查询词典 conclusion

At the same time it has some basic tactics: direct structure according as condition and conclusion, changing forms of condition and conclusion to indirect structure, structure according to basic mathematics structure and structure allelomorph.

在用数学构造思想方法解题时，往往根据条件或结论，直接构造、转变题设条件或结论的形式，间接构造、通过基本数学结构形式进行构造或构造对偶式，这是用数学构造思想方法解题的基本策略

On the basis of analysis of various combination methods, this paper proposes a method of using fuzzy Borda to get the comprehensive and integrated conclusion from the single evaluation methods. The conclusion is adjusted to meet the needs of different user preferences, and the adjusting rules are given in order to achieve the feasibility and reproducibility of the evaluation process.

在分析了多种组合评价方法的基础上，本文提出了采用模糊Borda法对单一评价方法得出的结论进行综合以得到综合评价结果，并根据不同的需要给出了对综合评价结果的较明确的调整规则，以满足不同用户的偏好，以期对评价工作可操作性和可重现性的实现具有一定的指导意义。

Compared with Borda and Copeland method,because this method further distinguishes "good" and "poor" level,the conclusion of combinational evaluation is more accurate,the degree of division is better and it has very good consistency with the conclusion of each comprehensive evaluation method.

与Borda法和Copeland法相比，该方法通过进一步区分"优"和"劣"的程度，使组合评价结论更为精确，区分度更好，且与各综合评价方法的结论具有很好的一致性。

Secondly, for the boundary correspondence of affine stretch on hyperbolic regions, we prove that the above conclusion is also true. Finally, we pose a sufficient and necessary condition for the same conclusion.

最后利用退化的四边形序列，给出了拟对称同胚的极值拟共形延拓的最大伸缩商、四边形模之比的上确界及拟对称同胚的边界伸缩商三者相等的一个充要条件。

II By calculating the unit exergy cost of the combined thermal power generation system using matrix model, validating the conclusion that the unit exergy cost of the whole system goes up gradually, and confirming the conclusion about the integration density influence on the systemic calculating results, it can be found that the unit exergy cost of the whole system goes up gradually because exergy loss increases with the exergy used to create exergy flux with the going-on of the process.

由此可以推知系统的集成度越低，子系统划分的越细，计算得到的结果越准确。（3）会计模式和矩阵模式方法在应用时有各自不同的侧重点和适用范围，矩阵模式方法在用于确定系统的划分即集成度的影响时有很大的作用，系统的划分明确对于整个计算至关重要；而会计模式方法在涉及到非能量费用的计算时有比较明确的思路和方法。

NET technology structure dynamic webpage in realizing in system, is it use personnel can choose to analyze the function through interface conveniently to make, the analysis result trends show with the chart; And has fully utilized treatment technology of running side by side, has considered the loss which sets up the index and resource proportionally, make systematic efficiency be optimized. Pass the imperial examinations at the provincial level several systematic example of practical application in thesis, if customer state analysis, income analysis, conversation situation analysis, is it transfer to situation analysis, rival analyze etc. to breathe out, having proved the system through the actual inspection of market analysis personnel, the analysis conclusion drawn from it is accurate, can be believed, and because of is it with chart, it makes to be very clear to analyze person, can catch the focal point easily to mix, have convincingness even more as to policy-making level of enterprises. System produce high benefit relatively already at present, can is it grasp message, consumption situation of customer in real time to realize easily through it, turn from enterprise policymaker to network analysis monthly demand of conclusion into and require that analyses rivals situation every day, draw occupation rate of market key index can know system become market important basis source of decision already, so, the realization of this project has greater actual meaning.

NET技术构建动态网页，使应用人员能方便地通过界面选择分析功能，分析结果动态以图表显示；并充分利用了并行处理技术，对建立索引与资源的损耗均衡考虑，使系统效率得以优化。3、在论文中举了几个系统实际应用的例子，如客户状态分析、收益分析、通话情况分析、呼转情况分析、竞争对手分析等，证明系统经过了市场分析人员的实际检验，从中得出的分析结论准确、可信，并由于配以图表，使分析人员一目了然，可轻易抓住重点，对企业决策层而言则更具说服力。4、系统目前已产生了较高的效益，通过它能轻易实现实时掌握客户的信息、消费情况，从企业决策者对系统分析结论的月需求变为要求每日分析竞争对手情况，得出市场占有率等关键指标可知系统已成为市场决策的重要依据来源，因此，本项目的实现具有较大的实际意义。

