查询词典 composite analysis

Plate and λ/2 plate were placed inside the Nd∶YVO4KTP green laser cavity with angle 90°between their fast axis.The composite plate composed of HWP,QWP and KTP has the function of QWP.The composite plate with Nd∶YVO4 can effectively suppress the coupling of polarized modes,and multi-longitudinal-mode lownoise green laser was obtained.Since the composite plate counteracted the phase shift induced by temperature sensitivity of quartz plate,the green laser operated with lownoise reliability in different output power and different operation temperature.The threelongitudinalmode, the noise of less than 0.5% and output power stability of less then 1% for 12 hour are obtained in the green laser.

介绍了一种LD泵浦腔内倍频全固体Nd∶YVO4KTP多纵模、低噪音、高功率稳定绿激光器在Nd∶YVO4KTP绿激光器组成的谐振腔内放置厚度约相等的石英晶体λ2波片和λ4波片，使两波片快轴夹角互呈90°，HWP、QWP与KTP构成复合波片，其作用相当于QWP，此复合波法与各相异性Nd∶YVO4共同作用有效抑制了腔内偏振模耦合，获得多纵模低噪音绿光输出此复合波片相互作用由于抵消了石英晶体波片温度敏感引起的相位延迟量漂移，所以此激光器在不同功率、不同工作温度下，均能稳定可靠地运转于低噪音状态实验结果为，绿光输出纵模数为3个，噪音小于0.5%，12 h功率稳定性优小于1

This thesis presents the stress,strain and failure researches on filament-wound composite engine shell of rocket bomb used by Solo Soldier Shoulder-launchered Weapon under the transient loads through studing the Composite Materials Mechanics and Composite Materials Structure Mechanics.

本文针对单兵筒式武器用火箭弹纤维缠绕复合材料发动机壳体，结合纤维缠绕复合材料力学与复合材料结构力学的理论对发动机壳体在瞬态载荷作用下的应力、变形、失效进行了初步的理论研究。

The differences of properties between components of composite yarns and the difference of structures between composite yarns and convitional two-ply yarns significantly affect the composite yarn properties and their fabric properties.

复合纱线中组分性能的差异性及结构与传统短纤维合股线的差异对复合纱线与织物的性能产生极大的影响。

It is studied to microcosmic mechanism of Fe/Zn composite plastic consume energy, that macroscopical antiseismic capability of Fe/Zn composite is response of microcosmic mechanism of Fe/Zn composite plastic consume energy is further proved.

研究了Fe/Zn复合材料塑性耗能的微观机理，进一步证明了Fe/Zn复合材料的宏观抗震性能是微观塑性耗能的反应。

Dehydration process based on hollow fiber composite membrane is one of the crucial and effective methods to remove water vapor from industrial gases such as light hydrocarbon, compressed air, natural gas and so on. Dehydration of propylene with VP method was studied in the thesis. We prepared the PVA/PS、CS/PS and PVA-CS/PS hollow fiber composite membranes by spread method. The permeation behavior of water vapor among coagulable light hydrocarbons through composite membranes and asymmetric membrane was researched by vapor permeation method. Also a differential mathematical model was established which can describe dehydration of gas phase propylene.

本论文以采用蒸气渗透法脱除丙烯中微量水分为目标，制备了 PVA/PS、 CS/PS、PVA-CS/PS 中空纤维复合膜；研究了可凝性轻烃蒸气中的微量水分在复合膜、非对称膜中的渗透行为，建立了描述丙烯气相脱水的数学模型，并进行了模拟计算；深入探讨了水蒸气在交联 PVA 致密膜中的渗透机理。

The composite powders consisted of Si, Ni, Ag and a series of Si-Ni alloys. The SEM and TEM results showed that the composite powder consisted of clusters with space and network structures. The composite electrode exhibited higher reversible capacity and the initial columbic efficiency was up to 87 %, which was much higher than that of the pure Si electrode.

XRD结果表明，复合材料中含有Si、Ni、Ag以及一系列Si-Ni合金相；SEM及TEM结果表明，复合材料呈现网格状的团簇结构，而且有一定的层状厚度；电化学测试显示，该材料电极具有较高的首次嵌/脱锂容量，首次效率达87%，较纯硅粉电极有了很大的提高。

And TM was carefully added to the solution of photo-PAE to form a PSPI solution containing TM. The composite filmcast from PSPI-TM can be developed using NMP. When the content of Ti〓 incomposite film was beyond 3%, a heateddeveloper had to be used for the successful development of the composite film.Compared with corresponding ester-type PSPI, D〓 of PSPI-TM increasedrapidly with the content of TM in the composite.

光刻实验发现这种含TM的PSPI光刻胶膜比相应的酯型PSPI光刻胶膜难显影，一般需NMP这样的强溶解性能的溶剂作为显影液，才能顺利显影，当Ti〓含量大于3％(基于酰亚胺化后PI的量)，必须升高温度才能顺利显影；这种含 Ti的PSPI光刻胶在感光性能上也比相应的酯型PSPI光刻胶低很多倍，形成50％留膜率所需的曝光剂量随TM含量的增加，而大幅度地增加。

He TiC could reprecipitate again with excess milling and Cu crystal decreasing. TiC-dispersion-strengthened Cu-based composite powders have been prepared from TiC-Cu and Cu-Ti-C mixed powders by MA. The composite powders were prepared into composite materials by pressing, sintering and heat-extrusion.

IC混合粉末经机械球磨后，再经压制、烧结和热挤压制备成 n 弥散强化铜基复合材料。

The composite amino acids of pupa protein was prepared by the method of enzymatic-acid hydrolysis. N-stearyl composite amino acids is synthesized by the synthesis reaction of stearyl chloride reacting with composite amino acids.

以蚕蛹为原料，采用酶－酸两步水解法制备混合氨基酸液，再与硬脂酰氯反应合成N-硬脂酰基复合氨基酸表面活性剂。

The blade according to claim 13, further comprising a blade rooting part including at least one blade attachment bar which is elongate, composite, and twistable about a longitudinal axis, and extends outside the shell by passing through the blade root, the at least one composite bar of the at least one spar having a longitudinal axis substantially parallel to the longitudinal axis of the blade, the end of the at least one attachment bar, on the side opposite the shell, being arranged in linkage attachment to the rotor hub, the at least one attachment bar of the rooting part being integral with the at least one composite bar of the at least one spar and comprising reinforcing fibres agglomerated by the thermoplastic resin.

刀片根据索赔13 ，进一步组成的刀片生根的一部分，其中包括至少一个刀片实习大律师公会是伸长，复合材料，和twistable约一长轴，并扩大外壳，通过叶根，至少有一个综合酒吧的至少有一个SPAR公司有一个长轴大致平行的纵向轴的刀片，结束对至少有一个实习酒吧，就一侧对面的壳，现正安排在联系实习，以转子枢纽的地位，在至少有一名实习律师生根的一部分，正在积分与至少有一个综合的酒吧至少有一个SPAR公司组成的加强纤维烧结由热塑性树脂。

Objective:To explore the feasibility of laparoscopy in diagnosing and treating of abdominal diseases.

目的：探讨腹腔镜用以诊断腹部外科疾病及选择治疗方案的可行性。

The lifetime of nylon 1010 and nylon 1010/POSS composites decreased with increasing temperature.

热重-红外联用分析表明尼龙1010在氮气气氛下的降解产物主要为小分子的低聚物，POSS并不改变尼龙1010降解产物的组成。