子成一键有三悬挂键稳定（与Wu等人实验结果一致））、不同的H吸附特性。

The main results of the investigation are as following:(1) Some important criteria for the design of multi-layer structure are acquired: the ratio of the layer thickness to the contact diameter should be controlled to a value about 0.8; increasing the number of the gradient layers and elasticity modulus of the top layer would benefit to the yield strength and the stress status at the interface.（2）By means of molecular dynamics simulations for a indentation and sliding process, it is discovered that dislocations of 45 direction to the surface occur in the surfaces layer, which is correspond to the direction of the plastic flows observed in the macroscopic continuous medium. The irreversible deformation caused by the dislocation and the atom piles at the surface are responsible for the irreversibility of the force response. They are also the main factors for the friction generation. The temperature and the indentation velocity have significant effects on the deformation behaviors of the material of the surface layer. The yield strength would increase obviously if the indentation velocity is greater than 10 m/s.（3）A method to evaluate the fracture toughness of coating by estimating the crack-density functionβof a Wicker''s indentation was proposed. Meanwhile a new surface treatment technology was developed using non-equilibrium plasma.（4）A MD-FE hybrid method and corresponding software was developed to analysis the tribological behaviors for multiplayer system.

研究主要内容和结果有：（1）得到指导梯度膜设计的几个准则：控制膜层厚度与接触半径比在0.8左右为宜；适当增加梯度层层数和顶层弹性模量，有利于提高抗屈服能力和改善界面处的应力状态；（2）通过对嵌入和滑动摩擦过程的分子动力学模拟，发现表层产生一个与宏观连续介质的塑性流动方向观测一致的45 方向位错；位错造成的不可逆变形和表面的原子堆积，是力的响应不可逆性的原因，也是构成摩擦力的主要因素；温度和嵌入速度对材料变形特性有显著的影响，当嵌入速度大于10 m/s时，屈服强度明显增加；（3）提出压痕裂纹密度系数β半定量判定膜层断裂韧性的方法；并开发出表面强化新工艺；（4）开发出分析表面摩擦学特性的MD-FE复合模拟方法和相应模拟软件。

He also suggested the five layers of neurosis that could block individual growth, which were phony layer, phobic layer, impasse layer, implosive layer and explosive layer.

皮尔斯人格思想和理论的贡献主要表现在：首先，它促进了现代人格理论的发展；其次，它促进了存在心理学在美国的发展；再次，皮尔斯以此为基础创建了独特的格式塔疗法。

The results of immuhistochemistry show: compared with normal retina, more 3-NT-positive cells and iNOS-positive cells appear in inner nucleus layer of diabetic retina; less eNOS-positive cells appear in inner nucleus layer and vascular endoderm of diabetic retina; less nNOS -positive cells appear in inner nucleus layer of diabetic retina; more ET-positive cells, ETRA- positive cells, ETRB- positive cells appear in inner nucleus layer of diabetic retina; moreα- synuclein- positive cells appear in ocular cone and rod layer of diabetic retina. Conclusions 1. RFDD-PCR is an efficient technique for research diseases genomics as a mass screening to complete gene expression with the identifying of candidate gene related to disease.

免疫组织化学结果显示：13-NT和NOS：与正常视网膜相比，8周糖尿病大鼠视网膜中，INL的3-NT和iNOS免疫阳性细胞明显增多，INL和血管内皮层的eNOS阳性细胞明显减少，INL的nNOS阳性细胞也明显减少；2ET及ETR：与正常视网膜相比，8周糖尿病大鼠视网膜中，ET、ETRA、ETRB免疫阳性细胞明显增多，增多的阳性细胞主要集中于INL，而在血管内皮层增多不明显；3α-synuclein：与正常视网膜相比，8周糖尿病大鼠视网膜中，α-synuclein免疫阳性细胞明显增多，增多的阳性细胞主要集中于视网膜视锥视杆层。

Liapunov—Schmidt method is one of the most important method in the bifurcation theory.

Liapunov—Schmidt方法是分叉理论的最重要方法之一。

Be courteous -- even when people are most discourteous to you .

要有礼貌──即使当別人对你最不礼貌的时候。