查询词典 composite analysis

The probability analysis method of the bearing capacity of composite pile foundation is investigated, which can push the developing of the reliability method of composite pile foundation.

研究了复合桩基承载力可靠性分析的方法，这对复合桩基的可靠性设计将起到积极的推动作用。

The results show that space finite analysis results are close to test ones, bottom chords suffer axial force and large in-plane bending, and the max stress is nearby each middle internode. The max stress of node crossbeams occurs in No.2 bottom flange, and that of internode crossbeams happens in ones lying in the middle of every internode. The concrete slab is in tension at the longitudinal direction, and also suffers bent at vertical loads. The degree of completely-composite model taking part in the combined actions is about 55%, while that of semi-composite model is 42%-43%. The combination of concrete slab and bottom chord increases the degree of floor system taking part in the combined actions, lightens the burden of bottom chord, and reduces out-of-plane bending of node crossbeams especially the ones near bridgehead. Stress and displacement of main truss can be evaluated by a equivalent plane rigid frame in preliminary design, and effective stiffness of bottom chords are composed of original ones and concrete slab, and the concentrated load from deck can be translated into uniform load.

研究结果表明：空间有限元分析结果与试验结果较吻合；下弦杆受到轴向拉力和较大的面内弯矩作用，各节间最大应力出现在节间中点附近；节点横梁最大应力发生在横梁2的下翼缘，节间横梁最大应力发生在位于端节间中部的小横梁上；混凝土板顺桥向整体受拉，并在竖向集中荷载作用下产生弯曲变形；全结合模型大部分节间内的桥面板参与主桁共同作用的程度为55%左右，半结合模型桥面板的参与程度为42%~43%；桥面板与下弦杆结合能够增加桥面板的参与程度，减轻下弦杆荷载，减少节点横梁尤其是靠近桥头横梁的面外弯曲；对桥梁进行初步设计时，主桁杆件的位移与内力可按照1个等效的平面刚架计算，下弦杆的等效刚度由原下弦杆截面和混凝土桥面板截面组合而成，桥面荷载可转化为均布荷载施加。

The research result provided the effective calculational model and numerical method for the design and analysis of composite flywheels. And it offered the valuable reference to similar rotor structures and composite structures.

本文的研究成果为复合材料飞轮的设计与分析提供了有效的计算模型和数值计算手段，同时为类似的复合材料结构件转子的研制与开发提供了有价值的参考。

Kempers' study , the more layers the mesh screen type had, its resistance against gravity was higher, but its heat resistance and flow resistance were comparatively augmented. As mentioned in the preceding paragraph, it is extremely difficult for a single micro structure based on any of the three types to possess both low flow resistance and strong capillary force. Faced with this fact, the researchers have tried to mix the three micro structures in Table 2 into as many combinations as possible so that a composite micro structure with low flow resistance and great capillary force may be fabricated. After a thorough analysis, the groove combined with sintered metal or mesh screen has been found to be a better alternative. However, the groove combined with sintered metal will raise the flow resistance of the channel, and the aluminum substrate employed in this research cannot be sintered into a micro structure. As a result, the groove combined with mesh screen is finally chosen as the composite structure to enhance its capillary force and at the same time maintain its high permeability. In this way, the heat pipe will not fail due to the working angles.

Kempers 的研究当中提到，当网格结构越多层时，其对抗重力的能力也越强，但相对的其热阻以及流阻也越高，就如同前段所述，我们很难在单一结构当中找出一流阻低且毛细力之微结构；因此本研究便以表2中之三种微结构进行组合，找出一低流阻且毛细力强之复合式结构，经分析发现，沟槽搭配烧结以及沟槽搭配网格为较佳之组合方式，但由于烧结搭沟槽构造将会提高流道之流阻，且本研究使用铝做为基材，并无法使用烧结最为其微结构，故将采用网格搭配沟槽之复合式结构提高结构的毛细力，并维持沟槽结构的高渗透性，解决因角度造成热管失效的问题。

From the wide verification and detailed analysis, such as a great amount of tests for single pile and two tests for composite pile foundation, a field measurement study lasted for more than 4 years for two same buildings designed by new design method presented in this paper, and a long term survey of settlement for 28 buildings found on composite pile foundation, it has been shown that this new design method is feasible and reasonable.

