查询词典 compression

The radial plasma transport in the Saturn's magnetosphere is that the denser plasma becomes cooler because of adiabatic expansion in the process of outward transport while the injected lighter plasma becomes hotter due to the adiabatic compression.

密度大的等离子体在向外输运过程中会绝热膨胀而温度降低，密度小的等离子体则在注入磁层过程中因为绝热压缩而温度升高。

An engine cyclic variation model has been built by using the residual gas temperature for the n-th cycle as the input of the model, through constant pressure intake process, adiabatic compression process, constant volume combustion process, adiabatic expansion process, adiabatic blow down process and constant pressure exhaust process to approximate the thermodynamic processes in the cylinder, finally the residual gas temperature for the (n+1)-th cycle can be estimated.

基于循环间变动的排气温度建立了一个发动机循环变动模型。在这个模型中，第n个循环的排气温度作为模型的输入，通过定压进气过程、绝热压缩过程、定容燃烧过程、绝热膨胀过程、定容放热过程和定压排气过程来近似汽缸内的热力学过程，最后得出第n+1个循环的排气温度。

It is assumed that it is adiabatic compression during start-up process before the atmophere pressure in flow passage rise to relief pressure, the thermodynamic equation, momentum equation and rigid water hammer theroy have been applied for the analysis and calculation the variation law of air during this transient process.

假设流道内气体未达虹吸驼峰顶处真空破坏阀排气压力前的起动过渡过程处于绝热压缩状态，运用能量方程结合动量方程和刚性水击理论，计算分析出了流道中的气体压力在起动过渡过程中的变化规律。

In some delivery systems, NF3 may be subjected to adiabatic compression .

在一些传输系统里，NF3可能受到绝热压缩。

2Research of strength characteristic for high bending concreteWe researched the bending strength, compression stength and cleavage strength characteristics of different type, different design strength and different age HBSPC , and analyzed the relations of of the strength of different HBSPC,we also analysised the influence regulation for HBSPC strength by the the admix amount and feeding sequence.

2高抗折强度路面混凝土强度特性研究。研究不同类型、不同掺量和不同龄期HBSPC的抗折强度、抗压强度和劈裂强度特性，并分析HBSPC不同强度之间的关系。

The main factors affecting the soil-structure interface behaviors were found experimentally and theoretically, including: 1 the thickness of the interface that is five to six times the average grain size of the soil; 2 the aeolotropy of interface, which is responsible for anisotropic response of the stress-strain response of the interface; 3 two physical states, including crashing and compression of the soil near the structure surface, which govern the stress-strain response of the interface strongly; 4 two shear deformation components due to sliding and constraint of the structure surface relative to the soil respectively, which forms the deformation of the interface; 5 the volumetric strain due to dilatancy, which is found to be composed of a reversible dilatancy component and an irreversible dilatancy component. 4. A unified constitutive model of the interface, based on new elasto-plasticity damage theory, was developed. It was confirmed to be effective for the conditions considering monotonic and cyclic shearing, coupling effect of shear and volumetric strains, evolution of physical state, micro-structure aeolotropy of the soil and the resulting aeolotropy of the interface as well as the three normal boundary conditions stated above. 5. 2D and 3D finite element formulations of the present model were derived and incorporated into the FEM codes. They were applied to the evaluation of practical engineering problems with different typical interfaces between soil and structure. The new model was shown to be reasonable and effective.

确定了粗粒土与结构接触面厚度约为5～6倍的平均粒径，首次揭示了接触面的细观结构异向性以及由此所引起的宏观剪切异向性，发现了在单调和往返剪切荷载作用下土颗粒破碎和剪切压密两种物态变化机制共同支配着接触面力学性质的变化，通过细观分析证实了接触面的变形可分解为一般同时发生的土与结构交界面上的滑移变形以及结构面位移约束范围之内土体本身的剪切变形两部分，观测到接触面受剪时表现出明显的相对法向位移，并可分解为可逆性和不可逆性两个分量；(4)建立了第一个能够统一地描述单调与往返剪切特性、剪应变与体应变耦合特性、细观结构和宏观剪切异向性以及土颗粒破碎等物态变化特性的土与结构接触面弹塑性损伤本构数学模型，并采用多种法向边界条件复杂加载路径的试验成果验证了新模型的合理性和有效性；(5)提出了新模型的二、三维有限元格式并结合实际边值问题进行了应用计算分析，比较了不同接触面本构模型对计算结果的影响，证实了新模型及其有限元格式不仅能够合理地描述土与结构接触面的主要力学特性，还能够较好地反映土体与结构物在接触面处的滑移、脱开等不连续现象。

The compressor package includes a simple cooling water circuit to provide cooling for the compression process both intercooler and aftercooler, the high-speed motor and the inverter.

空压机内部冷却水系统提供中间冷却器后部冷却器变频器及高速马达等元件的散热冷却，亦包括冷却高速马达的气冷风扇。

During the compression, room between the compressor's rotor and cylinder reduces. Oil content in the compressed air will be lower than 2PPM after the compressed oil-air mixture goes through mechanical separation and filtering separation. Purified compressed air will cool down in aftercooler. Condensated water after the cool-down is drained out solenoid valve.

在压缩过程中，压缩机转子的滑片与气缸之间容积不断减少，压缩后的油气混合气3/4机械分离和过滤分离，使压缩空气中含油量低于2PPM.3/4净化后的压缩空气进入后冷却器中进行冷却，冷却后所形成的凝结水3/4由一排水电磁阀而排出。

An exhaust port (20) allows dried air out of the compression chamber.

一排气口（ 20 ）让干燥空气的压缩会议厅。

The term "airwave" comes from the fact that human speech, in its native form, is an acoustic means of communications which makes use of the physical matter in the air to conduct compression waves.

术语"airwave"来自人的话音，其本来的形式是一种声学通信方法，利用空气中的物理介质传输压缩波。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。