查询词典 composite

The results show that the composite coating is metallurgically bonded to the substrate and the microstructure is fine and uniform. The hardness of the composite coating is up to 400 HV, which is 2.5 times that of the substrate. Under room temperature and oil lubrication condition, the sliding wear tests indicate the friction coefficient and weight loss of the composite coating are smaller than those of substrate. The worn surface of the composite coatings is much smoother than that of the substrate, without grooves and crater.

结果表明，复合材料涂层与基体形成良好的冶金结合，微观组织细小、均匀；复合材料涂层硬度达400HV，约为基体的2.5倍；在室温油润滑条件下，滑动磨损试验表明复合材料涂层摩擦系数和失重均小于基体，磨损表面划痕较浅且平滑，无明显的犁沟、粘着、剥落现象；激光表面合金化显著提高了材料的耐磨性。

Study the bioactivity of the n-HA/PA66 composite and the effects it would be to body's metabolism of calcium and phosphorus ion in vivo.(3) Study the osteo-conductivity and the ability to repair bone defect of the porous n-HA/PA66 composite and the feasibility use it as the scaffold of bone tissue engineering. Objects and Methods as follows: 1.To evaluate the biocompatability of nano-hydroxyapatite crystals and polyamide composite (n-HA/PA66) with the L929 cells.To proceed the morphological observation and take pictures of L929 cells after 1d,2d,4d,and 7d of co-cultured with extract of n-HA/PA66 ,and direct contact with n-HA/PA66.To determine light absorbtion value of every hole under 500 nm with enzyme linked immunity instrument after 1 d,2 d,4 d,and 7 d of contact of n-HA/PA66 extract with L929 cells,and direct contact with n-HA/PA66.In the meanwhile calculate the relative multiplication rate of cells,and evaluate them by six degree tests for cytotoxicity. To investigate the acute and chronic toxic reaction on the whole body induced by the new nano-hydroapatite crystals and polyamide composite(n-HA/PA66)after implanting in vivo and its effects on partial constitution of animal organs after implanting in vivo,and evaluate the potential and degree of subcuticular stimulation reaction.

本实验主要由以下三部分组成：一、n-HA/PA66 复合材料在动物体内、体外的生物相容性及生物安全性评价二、n-HA/PA66 复合材料植入动物体内的生物活性及近期对机体钙、磷代谢影响的实验研究三、网孔 n-HA/PA66 复合材料作为支架修复兔桡骨节段缺损的动物实验研究主要研究目标及方法如下：参照 GB/T16886.5-1997-ISO 10993-5：1992《医疗器械生物学评价细胞毒性试验体外法》之评价标准和要求，采用规定的 L929 细胞(小鼠结缔组织成纤维细胞)，分别经直接接触和材料浸提液与细胞共培养等方式对 n-HA/PA66 复合材料进行细胞毒性测试，采用细胞形态观察法观察两种细胞各组在 24h、48h、72h、5 天后各时相点的细胞形态学变化，并在显微镜下照相，从而对细胞与材料的生物相容性进行定性评价；同时采用细胞生长抑制法，以酶标仪定量测定评价各组 1，2，4，7 天 L929 细胞的相对增殖率，以定量测定并判别材料对细胞的毒性程度。

Then on the basis of comparative analysis on Central Composite Design which including Central Composite Circumscribed design,Central Composite Inscribed design and Central Composite Face-centered design in RSM, the paper proposes methods concerning how to choose experiment design of combined array.

本文针对RSM的中心复合设计——外切中心复合设计、嵌套中心复合设计和面心立方设计进行了比较评价，并给出了结合表实验设计的选择方法。

EPE series: ordinary EPE, rehabilitation PO BAG EPE film anti-static, non-wax EPE, EPE Turpin, EPE encryption, encryption hardware add EPE, anti-static EPE, rehabilitation PO membrane Antistatic EPE, PO EPE laminating, PE EPE¤the one hand, PO composite aluminum composite film side of EPE, single / double-sided foil EPE review the one hand, while aluminum complex rehabilitation EPE color film, one side of complex aluminum complex of textile fabrics EPE, EPE composite of different materials, plating color film laminate EPE, EPE composite of various special materials, PS board, pearl board, KT board, advertisement board, fire EPE, EPE bridge, all kinds of special EPE Products.

珍珠棉全系列：普通珍珠棉、复PO膜防静电珍珠棉袋、无蜡珍珠棉、特平珍珠棉、加密珍珠棉、加密加硬珍珠棉、防静电珍珠棉、复PO膜防静电珍珠棉、PO复膜珍珠棉、PE淋膜珍珠棉、一面复合PO膜一面复合铝膜珍珠棉、单/双面覆铝箔珍珠棉、一面复铝膜一面复彩膜珍珠棉、一面复铝膜一面复纺织布珍珠棉、复合不同材料珍珠棉、镀彩膜贴合珍珠棉、复合各种特殊材料珍珠棉、PS板、珍珠板、KT板、广告板、防火珍珠棉、珍珠棉架桥、各种特殊珍珠棉产品。

A new method was developed for design of the composite material flywheel with high speed. In this paper ,the method of optimization of shape design for the composite material flywheel with high speed was put forward on the base of the analytical method and research optimization of shape design, and established the models of density optimization of energy and light mass.These models were used to design two typical composite flywheels with high speed in hybrid electrical vehicle flywheel battery and the stress level and convergence on the flywheel were got .Then a new way was developed for optimization of shape design of the composite material flywheel with high speed.