In addition, some modifications on several computational methods are also presented. Using LMTO method the electronic structure of several systems are studied, and some results are obtained. They are: The ideal Nb (100) surface has three surface states, the multi-layer relaxed surface has two surface states. The surface energy of the ideal surface is higher than that of the relaxed surface, that means that the multi-layer relaxed surface is more stable than the former one, which supports the LEED results. The mono-layer relaxed Ag (111) surface is the most stable one among several" stable surface models"presented by several researchers. The surface energy of Ag (111) surface is higher than that of surface Ag (001), which supports some experimental results such as different reaction rate at different surface orientations for the same material. The surafce states of Si (111) surface not only locate near the Fermi level, but also in the valence band, which agrees well with Cohen's conclusion. Si (111)-H is an effective model for analysing the surface states and H adsorbed on the back surface is a good method for improving the convincingness of the results obtained on thinner slab models. The surface stability depends on three different kinds of MoSi〓(001) surfaces, the surface with mono-layer Si is the most stable one, and the surface with Mo at the first layer is the most unstable one among them. These are consistant with the Kemoda's experimental results. The valence bands of clean or K adsorbed CdTe (111) surface agrees well with the synchrotron radiation studies. The surface of CdTe (111) consists of four kinds of surface models which show different surface electronic structures and different surface structure stabilities. The conclusion agrees well with Wu's experimental work. The different absorbed alkali metals on the CdTe (111) surface give different adsorption characteristics which have relations not only with the valence electrons, but also with the core ones of the alkali metals. The electonic structures of Si-C alloys are different from that of Si-Ge alloys, and the energy band gaps of Si-C alloys do not increase linearly with Carbon concentration, our conclusion supports Alexander's results, but conflicts with Soref's one.

现分述如下： LMTO方法及其应用方面：1）通过对Nb（100）表面电子态分析发现清洁理想表面有三个表面态，多层弛豫表面有两个表面态；表面能大小说明多层弛豫表面更稳定，支持了LEED结果。2）通过对采用不同方法获得的几种不同Ag（111）表面稳定结构的表面能计算分析，给出了单层弛豫表面为Ag（111）表面的最稳定结构；从Ag（111）单层弛豫表面和Ag（001）表面的表面能比较，发现了Ag（001）表面表面能要比Ag（111）小的，表明了同种物质不同表面取向将表现出不同物理、化学性质，这是与实验中得出的结论是吻合的，3）通过对Si（111）表面态分析，不仅发现了Si（111）表面不仅具有居于费米能级附近的悬挂键所对应的表面态，而且还有很多表面态位于价带能量范围内，与Cohen等结果一致，H饱和slab模型背表面相当于增加了slab层的厚度，是一有效的变相增加slab层厚的方法，弛豫表面较清洁理想表面价带谱们低能端的少许移动，预示着总能降低，说明弛豫表面较清洁理想表面稳定。4）MoSi〓具有三种表面，从费米能级上态密度值大小得到单层Si表面最稳定，Mo原子为表层原子的表面最不稳定，双层Si原子表面居中的结论，这与Kemoda等人实验结果是一致的。5）通过对CdTe（111）表面表面电子态、表面结构稳定性及表面H、碱金属吸附的电子结构系列研究，不仅得出了CdTe（111）清洁及碱金属K吸附价带谱与同步辐射光电子谱相吻合的结果，而且发现了CdTe（111）表面具有四类不同原子近邻特征，表现出四类不同的表面结构及电子结构特征：不同表面态分布、不同的表面结构稳定性（表层原子与次层原子成三键有一悬挂键的表面要比表层原子与次层原子成一键有三悬挂键稳定（与Wu等人实验结果一致））、不同的H吸附特性。

Six kinds method the main body of a book is changed right away: Avianize the condition closing a problem; Conceal the conclusion closing a problem; According to condition or relation already giving examination questions,discuss the various conclusion; Give out a conclusion , explore sufficient condition making a conclusion be founded; Some similarities and differences of marriage partner burn comparatively; Comment that in having explored the various method of solving and conclusion , having been in progress in actual scene.

本文就变化的六种方法：弱化封闭题的条件；隐去封闭题的结论；根据已给题目的条件或关系，探讨多种结论；给出结论，寻求使结论成立的充分条件；比较某些对象的异同点；在实际情景中，寻求多种解法与结论，进行了论述。

Mendel had already found evidence for this conclusion.

Mendel已经发现的证据表明这一发现， conclusion。

This latter being I call "first," and from what you grant, it is clear that anything other than this is not first. Furthermore, it follows that if the first cannot be produced, then it has no causes whatsoever, for it cannot be the result of a final cause (from conclusion two of chapter two)—nor of a material cause (from the sixth conclusion of the same)—nor of a formal cause (from the seventh conclusion there). Neither can it be caused by matter and form together (from the eighth conclusion there).

这后一种存在我称之为&第一性&，由我们设定的前提看，只有这一存在而不是其他能够称为第一性，而且，如果第一性是不能被产生的，那它在任何意义上都无所谓原因，因为它不可能是一个终极因的结果，也不可能是质料因的结果，也不可能是形式因的结果，也不可能由形式因和质料因共同产生。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。