查询词典 compressor-expandor

Experimental investigation on strongly separated flow in an annular compressor cascade ;2. The structures of separated flow, especially, vortices, inside an annular compressor cascade at large incidences have been studied baized on the flow visualization images obtained by means of Laser-sheet method and 7-hole probe measurement.

本文采用激光片光层加示踪粒子流场显示技术，观察和摄取了环形压气机叶栅在约十14大攻角下的内部流动图像；采用七孔气动探针测量了叶栅出口截面上的速度分布S通过对流场实验结果的分析，并结合本文第一部分中得到的叶片近壁区分离流结构，得到了该环形压气机叶棚中严重分离流场的分离流形态和旋涡结构。

Muffler is located after the exhaust port of the pump of rotary compressor to reduce air pulse, noise, and improve the performance of compressor.

旋转式压缩机消声器是设置在压缩机泵体排气口处的，其作用是降低气流脉动以降低噪声，改善压缩机性能。

Through the flue gas and air characteristic analysis in supercharged boiler,the results showed that the value of parameters would increase with the increase of fuel consumption.And volume heat load of the furnace, fuel consumption, heat change between flue gas and convective heating surface and evaporation value would increase with the increase of compression ratio.The heat calculation would be different because of dissimilar thermal calculation in the turbo-compressor when the boiler load was changed.As the boiler load increased,heat loss in the turbo-compressor would increase and the efficiency of the boiler would decrease.The results of the boiler start-up simulation showed that the time of start-up would decrease with the increase of flue consumption ,but instantaneous pressure amplitude would increase.Steam water"s dymamic diversification would be more complex than flue gas"s,and dynamic characters of their parameters would be changed due to different boiler load and disturbance variable,which was shown by results of the simulation when boiler load was changed.

通过分析增压锅炉内的空气、烟气参数特性，发现随着锅炉负荷的增加，空气和烟气的各项参数值都相应的增加；炉膛容积热负荷、锅炉的燃料负荷随着增压比的提高成比例增加；随着增压比的增大，烟气与对流受热面的换热增加，蒸发量随之增加；由于涡轮增压机组在不同负荷下的热力计算不同而造成增压锅炉在不同负荷下的热平衡计算的不同；锅炉增压机组的总的热损失随着锅炉负荷的增加而增加，而增压锅炉的热效率随着锅炉负荷的增加而减少；锅炉启动模拟仿真结果中发现，锅炉启动时燃料量增加，锅炉的启动时间就会减少，但是瞬时升压速度会增加；而动态负荷变化模拟仿真结果中发现，锅炉汽水侧的变化相比烟气侧更为复杂，且在不同负荷和不同扰动量下，烟气侧和汽水侧的重要参数动态特性是不同的。

Air compressor is the necessary equipment for many enterprises. Since the air compressor might run for long time under the full-load status, the motor capacity is determined according to the maximum need, and the designed surplus is usually a little higher.

空压机组是很多企业的必备设备，由于空压机不能排除在满负荷状态下长时间运行的可能性，所以只能按最大需要来决定电动机的容量，设计余量一般偏大。

Reforming unit: recycle hydrogen compressor, reforming hydrogen compressor, feedstock furnace, reboiling furnace of deheptane tower

重整单元：循环氢压缩机、重整氢增压机、重整进料加热炉、脱戊烷塔重沸炉

R12 on the ozone layer due to the destruction of the requirements of the developed countries for environmental protection from 1996 to start using refrigerant R134a Automotive Air-conditioning and the construction of air-conditioning at home in a similar, it is often installed in the compressor engine, and with a belt drive, the condenser installed in the car in front of the radiator, and evaporator in the car inside, and work out from the evaporator of low pressure gaseous refrigerant flows through a high-pressure high-temperature gas compressor After cooling condenser cooling tube cooling into the low-temperature high-pressure liquid, through the desiccant dryers and storage of buffer, and then to a more stable flow of pressure and flow expansion valve, the final expenditure and the flow of relief evaporator.

由于R12对大气臭氧层的破坏，出于环保的要求发达国家从1996年开始改用R134a做制冷剂汽车空调的构造和家用的分体空调类似，它的压缩机往往是安装在发动机上，并用皮带驱动，冷凝器安装在汽车散热器的前方，而蒸发器在车里面，工作时从蒸发器出来的低压气态致冷剂流经压缩机变成高压高温气体，经过冷凝器散热管降温冷却变成高压低温的液体，再经过贮液干燥器除湿与缓冲，然后以较稳定的压力和流量流向膨胀阀，经节流和降压最后流向蒸发器。

It is shown by the statistics that the sales volume of the screw compressor is already at above 80% of the sales volume of .the displacement compressor. In all the existing running power displacement compressors, the screw compressors are at 50%. Thus it has vast prospects in future.

统计数据表明，螺杆压缩机的销售量已占所有容积式压缩机销售量的80%以上，在所有正在运行的动力用容积式压缩机中，有50%是螺杆压缩机，因此市场前景广阔。

Through the introduction of the internal structure of sliding valve in screw rod compressor,the methods of dealing with the problems in controlling the energy level of compressor were indicated.

通过介绍螺杆压缩机的滑阀的内部结构，处理压缩机能级控制出现的问题。

The traditional rotary compressor for more than single-cylinder type, and later a two-cylinder compressor.

传统的旋转式压缩机多为单缸型，后来出现两缸的压缩机。

In order to study the thermodynamic process of the variable displacement swash plate compressor and analyze the factors affecting the performance of this kind of compressor, the thermodynamic model, the dynamic model and the finite element model of suction and discharge valves are developed.

为了了解变排量斜盘式压缩机的工作机理并分析影响变排量斜盘式压缩机性能的主要因素，本文建立了其热力工作过程的热力学及其动力学模型。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。