在此基础上对高速复合材料飞轮进行了形状优化设计，将复合材料有限元分析方法和优化设计技术相结合，提出了复合材料的形状优化的方法，分别建立了以高速复合材料飞轮的以储能密度最大为目标函数的形状优化模型和以质量最轻为设计目标的形状优化模型，并以混合动力客车飞轮电池中高速复合材料飞轮作为具体应用，使其在满足强度条件和几何约束条件下，分别寻求其最大储能密度和最轻质量，从而为高速复合材料飞轮的形状优化设计提供参考依据。

In the second part of this thesis. The biological process of porons HA/bBMP composite repairing experimental defect in the dog femora and monkey mandibular were investigated by the qualitative and quantitative methods. The results showed that not only were the speed and time of new bone ingrowing into the bBMP/HA composite much quicker and earlier than that of implants of HA alone, but also the quantity of new bone ingrowth into bBMP/HA composite was much higher than that of HA alone. The bone ingrowth of bBMP/HA composite at higher rate within 3 weeks. In this study, bBMP/HA promoted more active new bone formation in bone marrow tissue than did HA alone. This reveals that BMP, brought into the bone marrow with HA as a carrier, accelerates osteogenesis or osteoinduction, providing sime bone marrow cells with more differentiative potential.

论文第二部分应用定性和定量的方法，较全面地研究了HA/bBMP复合人工骨在修复狗股骨和猴下颌骨实验性缺损中的生物学过程，研究发现，新骨组织长入HA/bBMP复合人工骨的时间和速度都较单纯HA早和快，而且新骨形成量也明显高于单纯HA，HA/bBMP在挂入后早期(3周)的成骨最为活跃，自体骨髓组织可为BMP提供敏感的靶细胞，增强BMP的骨诱导效果和HA/bBMP复合人工骨的骨修复能力。

objective: to prepare the molecularly imprinted composite membranes with propofol as template.methods: with the ultraviolet light and initiator, template molecular propofol, functional monomer methacrylate and crosslinking agent ethylenegly-coldimethacrylate formed molecularly imprinted composite membrane through polymerization on the surface of polyvinyli-dene fluoride microporous membrane.inspection of the combination of template molecule and functional monomer, characterization of the membrane surface morphology with scanning electron microscopy.results: the morphology of composite membranes was well.propofol bonded to methylacrylic acid with hydrogen bond.conclusion: the method of ultraviolet light-struck is feasible for preparation of molecularly imprinted composite membranes with propofol as template.

目的：制备异丙酚分子印迹复合膜。方法：在紫外光照和引发剂的作用下，模板分子异丙酚、功能单体甲基丙烯酸和交联剂乙二醇二甲基丙烯酸酯在聚偏氟乙烯微孔滤膜表面聚合形成分子印迹复合膜，考察模板分子和功能单体的结合特性，用扫描电镜表征膜的表面形态。结果：复合膜形态良好，异丙酚和甲基丙烯酸以氢键的方式缔合。结论：用紫外光照射法可以制得异丙酚分子印迹复合膜。

The result which was gained through experiments shows that the transverse tensile brute force of short-fiber non-woven fabric composite is higher than that of long-fiber non-woven fabric composite, but the transverse tearing brute force is lower than that of long-fiber non-woven fabric composite when the thickness of two kind of non-woven fabric composite are the same.

经实验发现，同种厚度短纤非织造布基布的横向拉伸性能优于长纤的，横向撕裂强力次于长纤的。聚酯非织造布基布的横向拉伸强力优于聚酯和尼龙混纤非织造布基布的，而横向撕裂强力两者均较差。确定热敏凝胶体系并研究其对基布横向力学性能的影响。

Our company mainly produces PVC series rigid sheets (Christmas tree leaves, medicine packing sheets, food packing sheets, industrial blister packing sheets), PVC series composite sheetsPVC/PVDC composite sheets, PVC/PE composite sheet, PVC/PE/PVDC composite sheet, etc.

主要生产PVC系列硬片（圣诞树叶片、药品包装片、食品包装片、工业包装吸塑折合片等）、PVC系列复合片（PVC/PVDC复合片、PVC/PE复合片、PVC/PE/PVDC复合片等）、PVC粒料和聚四氟乙烯制品系列产品，产品畅销全国，并出口香港、东南亚、欧美、日本等国家和地区。

The differences of the micro structure and properities of the bulk sinters, between the fabrication methed of powder metallurgy and reactive synthesis for silver tin oxide composite, are studied in prensent thesis. With the increase of the tin oxide content in silver matix, the electric conductivity of the composite tended to decreace. While in the same tin oxide content, the electric conductivty of the composite fabricated by reactive synthesisis better than that by powder metallurgy. One of the reasons is that the regular net structure existing in former composite.

研究了两种方法即粉末冶金法和反应合成法制备的银氧化锡复合材料烧结坯在组织上的区别和性能上的差异，两种方法制备的银氧化锡复合材料，随着氧化锡含量的升高，材料导电性均呈下降趋势，而相同成分的材料，反应合成法制备的银氧化锡复合材料的烧结坯的导电性要优于粉末冶金法，有规则的网络状组织结构是反应合成法制备的烧结坯导电性好的原因之一。

Objective:To explore the feasibility of laparoscopy in diagnosing and treating of abdominal diseases.

目的：探讨腹腔镜用以诊断腹部外科疾病及选择治疗方案的可行性。

The lifetime of nylon 1010 and nylon 1010/POSS composites decreased with increasing temperature.

热重-红外联用分析表明尼龙1010在氮气气氛下的降解产物主要为小分子的低聚物，POSS并不改变尼龙1010降解产物的组成。