查询词典 composite

In this project, the selection criteria of matrix and reinforcement for obtaining composites with high strength and toughness are determined. The as-cast and aged microstructures of composites reinforced with particles of different strength are observed, and their metallurgical conditions and stabilization mechanisms are analyzed. The aging precipitation behaviors and mechanisms are studied. Some characteristics of nano-materials (micro-distortion areas) are found in 150nm- Al2O3p/Al composites and their formation mechanisms are expatiated. The "flexible" restriction to the deformation of the matrix by low strength AlN particle is observed by in-situ TEM and SEM techniques, and the mechanisms of its resist on cracks propagation and its contribution to composite strength are revealed. The high temperature deformation behaviors of Al2O3p/Al composites are studied. A rare-earth coating is established on sub-micron Al2O3 particles, leading to an improvement in wettability between coated Al2O3 and liquid aluminum and a decrease in infiltration pressure. The strength and ductility of coated particles reinforced composite are also increased. The interfacial characteristics, bonding structures and their formation mechanisms are studied, and the crystal orientation relationships between reinforcement particles and aluminum matrix are investigated. Finally a lighter composite with better balance of strength and damping properties is reinforced with hollow ceramic microballoons of ultra-lower strength.

本项目发现了获得高强度和高韧性复合材料的基体、增强体选择依据；观察了各种强度质点增强复合材料的铸态和时效态微观组织，分析其微观结构形成的金属学条件及稳定性机理，研究了其时效析出规律和时效机制，发现了150nmAl2O3颗粒增强铝基复合材料基体中的纳米材料特征，并解释了其形成机理；利用TEM和SEM动态拉伸技术发现了低强度质点AlN颗粒对变形协调的&柔性强化&机制，揭示了其对裂纹扩展的阻碍作用和对复合材料高强度的贡献；研究了中强度质点的Al2O3颗粒增强铝基复合材料的高温变形行为，并对其进行了稀土界面层设计与制备，改善了颗粒与铝合金之间的界面润湿性，降低了复合材料铸造渗透压力，提高了复合材料的强、韧性；研究了多种复合材料界面结构及形成机理，确定了增强体与基体之间的界面结合机制，分析了复合材料界面处的晶体学位向关系；最后制备了含微孔的中空型陶瓷颗粒增强的特种复合材料，得到了强度和阻尼综合性能较好的轻质复合材料。

This paper discussed two different Electroless nickel composite platings : Ni-P-SiC composite platings and Ni-P-PTFE composite platings.

本论文主要讨论了两种不同用途的化学复合镀层：Ni-P-SiC复合镀层与Ni-P-PTFE复合镀层。

In the production of various types of decorative panels, composite boards, transparent lighting board, wave board 2.6 million square meters, all kinds of FRP cable retaining tube 1600000 meters, all kinds of FRP process pipe, sand control, GWF Composite Pipe 2,600,000 meters, SMC molding FRP composite door 200,000 kg and all kinds of molded products, stainless steel water tanks FRP 10,000 cubic meters.

年生产各类装饰板、复合板、透明采光板、波形板260万平方米，各类FRP电缆护管160万米，各类FRP工艺管、夹砂管、GWF复合管260万米，SMC模压复合FRP门20万合及各类模压制品，不锈钢玻璃钢水箱10000立方米。

That is, plastic screw-plate-type copper composite material Slideway TS-70 series, screw-plate-type heavy-duty low-Mount Self-lubricating bearings lubrication and drop TS-100 series, screw-plate-type solid-liquid film lubrication Bearing GM series, in addition to have mosaic-type self-lubricating composite bearings XQZ and with independent intellectual property rights GY series, as well as a common three-tier composite material SF series, copper steel matrix composites TSG Series.

即钉板型铜塑复合材料滑道TS-70系列，钉板型重载低摩自润滑和滴油润滑轴承TS-100系列，钉板型固液油膜润滑轴瓦GM系列，此外还有镶嵌型自润滑复合轴承XQZ和具有自主知识产权的GY系列，以及通用的三层复合材料SF系列，铜塑钢基复合材料TSG系列。

A stupid rewriting will help: The composite is more resistant to corrosion than the steel it replaces;The composite is easier to clean ; and the composite floats (a verb too, intransitive though).

贸易模式的差异决定了中国向美国出口的货物比从美国进口的货物要多，所以在美国向中国运输货物的途中就会不可避免地出现空集装箱。

Electron microscope of the scheme of chart of X ray diffraction that analyses composite material, transmission and photograph of scanning electron microscope make clear: OMMT basically is with coming off condition disperses in PLA matrix, form in order to come off model give priority to, the accept rice that at the same time existence inserts a structure composite material, the affiliation of OMMT makes the drawing section of composite material ruptures to tenacity by brittleness change.