通过大量的单桩静载试验、复合桩基静载试验、对按提出的复合桩基方法设计的两幢体型、面积和层数相同的房屋的长期监测试验以及大量的建筑物的长期沉降观测，进行检验和深入而详细的分析。

Parts of the Process Analysis、Process improvements、Die with a complete composite blanking process Piercing 、Expounded washers composite Die Blanking the overall structure and characteristics of the process, Should pay attention to the issue of sexual and assembly process ,Piercing the settlement sheet、 And seam compound die punch slender easily broken、Hole coaxial hard to ensure the short life and die of technical problems.

通过对零件的工艺分析，改进了工艺方案，用一套复合模完成落料冲孔工序，阐述了垫圈冲裁复合模具的整体结构特点及工作过程，应注意的问题和装配工艺性。解决了薄板冲孔、冲缝复合模的凸模细长易断、孔的同轴度难以保证以及模具使用寿命短的技术问题。改进了落料、冲孔、冲缝的制作工艺，设计了一套新型复合冲裁模，提高了工件的同轴度精度，延长了模具的使用寿命。

Theory analysis of composite subgrade has got behind practice engineering of it in recent years. In correlation code, design and construction of composite subgrade have actual being unsureness for complex of geotechnical conditions.

目前，复合地基的理论研究远远落后于复合地基的工程实践，而我国关于复合地基的相关规范由于岩土材料性质的复杂性和变异性，岩土工程边界条件的不确定性等众多影响因素，使得复合地基的设计和施工留有很大的选择和发挥空间，因此，如何提高复合地基的设计计算精度，满足建筑工程对可靠性、安全性及经济性的要求，是岩土工程人员的当务之急，也是复合地基工程的研究目标和方向。

Composite function is one of the important objects of mathematical analysis research,and some of it's analysis natures such as monotony, boundedness, limit,continuity, derivability,integrability are important content in the mathematical analysis,they are also important tool to study other objects in mathematics.

复合函数是数学分析研究的重要对象之一，它的一些分析性质（如单调性，有界性，极限，连续性，可导，可积性）是数学分析中的重要内容，也是研究数学中其它对象的重要工具。

I cite the ANN methods of the financial risk assessment and the corporate finance composite indicator model of the financial risk assessment, and use the statistics analysis methods, the correlation analysis methods and the factors analysis methods.

本文还通过对企业财务风险类别进行细分，提出了对于不同类型的财务风险采取有针对性的对其相关因素进行分析的方法。

Main Curriculums: Higher Mathematics, Engineering Mathematics, College Physics, English, Descriptive Geometry and Building Cartography, Program Design and Arithmetic, Introduction to Java, Network Database, Numerical Analysis, Tensor Analysis, Specialty English, Document Retrieval and Utilization, Introduction to Mechanics, Theoretical Mechanics,Mechanics of Materials,Structural Mechanics,Computational Mechanics and Engineering Software, Theory of Plate and Shell, Theory of Elasticity, Composite Mechanics, Advanced Structural Mechanics,Plastic Mechanics of Structural Engineering, Fluid Mechanics, Experimental Mechanics, Vibration Theory, Soil Mechanics and Foundation, Steel Structures, Concrete Structures, Engineering Construction and Engineering Estimate, Engineering Signal Analysis and Processing, CAD of Structure, Design of Structural Optimization, Modern Testing Technologies.

专业课：高等数学、工程数学、普通物理、英语、政治、画法几何及建筑制图、程序设计与算法语言、Java基础、网络数据库、数值分析、张量分析、专业英语、科技文献检索、力学概论、理论力学、材料力学、结构力学、计算力学与工程软件、板壳理论、弹性力学、复合材料力学、高等结构力学、结构工程塑性力学、流体力学、实验力学、振动理论、土力学与地基基础、钢结构、混凝土结构、工程施工与概预算、工程信号分析与处理、结构CAD、结构优化设计、现代测试技术等。

Putt your way through 36 fun-filled holes of minigolf on 3D designed courses with elevated greens, bunkers, bridges and water hazards, among other crazy obstacles.

您的推杆方式，通过36个有趣的填孔迷你的三维设计的课程，以提升绿党，掩体，桥梁和水的危害，除其他疯狂的障碍。

Some participles can be used either as attributes or as predicatives.

有些分词既可当定语用，也可当表语用。