查询词典 computer hardware

In its analysis, different parts of the computer from hardware to software will be put under scrutiny.

在其分析，不同地方的电脑从硬件到软件将根据检查。

The motor is competent for long low-speed or stopping up and the clutch has fine characteristic of control with torque. Sensors as forward access obtain signal, an industrial computer with abundant hardware resource as background utilize set-in boards based on PCI bus and serial modules to fulfill data transmission and instruction communication.

传感器作为前向通道拾取各信号，后台以工业控制计算机丰富的硬件资源为基础，利用基于PCI高速总线的插卡式测量板卡和串口模块实现与计算机的数据传输和命令通讯。

So we designed a adaptive synchronizing controller based on hereinbefore hardware environment: first a small magnitude reference signal r is outputted to system through the signal card (to ensure that the vibrating system works in a linear state), and this signal is sent to the moving coil of vibrator through the power amplifier, so vibration is produced through electromagnetic induction. Secondly the vibration signal can feedback to the data acquiring card in the servo system through the acceleration sensor on the Vibroseis reactor M〓 and the base-plate M〓, then the computer can get the current vibrating state y〓 of the coil of vibrator according to the feedback information from the data acquiring card, and give a real time comparing between the current state y〓 and the reference output y〓 of the set-in reference model with current reference input being r , then regulates the correlative controlling parameters according to the error e〓=y〓-y〓 till y〓→y〓, finally normal signal sweeping begins with a certain phase fixed. Meanwhile a synchronization signal for seismic signal record is sent to seismograph from synchronization signal outputting component in the Vibroseis system to perform the controlling process of synchronization of sweeping phases.

为此，我们基于以上的硬件环境设计了一个自适应同步控制器：首先通过信号发生卡对系统输出小幅度的参考信号r(从而保证振动系统工作处于线性状态)，信号通过前置放大器、功率放大器等送到激震器动圈，并通过电磁感应产生振动，振动信号通过可控震源激震器反应块M〓和基板M〓上的加速度传感器反馈给伺服系统中的数据采集卡，工控计算机根据采集卡的反馈信息，获取当前激震器动圈的振动状态y〓，并实时地将该状态与内置的参考模型在当前参考输入r下的参考输出y〓进行辨识，再将两者输出误差e〓＝y〓-y〓对系统的有关控制参数进行调整，直至y〓→y〓，最后在经过某一固定的相位后，开始信号的正常扫描过程，与此同时，由可控震源系统的同步信号输出部件向地震仪送出一地震信号记录同步信号，进而完成扫描相位同步控制过程。

Cairo image engine makes the indication hardware of browser and computer more shirt-sleeve.?

Cairo图像引擎让浏览器与电脑的显示硬件更融合。？

In the earlier work D. Husinga developed a Matlab computer program that traded adders for delays, optimized scaling and used Canonic Sign Digit techniques to reduce hardware requirements for fixedcoefficient FIR filters .

在先前的工作4 Husinga开发了基于Matlab的计算机程序交易加法器的延迟，优化调整和使用法服注册位数技术，以减少硬件要求fixedcoefficient FIR滤波器。

The former is the core of hardware, it is based on industrial control computer that expended with analog signal input board and digital signals input and output board.

其中工控机是自动化测试系统的硬件核心，在工控机内扩展了数据采集卡和数字量I/O卡，完成对电源输入、输出信号的采集和对系统的控制。

Its hardware is composed of a portable computer、 NI data acquisition card、 signal pretreatment box and sensors. Its software is programmed under Labview.

系统硬件由一台便携式笔记本计算机、NI数据采集卡、信号调理箱、传感器组成，软件在Labview图形化编程环境下开发。

Design and amelioration design the hardware circuit of system: It is composed of main computer, capacitance moisture sensor, electronic balance and signal conversion box. Capacitance moisture sensor is the core of the system.

由此可见，采用神经网络技术对容重、温度及电容测量值进行融合后建立的校正模型，能够解决系统的温度、容重补偿和非线性校正问题，从而提高了系统的检测精度。

The hardware includes industrial control computer, high sample rate DAQ card and signal transform box, and the software is designed based on Labwindows/CVI.

该测试系统硬件部分主要由工控机、高速数据采集卡及信号调理箱构成，软件部分基于NI公司的Labwindows/CVI虚拟仪器开发平台设计。

The eCAN module in the signal processor TMS2812 is introduced. Its correspondence partial hardware and the software design method with the CAN bus between correspondence is given. The OPC server is used for host, slave computer I/O driver, which has enhanced the ability of the scene intelligence measuring appliance computation complexity and system real-time communication.

详细介绍TMS2812信号处理器的eCAN模块以及其与CAN总线之间的通信，并给出其通信部分硬件和软件的设计方法，采用OPC服务器为上、下位机的I/O驱动程序，满足了现场智能仪表的计算复杂性和系统通信的时实性。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。