分析复合材料的X射线衍射谱图、透射电子显微镜和扫描电子显微镜照片表明：OMMT主要以剥离状态分散在PLA基体中，形成以剥离型为主、同时存在插层结构的纳米复合材料，OMMT的加入使复合材料的拉伸断面由脆性断裂向韧性断裂转变。

On the basics of briefly summarizing the research and application presents of building coatings and nano-composite building coatings in domestic and overseas, we presented a creative approach of modified exterior and interior building latex coatings applying inorganic nano-powders and its compound, systematically studied the effect of factors such as nano-material's category、additive capacity、dispersing method on the behavior of exterior building coating's weathering resistance、scratch resistance、water resistance、alkaline resistance and on the behavior of interior building coating's restraining bacterium、degrading all kinds of bad organic matter,and triumphantly developed nano-composite building latex coating.

本文在简要叙述国内外建筑涂料和纳米复合建筑涂料的应用研究现状的基础上，提出了使用无机纳米粉体及其复合材料改性建筑外墙乳胶漆的创新思路，系统地研究了纳米粉体材料的种类、添加量、分散方式等因素对外墙乳胶漆耐候性、耐洗刷性、耐水耐碱性等性能的影响，以及这些因素对内墙乳胶漆抗菌杀菌、降解有害有机物等性能的影响，成功地开发了纳米改性建筑外墙和内墙乳胶漆产品。

As the foundation of ultrasonic testing of composite materials, this thesis is intended to explore in detail a number of features of wave propagation in anisotropic plates, and the following essential problems will be considered:(1) Propagation of plane bulk waves in homogeneous and orthotropic anisotropic media;(2) Lamb wave propagation in multilayered anisotropic plates;(3) Influence of isotropic solid or liquid loading on Lamb wave propagation in anisotropic solid media;(4) Influence of interface layers on Lamb wave propagation in layered anisotropic composite laminates;(5) Dispersion characteristic analysis of attenuation Lamb wave while existing an thin viscous layer which is used for simulating the poor curing in adhesively bonded joints.

作为复合材料超声检测的基础，本文研究了如下国际前沿性的课题：（1）平面体波在正交均匀各向异性媒质中的传播；（2）多层各向异性媒质中Lamb波的传播；（3）各向同性固体或液体负载对各向异性固体媒质中Lamb波传播的影响；（4）界面层对层状各向异性复合媒质中Lamb波传播的影响；（5）胶粘剂未固化而呈现粘弹性时粘接结构中衰减Lamb波的频散特性分析。

The thermal residual stress is a type of short-rang internal stress between matrix and whisker in composite. It was verified that the thermal residual stress could not be released and could not cause the macro-strain, although the diffraction angle of matrix was shifted in composite.

复合材料中热残余应力是基体与晶须之间的短程内应力，试验证实热残余应力虽可引起基体衍射峰位移动，但不会造成复合材料宏观应变而自然释放。

Based on the laminate theory, a laminate weakened by damage is treated as an anisotropic thin plate. Using the complex potential method in the plane theory of elasticity of an anisotropic body, the series solution of finite anisotropic thin plate containing an elliptical inclusion is proposed with the help of Faber series. A hybrid element with an elliptical inclusion for anisotropic materials is obtained by using the hybrid variable principle, and the element efficiency is verified by numerical examples. The state of the damage is modeled by an elliptical soft inclusion, and using the point stress criterion based on characteristic curve and Yamada-Sun etc. criteria, the prediction of the strength of a composite laminate with damage is set up. The effects of various parameters on the stress distribution and the residual strength of a composite laminate weakened by damage are detailedly studied.

首先基于经典层板理论，将复合材料层板的弹性问题化归为均匀各向异性板来求解；采用各向异性体平面弹性理论中的复势方法，以Faber级数为工具，给出了有限大含椭圆核各向异性板弹性问题的级数解形式；利用杂交变分原理，成功导出含椭圆核各向异性板杂交应力有限元，并用算例验证了该单元的可行性和有效性；采用含刚度折减椭圆形弹性核的冲击损伤模型，引入基于特征曲线和Yamada-Sun破坏准则的点应力判据，建立了含损伤复合材料层板剩余强度的分析方法；通过数值计算详细讨论了各种几何参数对损伤层板应力分布、剩余强度的影响，得到了一系列对工程应用具有实用价值的结论。

Salt is good, but if the salt becomes flat and tasteless, with what do you season it?

14：33 盐本是好的，盐若失了味，可用什么叫它再咸呢？

He reiterated that the PLA is an army of the people under the leadership of the Communist Party of China.

他重申，人民解放军是在中国共产党领导下的人民军队。